Having problems with your Kirby G4 Bagged Upright Vacuum ?

Won't turn on. How to reset the fuse

\015 Won't turn on. How to reset the fuse\015

Answers :

First thing you want to make sure that both safety switches are engaged\015\012(nozzle and bag) if this doesn't help, than it could be many different\015\012reasons (cord, motor). You can fill out Service request form on our\015\012website and sent power unit to us. We would inspect it and let you know\015\012what is the problem and how much it would cost you:
First thing you want to make sure that both safety switches are engaged\015\012(nozzle and bag) if this doesn't help, than it could be many different\015\012reasons (cord, motor). You can fill out Service request form on our\015\012website and sent power unit to us. We would inspect it and let you know\015\012what is the problem and how much it would cost you:
http://www.goodvac.com/GoodVac_com_vacuum_service_s/14.htm

Good Luck,
Rocky
Kirbys have no fuses. You either have an electrical problem, physical blockage, or the motor is bad. Can you turn the drive shaft freely when the brushroll head is removed? If not then you have something stuck in the fan chamber or the motor is bad. If it turns freely then it is most likely an electrical problem. Kirbys motors can take a lot of punishment so dont get rid of it. They are normally very inexpensive to repair.
Repair Help & Product Troubleshooting for Kirby G4 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The microwave will not turn on. No power. Checked fuse box and power outlet...not the problem. Unit just wont turn on? Is there a reset button or another option.?


Remove the cover and locate the internal fuse you will find near the power cord entry. Replace with the same. ... Vacuums

Kenmore canister model 116.25513506 wont turn on. when handle switch is turned to floor. vac motor does not turn on. When switch is turned to carpet, floor nozzle works but vac motor does not. I checked fuse, all o.k. checked continuity for plug, o.k. removed wires for bag full switch...motor wont run. I wired motor directly power cord...motor runs. Thinking it must be the circuit board, how do I bypass it or test it?


... Vacuums

Have a hoover windtunnel platinum. I have changed the bag ( hepa Q bag) but the bag light wont reset. so the vaccum wont turn on. I have unpluged it and let it set for a while with the new bag in and repluged it in. I have checked the brushes and it is all clean but it will not reset. This only the second bag so it is a new machine I should not be having problems. Is there some sore of reset button I can hit.


... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

I have a hoover windtunnel platinum. I have changed the bag ( hepa Q bag) but the bag light wont reset. so the vaccum wont turn on. I have unpluged it and let it set for a while with the new bag in and repluged it in. I have checked the brushes and it is all clean but it will not reset. This only the second bag so it is a new machine I should not be having problems. Is there some sore of reset button I can hit.


... Hoover Company Wind Tunnel U53019 Upright Vacuum

I have a DC14. About a wk ago it was making loud sound and bar stopped turning. i unclogged everything....now the suction works great. However, the bar still wont turn. The belt inside is still intact and isnt loose. Several solutions suggested resetting the "Red" button...i have searched the vacuum over and over. there is NO red or any other color reset button. The bar is set down perfectly in there, the cover plate is installed properly. What other problems could there be? Or do i just need to


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Won't turn on. How to reset the fuse


First thing you want to make sure that both safety switches are engaged\015\012(nozzle and bag) if this doesn't help, than it could be many different\015\012reasons (cord, motor). You can fill out Service request form on our\015\012website and sent p ... Kirby G4 Bagged Upright Vacuum

Brush wont turn..Pressed reset still no turn - Vacuums


If the motor runs and the brush doesn't turn, the first and best suspect is the belt. ... Vacuums

No power The vacuum worked. Then cut off. I changed the bag and let it sit a bit. Then it turned on. I used it for about 5 minutes and now it's off again and won't turn back on. Is there a fuse or something I can reset?


Miele Capricorn whole unit shuts off totally off when I am using the Miele and I turn the powerhead sharply to the left. It an on-going problem that I have had serviced serval times. The last time the place I purchaced it from replaced the whole bead ... Miele S514 Solaris Electro Plus Vacuum

Bissell model 3575 vac won't run, when I turned the switch to on it tried to start, and now won't. The light turns on. Is there a fuse or reset button??


... Bissell 3575 CleanView Upright Vacuum

I have a Bissell lift-off revolution. The power won't turn on at all. Tried different outlets. It doesn't work whether the lift-off canister is out of the frame or in the frame. The manual refers to a reset switch but can't find it, even when I took the cover off the main canister unit. Where is the reset button and/or fuse?


I have the same issue too. Brush motor is working and brush is turning on but the vaccum motor is not working. If I take the canister out of the frame then it wont turn on at all. Any help? ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

I shorted out the light socket on my Chamberlain Professional Garage Door opener. Now it wont open, I am looking for a fuse or reset button, but cant find one. Is there a way to reset it or did I fry the solinoid


First check your house fuse. ... Vacuums

The Shark steam cleaner wont turn on when plugged in. Is there somewhere on the machine where maybe a fuse was blown or shorted out and needs to have a switch turned back on?


... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

Eureka enviro vac 3041bz son sucked a sock up in the vacuum, its turned off. I removed the sock from the tube. Now it wont turn back on. Is there a reset switch and if so where is it located


... Eureka 411A Upright Vacuum

Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would


... Hoover L2310 GUV Central System Vacuum

The light wont turn on and mop wont get hot is the fuse bad


You have to consider several things. Fuse is the first thing to check, but you need to check also if there are loose wires and check also if the plate is still working. These are the things that you need to check.If all else fails after r ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My Vacuum just stop working. I was cleaning my car carpets when it just went off. I tough it got disconnected from the outlet (power supply). The vacuum was connected and it is like when a fuse go bad, just like that it won't turn on anymore. Is there a switch that needs to be reset or a fuse to be replace? How do you do it?? Thanks


There is not any of that. Buy a new one ... Hoover Empower Bagless Upright Vacuum

My brand-new Hoover Windtunnel T-Series Pet Rewind Bagless vac simply shut off while I was using it and now I can't get it to turn back on. I've emptied the dirt collection bin and let the unit sit unplugged for 30 minutes to reset the Thermal Protector as per the manual. I've even tried a few different outlets just in case a fuse got tripped, but the vac still won't turn on. What happened? Do I need to return this vac to the store? I just bought it 5 hours ago.


... Hoover Vacuums

I have a Riccar R-200 upright vac. My wife ran it for an hour without stopping and a full bag. The motor cut off and the unit won't turn back on. Is there a fuse to reset in the unit if it overhe


... Dyson Vacuums

Today i was hoovering, and then my dyson just cut out! i left it a few hours then went back to it, it gave a little noise when i switched it on, then again i tried but it failed to come on! ive even changed the fuse in the plug! and now my dyson wont turn on at all, ive cleaned everything there is too clean! help! :D


It looks like you need a professional repair. If you're really lucky this may just be a break in the flex, or the switch has failed - both relatively cheap and simple to sort out. More likely, though, is a problem with the motor (carbon brushes worn ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I am wondering if there is a reset button on the g4 kirby vacuum? I used it 2 days ago works good and today wont even turn on and I have tried several outlets in my house


Hello Sheri_stange.Unfortunately, there's no reset button on this vacuum. What you can do is make sure that the brush roll housing and the bag unit are on firmly as there's a safety switch that will disable the Vacuum to turn on if either ... Kirby G4 Bagged Upright Vacuum

Caught rug, motor overheated, the brush wont turn at all, but suction is still there ...is there something I can do to reset it?


Assume that the belt is broken to the power brush /head. Did you happen to smell burning rubber at all when the motor got stuck? The motor may have a reset on it, if it was not operating, but that is not the case, as mentioned. Look in your manual fo ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My Eureka Altima Upright Vacuum Model 2996AVS Vacuum wont turn on. Any advice where to start? I would think it may be a fuse but do not know where it is on this vacuum.


... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

I have a Dyson DC 14, it will not turn on. Is there a fuse or reset button?


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a hayden premier supervac central vac system, while working on the switch in for the beater bar, the actual unit has turned off, the green light is no longer lit, is there a fuse on it somewhere or a reset button, i have tried unplugging it and replugging it in, but can not seem to get it to power up now?


Should be a reset on the main unit near the top ... Vacuums

My Eureka Altima Upright Vacuum Model 2996AVS Vacuum wont turn on. Any advice where to start? I would think it may be a fuse but do not know where it is on this vacuum.


Generally, on something with a cord and plug, the first thing I suspect is a bad spot in the cord where it connects to the plug. One way to check it is to turn the vacuum on, plug the plug into a good outlet that you have checked to make sure it wor ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0644 seconds