Having problems with your Kirby G4 Bagged Upright Vacuum ?

I have a senteria about 4 yrs old. it bounbes

\015 I have a senteria about 4 yrs old. it bounbes when pushed forward and the handle bounces up and down when it is not pushed. ?\015

Answers :

Check the wheels and axles for damage or bent shafts. Remove the bottom cover and inspect the brush roller for damage--breakage of the roller, bad or broken end bearings, missing brush sections, or something stuck to the roller like a wad of gum or something. Hope this helps!
Repair Help & Product Troubleshooting for Kirby G4 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a senteria about 4 yrs old. it bounbes

Check the wheels and axles for damage or bent shafts. Remove the bottom cover and inspect the brush roller for damage--breakage of the roller, bad or broken end bearings, missing brush sections, or something stuck to the roller like a wad of gum or s ... Kirby G4 Bagged Upright Vacuum

I have a kenmore canister vacuum cleaner, 4 yrs. old, model #116.27815701. The powermate assembly, the one for the carpet, seems to have a short or something. The light goes on and off and the motor

... Kenmore Vacuums

Eurosteam iron now (2 yrs.) hissing and whistling.

... Vacuums

Roomba 530 runs for about a minute then stops and red light is on. Cleaned everything, still happens. Roomba is about 3 yrs old, lots of use.

Battery time! Get a nice new longer life battery on Ebay, or go for the Nicad replacement if you have no carpet and want to save some cash. ... iRobot Roomba 560 Robotic Vacuum

I was vacuming with the hose only with my kirby generation 3 vacum and it suddenly made a different sound and smelled strong of burning. I immediately shut it off and unplugged it. It IS about 30 yrs old. Do you think it is worth taking in to pay someone to look at it or it just bit the dust?

It might be the belt and if it is it will be a sipmle fix. If it isn't I think It's time to bite the dust and buy new. You won't believe what you old vacuum was not sucking up and for what it would cost to repair vs buying new it would be about the s ... Vacuums

Aquavac runs for short time then cuts out blowing the RCD . Have rewired mains cable thinking a broken or loose wire... still same problem. Have also noticed that a lot of sparks etc coming from the motor brushes. Vac approx 10-15yrs old.Aquavac is model 6310B

... Vacuums

If you hold down thepower switch will not engage... same thing as effernan above! Who knows the solution.... this machine is only 2 yrs old....

Cool, ok the problem is in the internal contacts within the switch. Usuall a broken spring. It will require a complete new switch. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

My Hoover carpet cleaner is approx. 7 yrs. old....husband believes motor is shot? Smells burnt when running....fix or buy new???

You are correct, the motor is shot. if you like the machine replace the motor. i would get an est. on the machine from your local vac shop and the go price them. in some cases its better just to get another machine. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Senteria power will not come on at all

Make sure the bag and the front nozzle are attached all the way. There is a safety switch on the bag and nozzle. If either one of these is not on all the way the machine will not come on.There is a reset circuit near the cord inlet. Make ... Kirby G6 Bagged Upright Vacuum

I have a Simplicity S24 canister vacuum. It's about 3 yrs. old. In the past year I have had it in the shop 4 times because when using the rug piece, the piece turns on & off, on & off. The actual vacuum doesn't... just the rug piece. I recently spent $65 on a new part, after spending countless dollars the other 3 times it was in the shop for this problem. I'm ready to buy another name vacuum altogether as I feel this vacuum is not worth the money that was spent on it. I'm very frustrated.

Repair shop has not fixed the problem? complain until they fix it properly. This is a pressure fault / jamming issue or slipping drive. Repair shop should have fixed it 1st time. ... Vacuums

Our Miele vacuum is only 2/3 years old and seems to have given up the gost, our previous one lasted 15 yrs. The machine starts ok and within 4/5 minutes the power drops down and the hoover comes to a stop and it may re-power itself again within minutes, as of today their is no power when the on button is pressed. What do you think the problem is Thank you.

There is a circut board that is going bad and not providing the power to run the motor. You will need to contact a Miele dealer for that part. It is the only board that is in this machine so they should just need a model number in order to get it ... Oreck XL Ultra Bagged Upright Vacuum

The overload on my dyson cuts in after about five minutes,and I have to wait hours for it to reset? it is an upright about ten yrs old

Check both your filters and make sure you dont have any cloggs. you have 2 filters, one premotor filter on the side or top of the canister. also check your hepa filter which is located underneath where the canister sits. Dyson claims this to be a lif ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Overheating Our Bissel bagless upright is about 1-1/2 yrs. old and is overheating.

Check filters and for blockage - poor air flow then will overheat ... Bissell 6594 PowerForce Bagless Upright Vacuum

Kirby 3g I have a kirby 3g about 4 yrs old and when I push it forward it just takes off, how and I adjust the tranny to control it better. Jeff

\015\012 Here's a link on how to adjust the transmission on the kirby...the kirby pictured is a G4 or 5 but it is the same transmission as the G3\015\012\015\012\015\012 \015\012\015\012 ... Kirby Generation 3 Bagged Upright Vacuum

Lost electronics are great-this thing is all mechanical (still-i finally bought one after using moms for 10 yrs), completely unnatural for me-so so so lost!

Check out the "Online Kirby Vacuum Manual" at GoodVac.com.\015\012Here is the link:\015\012\015\012http://www.goodvac.com/articles.asp?id=135 ... Kirby Ultimate G Bagged Upright Vacuum

Lead from water fill and detergent dispenser. Two small black stoppers don't fit tightly. Hoover Steam Dual Vac 12 amps Approx 5 yrs. old

You may have to replace the tank if the seals don't fit tight. ... Vacuums

I bought a Euro Pro Shark Steam Vaccum about 3 yrs ago. Now, suddenly, it won't switch on. I checked the power receptacle and tried other receptacles. It still won't switch on. I wanted to open and check the inside but it needs some special tools (and long screw drivers!). Any suggestions on what I could do?

... Euro-Pro S3325 Handheld Steam Vacuum

I have a hoover u6660-900, 3 yrs old. The drive support works OK in the forward motion but does not in the reverse motion. I don't mind using a screwdriver, but not sure where to start or look. Your thoughts? wally

Another, truly free web site. ... Hoover U6660-900 WindTunnel Bagless Upright Vacuum

Vacuum cleaner hi.this is 10 yrs old and not overly worked.bags are changed regularly and the micro filter has been changed at least three times over ten years.it goes well for about 2o minutes then loses power with not much "suck"after that.sometimes shutting down completely,because of overheating i presume,or just carries on at a much lower'"suck".have tied shaking bag inside but no luck.any suggestions out there or can you tell me the agents support office for new zealand[auckland].many thank

What brand vacuum is it? ... Vacuums

Low suction I have an Electrolux central vac that is approx. 11 yrs old. the suction is very low. this started about 1 week ago. I checked the hose and it is clear. I also went into the attic and checked the pipes(as far as I could see them) and they appeared to be intact.

1) Have you checked the filter? If it is clogged your suction will be low. Also, you could have a pipe loose where you can't see. Make sure that you can get a coin to go all the way through the hose. make sure the suction motor ( the unit ) is coming ... Electrolux Central Vacuum

Houver Cleaner My self propelled windtunell baged Vacumn has a broken belt. The small visible one that is visible is intact. This is the thick belt. I cannot for the life of me figure out what to open and how to replace it. The model # is U6 401-9RM I keep asking for a manual online but it doesn't recognize this number. I am 67 yrs old broke and fix it challenged..lol can you help me?

Take off the bottom plate, The flat belt ges around the motor shaft and then around the bigger pulley by the V belt. It will stretch to o on.\015\012\015\012 ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Our vacum isn't picking up @ all.we did have some thread around the brushes, about an inch wide. it has an odor like it is getting hot. the vacumn is about 1-1/2 yrs old. we need help. thanks BETTY COX.

Hi, The most likely cause would be a blockage. If you remove vac hose, does it **** on your hand? secondly, with the vac unplugged, Can you turn the brush reasonably freely ? Is the drive belt on? ... Vacuums

Model#F5858-910 hoover steam vac,silver ,spin and scrub. It doesnt seem to spray cleaner it seems to stream it now. what could be wrong? I cant get to end of where it sprays to see if something is blocking it . otherwise it works great. I have it about 8 yrs. always worked good until recently

... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a dyson - bought it 3 yrs. ago and the roller brush stoped working - doesnt pick up anything. Can you help? The brush doesn't roll or spin. Where can we take it to be fixed and is it under warrenty? THis

Don't worry it's probably just that the belt has broken or stretched. Your actually supposed to change them yearly. So if its been three years thats probably the case. Here is a link to the belt you need and a manual with instrutions: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Need to vacuum and my Kirby G4 and was wondering if it has a power reset button, or if anyone knows what it could be. It is in very good condition and was rebuilt 2 yrs ago. Please help???

Hello, sheriI was trying to help you out here. Maybe this will help some? I was going backto some customers that asked questions in the recent past and even fartherback. It appeared that no one answeredsome of them, So, I thought I would t ... Kirby G4 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0100 seconds