Having problems with your Kenmore Vacuums ?

Kenmore sweeper 21514010

\015 How to take cover off\015

Answers :

Repair Help & Product Troubleshooting for Kenmore Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore sweeper model 116-33919


Go to sears.com, click on the parts link, enter your complete model number, then you can click on the links for your vac and you can figure out what it takes, and you can order thru there also. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Kenmore progressive canister Sweeper


I figured it out ..by pushing the lever down and pry a screw driver into three different spots on the top, to release the rewind bar. Looks like three little j hooks hold it down. It took a flashlight and night time for me to see it. ... Vacuums

Kenmore Model 116.33922 or 116.33923 upright. The vacuum cleaner does not have any air suction through the floor sweeper part. It does in the hose. I changed the filters. What next?


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Sear Kenmore Upright sweeper, Model #116.36932502 makes a loud "howling"noise when switched on. It vacuums, but is terribly noisy.


... Vacuums

Wiring diagram for Model #11635922500 - KENMORE Upright vac I took the cover off of the vacuum to repair the power cord and must have pulled a wire out of its wire nut by the sweeper bar. If I had a diagram it would be no problem to replace. The bad has four short gray wires coming out of it. It is one of the gray wires that has come loose.


... Kenmore Vacuums

I have a Kenmore canister vacuum - model 25614506. Some time ago, I was not able to turn the vacuum off with the on/off switch, but could still use the vacuum. Turned if off/on by pulling the plug. The other day when I went to plug it in, I heard a pop. Now the sweeper runs but the vacuum cleaner does not **** - no air flow. What could be the problem. The cleaner is only 4 years old.


The motor has an inline fuse ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

The sweeper wont move - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My power head on my Kenmore canister sweeper dont work right.How do I get it apart and fix the problem?


Try pushing the reset button on the top of the power head first. There is a protection system on Kenmore canisters that protect the belt from breaking, and if something was vacuumed up into the head, it will cause this reset switch to activate to p ... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

I have a Kenmore Progressive with Direct Crive Model 116.35922502 I was sweeping and my sweeper just shut down, I pushed the reset button and it is not working to either. What do I do now?


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Change my hose on my kenmore canister sweeper model 11623312303


... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

I have a Kenmore Progressive Canister Model # 29612992. I was replacing the sweeper bag, when I opened the lip, the plastic arms was pull out of joint and will not close. I removed the 2 screws under the lid to put back it in place but there I can't remove the plastic molding because there are still screws holding somewhere. Are there tabs instead of screws still hold the molding?


... Kenmore 25512/ 25513 Progressive Canister Vacuum

I have a kenmore 116.25615506 vac and I want to replace the connector on the power sweeper. I cannot figure out how to disassemble the "electric folding wand" to get the connector out


... Kenmore Vacuums

My upright kenmore progressive vacuum will not suction up when using the sweeper. It will suction things when I use one of the tools. I have put in a new bag and have tried to see if anything is blocking the bottom. It sometimes makes a very loud noise when I try to vacuum. If I press the intell clean on and off yellow button the noise may go away but it still does not work.


Double check hose placement, making sure you have the hose inserted into the correct slot. The long attachment nozzle stores in the front hole on the right, and the sucking hose inserts into the rear hole on the right. I know this is too simple of a ... Vacuums

Kenmore sweeper 21514010


... Kenmore Vacuums

Kenmore canister sweeper model 116 2621 2602


... Vacuums

I have a Kenmore Model 116 26312603 sweeper. The vacuum motor does not run, the power head does run. What is the most likely solution?


If the switch is a simple on/off switch,it could be that.Make sure it is unplugged.If you take the switch apart,twist the two wires together,and cover with electrical tape.If you do not have electric tape,make sure the connection is off of the ground ... Vacuums

I have a Sears Kenmore canister sweeper with the power mate, but it no longer has sufficient suction to pick up dirt. I took the machine apart and cleaned it, but it is still not sucking, does this model need to have the motor oiled?


When cleaning the machine, did you do a good job of cleaning the beater brush and making sure it turned freely in the holders on each end? Perhaps a bit of WD40?\015\012Also, a new set of belts might help a bit. ... Kenmore 22812 Bagged Canister Vacuum

Kenmore 116.2481190 vac I need help with replacing the hose


... Kenmore 22812 Bagged Canister Vacuum

Kenmore Whispertone 100 connection issues


Find a used one at a vac repair shop, its just worn out ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Kenmore canister,model 116 52512201


Do check and make sure you've removed all screws as some are recessed then look at the front of sweeper to see if there are what I would call clips/hinges holding the bottom plate on gently seperate plat e from head Hope this helps ... Vacuums

The brush does not turn on my kenmore intelliclean beltless drive upright. how do i correct this?


... Kenmore Vacuums

Silvermoon overheated and shut down. we've waited for it to cool down. When attempting to start the sweeper the red caution light (red triangle with exclamation mark comes on) but sweeper does not turn on. There are no obstructions in the hose or sweeper bag. There is a reset button. I pushed that but still no luck. Is there a fuse or something that needs to be replaced?


... Miele s558 Silver Moon Vacuum

Webpage error detailsrn User Agent: Mozilla/4.0 (compatible; MSIE 8.0; Windows NT 5.1; Trident/4.0; FDM; AskTbPLTV52/5.12.2.16749) Timestamp: Wed, 1 Jun 2011 21:06:26 UTC Message: HTML Parsing Error: Unable to modify the parent container element before the child element is closed (KB927917) Line: 0 Char: 0 Code: 0 URI: http://www.facebook.com/hoshmend.ali1


... Euro-Pro PT205 Leaf Blower Powerful 12 AMP Leaf Blower, provides 205MPH air speed, Detachable Vaccum... Vacuum

My shark bagless sweeper worked for about 6 months. Like a previous blogger, I caught the edge of a rug that jammed the sweeper, three red lights blink, the brush is free moving yet the sweeper will not work. I did leave it plugged in all the time otherwise it would not run but for minutes. Very disappointed. New battery? what if that doesn't work? is it junk then, money down the drain.


This will probably cost you more to repair than to buy a new one. Does it turn on at all? ... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

I bay this SWEEPER 6 of july 2012MODEL : V1725E I need batary 4.8 V.DC , MODEL : V1725E EURO-PRO CORDLESS RECHAREABLE SWEEPER


You can get your battery off the link below ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0199 seconds