Having problems with your Kenmore Vacuums ?

Vacume overheats and shuts down I replaced the motor.When it cools down it runs again.


Answers :

The filters had to be cleaned out with air.
I replaced the motor for nothing.There are two filters and the cannister give them good cleanings with an air gun.
Repair Help & Product Troubleshooting for Kenmore Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vacume overheats and shuts down I replaced the motor.When it cools down it runs again.


The filters had to be cleaned out with air. I replaced the motor for nothing.There are two filters and the cannister give them good cleanings with an air gun. ... Kenmore Vacuums

My hoover vacuum runs for about 10-15 minutes then the saftey feature shuts it off(overheat?). i have taking it apart a cleaned it with no results, added new bag also. after an hour it cools down and works again. do i just need a new vacuum?


Do you have suction through the tools? Does it look like it picks up when it runs? The machine could be clogged and that would cause the problem, but unfortunately the sensor that shuts the machine off could be bad if the machine isnt clogged. Its no ... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

Shuts off frequently The sweeper will run for a few minutes and when it starts to get warm it shuts off. If you allow it to cool off it will turn on again and run until it gets warm


Check any filters to see if they are clogged up with dust because its overheating the motor causing the thermal switch to trip. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

When I sart to run my bagless vacuum, it runs for a second and then shuts off. I replaced the belt and the filter. The repairman told me that on bagless vaccuums, the motor and bearings get clogged w


Take the brush roller off and on the ends are the bearing caps.try to take those off and clean the bearings ,carpet strands and hair will cause that.after you do that make sure the roller turns freely if not then the bearings might be bad and if that ... Vacuums

Vacume Overheating My vacum is overheating and then shuts down for awhile but doesn't start again untill the vacum has cooled down.. Are there any heat-relays or something like that that could cause the problem ?


There will be a filter between the cylinder/bag and the engine. If your vacuum has a HEPA filter there will be one on the other side of the engine. Remove both of these and clean them out with water, allow to dry and replace. ... AEG Vacuums

I have the same problem as steve967 The dyson dc16 is fully charged, runs well for 5-10 seconds and shuts down. I wait for a second or 2 and it runs again for 5-10 seconds. This will continue for numerous cycles, until I am finished cleaning. I have cleaned all the filters, and the power is good, The system will just not stay on. It is just over 2 years old. A friend of mine had the same problem with his Dyson DC16 after just a couple of months and has replaced his Dyson with a Black N De


Dear Michael_Stad,I am going to sound like a broken record but here is my same answer to another person with the same problem.I have I had the same problem with my Dyson DC16, where it only runs for a few\015\012seconds at a t ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

The vacum will run until the hose is inserted and then the motor shuts off. The vacum switch must be hooked up incorrectly. Do you have a schematic?


Before trying to take it apart, check the hose for a blockage. Disconnect the hose at both ends, drop a coin in one end, lift that end of hose allowing coin to drop through. If it doesn't come through, there's a clog. You should be able to clear i ... Electrolux C101 Bagged Canister Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

Machine running hot. new bag but red flag indicator is fully closed at stsrt up. Runs but overheats and shuts off and red reset light comes on


You may have a blockage in either the hose, the telescopic wand or the power nozzle/floor attachment. The easiest way to tell, as you have a new bag in there is to disconnect the hose and start the machine. If the suction is good there, start to narr ... Miele S548 Bagged Canister Vacuum

My powerhead on my EXL Tri-Star goes on then shuts off. When youturn it upside downit runs, then back on the floor it stops. Is it the belt inside the powerhead and if so to I take the head apart and replace this belt. Can any vacuum repair place fix this if I have the part. Vacuum was purchased in March 2000 Thank you, Dianne Miller [email protected]


A vac shop is probably going to require you to use their parts for warranty purposes. but its pretty simple. most shops should be capable to do it. ... Vacuums

My hoover, self propelled windtunnel ,on off switch will not shutoff. the second the electrical plug is put in the wall socket, the vacum starts running and you cannot shut it down with the on off switch


... Hoover Vacuums

Eureka 4467AV overheats and shuts down after about 3 or 4 minutes of operation. I pulled all the filters to assure no blocked air flow. I assume the motor is not getting enough cooling air but i can't figure out why. checked bag for blockages as well as hoses. could the thermal protection have gone bad?


... Eureka 4467AV Upright Vacuum

Magic chef model #MCWC45A Serial # 0902mcwc45a09720. It is a bit over a year old. it just went dead. no compressor sound.No interior light. Unplugged it, and after a day plugged it back the the compressor started running. it ran for about an hr the it shut off. the cooler was cool inside. i noticed the compressor was hot to touch.


Hi, It sounds like the compressor is going bad, but you can try to change the start components and overload to make sure they aren't at fault......Check out these tips that I wrote about that... it is a great place to starttro ... Vacuums

I can't get the vacume to run for more than 15 minutes before it shuts down presumably do to overload. But I don't get the warning light and I clean it out regularly. I have to let it sit for hours until it resets and I can finish the job


Sounds like you have a blockage. Check your attachment hose by dropping something through it, if it is all clear, then check your duct hose, this is the hose at the base of the cleaner. Many times this will clog and you might have suctionat your ho ... Vacuums

Hoover Spirit canister vac seems to overheat in about 10-15 minutes and shuts down until it cools off.


... Vacuums

Vacume is a mach 4 cyclonic, it runs for about 8 minutes and then it shuts itself off? any idea?


The only thing I can think of from your additional comments is when it warms up something expands and it loses continuity of the circuit. Most likely the switch or the breaker. Another thing to check is if it has a hepa filter it may be clogged ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

My hoover mach 6 bagless overheats, shuts off for about an 1 hr will run again, all filters are clean, no blocks in hoses, how can i fix this problem


This is telling you that there is poor air flow or a blockage somewhere. To simply check for proper suction, remove the accessory hose to see if there is normal suction, if not then your problem is further in the unit. Troubleshooting from there will ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

I have an Electrolux LE canister. It runs for about 2minutes then shuts off for about a minute , then turns on again and it keeps repeating this routine!!! It is driving me nuts. What part do I need to replace? Apparently it is over heating. Please help. Thank you.


The LE has a thermal cutoff. If the bag is overfilled or a bag breaks and clogs the bag chamber the vac will over heat. This also happens if the hose, wand or neck of the power head is obstructed. Try dropping a coin through the hose, look thro ... Vacuums

I have a Simplicity model 6970 upright vacuum. It picks up great and there is no smell but it will over heat in about ten minutes and shut down. There are no clogs. Once cool, I hit the thermal reset on the back at it works great again until it overheats again.


It could be electrical on the inside of the vaccum or your belt is the wrong size therefore making it over heat. Hope this helps?!Please rate and comment - Thank You ... Vacuums

Nutone central vacuum shuts off after a few minutes running then will restart after motor cools down I cheked motor and vent ports blown out all clean


Sounds like you have an overtemp switch that is tripping and shutting your motor off. Many motors use what they call a 'snap switch" ( looks like a small disk with two wires on it ) to sense motor temp and if that trips, then it will temporarily disa ... Vacuums

Vacum runs fine with hose disconnected and soon as any pressure is put to hose recepticle including your hand it shuts off


These machines have a "Suction" sensor this has become blocked or gone faulty, or the microprocessor has... yes there is one in here too. Probably going to have to get it looked at? ... Electrolux Epic 6500 Vacuum

We replaced the motor and the overheat light stays on and the motor does not run. Any suggestions?


Sounds like a bad thermal switch to me. take it a vacuum shop they should be a able to rewire it for you. ... Electrolux Epic 6500 Vacuum

Shark infinity vacuum nv31c motor overheats. everything is clean and free of clogs. it will work for 3-4 minutes, then shut off. does the motor need replacing?


Mine takes longer to shut down, but I just started having this same problem. I wish I knew what's causing it so I could fix it. I think maybe we had a power surge at some point when I was using it last week. :( ... Euro-Pro NV30 Infinity Bagless Upright Cyclonic Vacuum

My oreck orbiter overheats, shutoff, cools and runs again.


... Oreck Orbiter Floor Machines ORB-500, ORB-550, ORB-600 Vacuum

Eureka whirlwind litespeed 5843 baygess upright acuum, when overheat the switch won't work, when cool off it starts working. but now it turn on and run few seconds and stop.


... Eureka Whirlwind Litespeed 5740 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0527 seconds