Having problems with your Kenmore Vacuums ?

Kenmore vaccuum model 116-25615500 power cord wall plug gets extremely hot during operation. What is causing this?

Answers :

Repair Help & Product Troubleshooting for Kenmore Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore vaccuum model 116-25615500 power cord wall plug gets extremely hot during operation. What is causing this?

... Kenmore Vacuums

I can hear a gurgling sound and a little steam comes out for about 5-10 seconds, and then it stops doing anything. However, if I keep it plugged in, the body gets extremely hot. I have a purple, model #: S3101

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My shark professional steamer plug gets extremely hot. Is that normal?

No it should not get hot undo the plug and check if the wirers are conected tight one of the main causes is loose wires, have you tried a differant outlet. ... Vacuums

Our kenmore progressive model #11634922 was working fine today. And then - it's not. Plugged in - nothing is working on it. We let it cool down (though it didn't seem hot). Still nothing - no light, no motor. Tried it in some other plugs that we know are functioning well - and still nothing. Any idea what might be wrong with it? It's six years old but doesn't get heavy use. Thanks so much ~ Susan Golden

Hi, it could be a number of things, cord may be bad as well as a problem with the motor. There also is a fuse that could have blown. If you go to sears.com, click on parts, put in your model number, when the page loads, click on the first link ... Kenmore Vacuums

Where can i get the charger cord that plugs into the wall for shark model sv736?

You can use any cord you like, just buy one, open the unit, and replace the cord. \015\012\015\012:D when i was 10 i replaced a vacuum cord with an orange extension cord and it still works today!!!!! 15 yrs later!!!!!\015\012\015\012Good ... Euro-Pro S3325 Handheld Steam Vacuum

Miele red velvet over heating. The plug gets extremely hot and shut down

... Miele S558 Red Velvet Bagged Canister Vacuum

I have had my RCA microwave model # RMW1108 for about 8 months now. It was working fine until yesturday evening. I went to warm up some food for 2 minutes, the microwave itself was on and everything appeared to be working except my food did not get warmed up. I plugged it out and checked all over it for any damage but i could not find anything wrong. What would cause it to just stop heating up the food? Is this type of problem covered in the 1 year manufacturer's warranty.

... Vacuums

I have a Kenmore canister serial number DB12027279, model 116-2234590. The problem is that the power cord plug gets very hot. Please advise what to do. Thank you.

Just a suggestion, as the debris enters the machine, it has to pass the motor. The motor has vents around it. Enough "debris" gets in that motor, the motor starves for power, which inturns make the media, the cord, work harder.\015\012\01 ... Vacuums

I own a watercooler 4 yrs old model # whkmd30The bottle water get extremely hot. There is good ventilation Any suggestions

Your water cooler has a Hot water section, also-- correct?-- You have 2 faucets, right?-- One COLD and ONE hot! Is it possible that the section that does the HEATING, is stuck ON and is in some way heating the water back up thru the connectio ... Vacuums

Our Mr Coffee Model FTX 45-1, all lights are onit is plugged in but thebut it does not brew coffee and the heating element does not get hot.

... Vacuums

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!

Hi,\012\012You have to open the vacuum cleaner and look for the wire.\012\012It is located inside the circular wheel, where it wind itself up.\012\012Don't be afraid to open it, unless your willing to pay somebody just to install a ... Electrolux Vacuums

Dyson 07 plug gets very hot after prolonged vacuuming

Electrical current passes through the electric cord and plug - it will get warm, that's normal. If the problem is worse where you smell an electrical burning smell, only an authorized dealer can fit a new power cord to your vacuum cleaner. Call the D ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

This Model likes to shoot electrical sparks between the plug and wall outlet when plugging in. I'm afraid I'm going to burn out an outlet.

This sounds might hazardous! Worry less about burning out an outlet, and more about the risk of electrocuting yourself!\015\012\015\012There's an electrical short-circuit somewhere, and the first place to look is the flex. Flex often gets damag ... Hoover U8311900 WindTunnel 2 Vacuum

Vacume model-40139000900 i just got a kenmore bagless vacume model-40139000900 for christmas and it is getting real hot, tunnel does not spin and it spits out everything back all over the floor?

... Vacuums

On a Kirby sentria the metal spool sticking out that goes into hose or power head becomes extremely hot and left burns marks on brush tube. It only gets hot when using power head. I checked all adjust

Check the brush roll to be sure it's spinning free too much drag can cause that to get hotter but usually it would break the belt. That spindle will get hot from the friction created by turning the belt and from the motor's heat. They'll just get hot ... Kirby Vacuums

I'm using (or WAS using) a Eureka ''the boss'' model 8803. The belt broke, no biggie, so I replaced it with a Eureka model U belt, the problem is when I put the new belt on and turn on the vaccuum, the belt breaks again. I am also having trouble getting the brush roller to fit right when the belt is in place. I can't find any sharp edges that would cut the belt,nor can I find where any small bits may have broken. Anyone have a solution for me?

First, make sure you have the right belt, second, i am thinking that you are not lineing the roller up right, it will only fit one way. look at the ends of the roller and the grooves where it slides in, you should be able to see clearly how it goes. ... Vacuums

I have a Janome Model 556, purchased in 1968 in Zimbabwe. I need to know how to replace the wires of the foot pedal. There were 4 wires used to go into the small plug attached to the machine, however the wall plug only had 3 wires.

... Vacuums

Cannister model#11627915701. connector terminals in extensionwand ,and wlre harness in hose handle get hot,,,look a bit singed.. can order and do ourselves. but would like a "tune up " ,cleaning of vacuum as well. purchased in 2008. have long haired dog,,,can't afford to be without it for very long. have sears store in clay ,ny. lady I spoke w/ says it would get sent out and take at least 2 weeks.!

... Kenmore Vacuums

Bought an PlayStation 2 at our youngest dauthers 9 year birthday together with an dance mat. Caused by an accident we had to buy a new remote contol for some years ago and we chosed your URC-3445. We can't get it to work. How do we get to AV-chanel throughtout your device? There must be a solution at our problem. Please help ....! Her anniversery is unfortunally today!!! Our TV is an rater old Tandberg modell: TVF2915NT Please...

Go to menu settings, find channel edit or add/delete, turn channel to input or a/v channel, select add channel and then your good. You should now be able to use the ps2. You can also hook them up through vcr and use the vcr input/av channel. and then ... Vacuums

Brand new Shark steam mop out of box - plug in, gets hot but steam won't come out. No steam, just hot mop - should we just give up and send it back?/

Hi,Some types of water will not work, try bottled spring water...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hot cord the cord on my vacuum cleaner has been getting very hot the heat is from one end to the other incuding the plug and also where the cord exits the back of the canister please help I love this vacuum cleaner it has been faithful to me for over 15 years!

Likely after all these years that the motor is starting to go bad and draw more amps thasn it should. a new motor at a vac dealer is your best bet. it was likely made by panasonic, so a new panasonic is your best bet, and less $$$than the kenmore for ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Just properly installed a Hampton Bay ceiling fan - Midili, 44inch Model #44-MDL. Loaded the remote control with a 9 volt battery and the remote is EXTREMELY HOT. Changed out the battery with another brand and the same thing happened again. It is so hot you cannot even hold the remote! Help...! I want to use my new fan.

... Vacuums

Dirt Devil Quick Power hand vac model 0896 won't charge. Red light doesn't go on when plugged into wall. We've lost our manual, need help troubleshooting.

... Dirt Devil M0896 Quick Power Bagless Handheld Vacuum

I have a kenmore vacuum model #116.28614801 and it just stopped working. When I plug it in nothing happens. I cannot get it to turn on do you have a manuel for this vacuum?

... Kenmore Vacuums

I bought a samsung SU3363 about 4 weeks ago and today after hoovering the plug was so hot it has melted into the wall socket. Can you suggest reasons why this should happen?

... Samsung Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7957 seconds