Having problems with your Kenmore Vacuums ?

Kenmore powermate vacuum 116.5818380 take hood off to get to bel

\015 Kenmore powermate vacuum 116.5818380\015\012How do I take hood off to get to belt\015

Answers :

Repair Help & Product Troubleshooting for Kenmore Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore powermate vacuum 116.5818380 take hood off to get to bel

... Kenmore Vacuums

Broken vacuum jammed the rotating brush on a kenmore powermate vacuum cant get it to run properly after clearing the jam

Question; you can't run it properly meaning? The agitator (brush) isn't spinning? If that's the case, then Kazong is right, check the belt. If the belt is fine, check to make sure you didn't damage the bearing of the agitator.\015\012\015 ... Kenmore 23613 Progressive PowerMate Bagged Canister Vacuum

Need a repair Manual for Sears Kenmore Canister Vacuum with Powermate that was purchased in March of 1999. Only numbers we have are as follows: 20-29712-990; 116.29712990; and 116.59712990. The canister is making a clicking noise when shutting down and we don't see how to get to the inside of the unit as it doesn't have any visible screws. Thank you for any information.

... Vacuums

How do I open my kenmore powermate vacuum (model # 116. 22100400C)to get at the motor?It's making a loud noise when running.

... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

How do I get the cover off my Kenmore PowerMate canister vacuum? The roller is stuck.

Remove the top that covers your light bulb, remove the two screws, unscrew light bulb, flip unit over and find the two clips on the right and left side, gently press each clip and the hood comes off ... Vacuums


... Vacuums

Where can I get a replcement hose (with ends) for a Kenmore powermate vacuum model 116.2635081, powerhead model 116.5114190? Thank you in advance.

All Kenmore parts are easily ordered at Searsparts.com ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Need to check belt on a Kenmore WhisperTone powermate vacuum

There are two screws. Pry off the light bar on top by pushing against the sides, and you will see them inside just behind the light bulb. ... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

Kenmore canister vacuum 116.27615 won't run - Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

Needed, a new Hose for Kenmore Canister Vacuum cleaner. Model Number 1162497184 --A 3.9 Powermate Kenmore Vacuum Cleaner

... Kenmore Vacuums

Kenmore canister vacuum model #116 - Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

Where is fuse kenmore canister vacuum - Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

I was given a Kenmore progressive hepa filter 22313 Bagged Canister Vacuum recently, but don't have the manual. We used it once to vacuum the house and it worked beautifully. Then we used it 5-6 days later and it started whining and getting hot. What year was this vacuum manufactured? Where can I download an owners manual?? Help!

Http://www.managemylife.com/mmh/owner_manuals/5461/KENMORE-Vacuum-Canister-L0809572 ... Kenmore 22313 Bagged Canister Vacuum

The vacuum does not **** in dirt. It is blowing air instead. Yet when I disconnect the vacuum from the cannister, the suction seems very strong. I took it to a vacuum repairman, and he said that Kenmore sucks and I might as well get rid of it. (He wanted to sell me another one) It is 10 years old, but if I can fix it I would like to try.

... Kenmore 22613 Bagged Canister Vacuum

I have 2 Hoover Wind Tunnel-self propelled bagged vacuums-U6433-900 model.The roller bar does not agitate, the self propelled feature does not work and, in general, the vacuum is not performing well. I have replaced the roller bar, the v belt and the wide belt. The filters have been replaced and it has a new bag. I have had both of these since 2004 and they were fairly expensive $200 each) but if the repairs are prohibitive, I might as well get new vacuums. Suggestions? I just spent $100 for bel

The Hoover WindTunnel self propelled is a machine that we see in our retail stores (Vacuums Unlimited) constantly. The benefit of having a supposed "self-propelled" machine wears of quickly after the numerous time you will need to take this machine ... Hoover Vacuums

My Kenmore 35922 works well on floors, but it recently became very difficult to push on carpet. The brush spins and a local vacuum repair guy wouldn't solve my problem since the vacuum worked fine on his very flat, commercial carpet. What can I do to get my easy to push vacuum back?

Hi dalee196,There are three common reasons why vacuum cleaners are getting hard to push.1. Base is dirty - The base needs to be clean from dirt and tar.2. Height is too low - You might want to consider adjusting th ... Vacuums

I have an older kenmore canister powermate 3.9 and the vacuum itself works fine but the powermate isn't sucking after a toy was sucked up last week. The toy is out but the powermate doesn't work. I assuming that is what it is called. The big long part that hooks to the canister that actually cleans the carpet. I would appreciate any help.

... Kenmore 25512/ 25513 Progressive Canister Vacuum

The thermal motor protector on sears model 116.35912 Kenmore vacuum won't reset. The manual says to wait 30 minutes and the thermal protector will reset on it's own. It appears I would have to take the vacuum apart to get to the thermal protector. Is it worth the effort or should I trash the vacuum?

... Kenmore Vacuums

The telescoping wand on my kenmore magic blue cannister vacuum stopped working shortly after I bought it a few years ago. After 10 minutes of pushing sometimes I get it to work. It gets longer easier than shorter. What could be causing this problem? Please help!

... Kenmore Magic Blue 24195 Bagged Canister Vacuum

The retractable cord is stuck all the way out and will not go back in. Is there a simple way to fix this "disaster"??? without taking vacuum apart that is. And this is not my exact vacuum but I figure the cord problem would go for all of them. Ours is a ORANGE HEPA 360 Kenmore Whisper Belt 12 amp with PowerMate Model # 116.29219800

... Kenmore 27915 Bagged Canister Vacuum

How do you turn on the kenmore Progressive Canister Vacuum -- True Hepa. I bought my daughter this vacuum for Christmas several months ago and we can't get it to work.

... Kenmore 25512/ 25513 Progressive Canister Vacuum

Need tp replace belt on Kenmore CB-3 - Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

Switch I have a kenmore 31913 vacuum and the on/off switch appears to be bad. My problem is getting into the switch. How do I open up the handle to get to the switch?

Go to this website\015\012and enter your complete model number in the search field in the upper\015\012right corner of the page. You should be able ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My miele vacuum cleaner hose has no suction - Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

Have you tried changing your filters.? Also using genuine filters gives you much better suction ... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

I am trying to replace the cable and actuator on a Hoover windtunnel self propelled vacuum. but I cant get the top or hood off the get to them, I have removed all the screws I can see, roller, belts..what am I missing?? thanks so much for any help

Hi there SmartAlec from NelsonVacuums.com.au here. You will need to remove the knobs for carpet/hard floor selection and the carpet height to remove the cover they act as k ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1432 seconds