Having problems with your Kirby G4 Bagged Upright Vacuum ?

Replace broken coupling to hose

\015 Have new replacement coupling how do I reattach the hose?\015

Answers :

Heat the end of the hose under the hot water tap 10 seconds the fit into new coupling
Repair Help & Product Troubleshooting for Kirby G4 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replace broken coupling to hose

Heat the end of the hose under the hot water tap 10 seconds the fit into new coupling ... Kirby G4 Bagged Upright Vacuum

Plastic handle and coupling on hose gun got broken. EUREKA UMC18

... Eureka 1810 Central System Vacuum

I have Optima, 12amp Eureka vacuum, Model 431, AXZ type and the extension hose for cleaning corners and edges --the plastic part that the attachments fit into has a piece broken off and tools don;t fit anymore. It looks like the hose attachment can be replaced--can it be and if so--where can I get a new hose attachment. It seems it is cheaply made of plastic and really shouldn't have broken a piece off.

... Eureka 431A Optima Bagless Upright Vacuum

How to replace just the Kirby 210097 Hose End For G5 Series Vacuum Cleaner to hose. can buy replacement but can not get the broken end off

Simple and rquires no tools. Fill your sink with hot water and set the end in water with attachment on it. Within a few minutes the end is soft enough to slip out. setting the hose end in the water again will let you simply slip the hose into the ... Kirby G5 Bagged Upright Vacuum

Broken hose The hose on my Hoover F5837-900 Steam vac Supreme broke away from the coupler on the bottom of the unit - under/behind the recovery tank (solution tube is till attached). It might have gotten pinched in there a couple times. Problem - it was glued in the coupler really well, and I cannot get the whole thing out - hose will be too short anyway - is there a way to fix this or a part I can order instead??

You will have to replace the complete hose asm, part # 90001337 ... Hoover F5837-900 SteamVac Supreme Wet/Dry Vacuum

Kenmore Model 116 28014700 intuition vacuum cleaner. Latch for hose connection to cannister broke. I have the new part. How do I remove the hose from the broken part and replace it on the new part? I have already purchaed the new part p/n KC92PDDUZV06 for this, bt can't figure out how to get the old part off. It looks like you must destroy old part in order to get it off.

... Vacuums

Kenmore Model 116 28014700 intuition vacuum cleaner. Latch for hose connection to cannister broke. I have the new part. How do I remove the hose from the broken part and replace it on the new part? Thanks

Hi\015\012\015\012To remove the broken part from the latch use a small screwdriver to release the tabs on the latch on the connector. When latches are released the latch assembly and the plate will slide out of the connector. When the pla ... Kenmore Vacuums

Broken Upholstery hose on my Hoover SteamVac Model #F6020. How do I remove the old hose to replace it?

... Hoover F6020-900 SteamVac Upright Vacuum

The switch to my Riccar 1500p hose is broken for the 2nd time. I don't want to replace the entire hose again, where can i get the switch and leads?

Take the screws out to take the handle apart. Remove the switch and take it to your hardware or local vacuum to to get the correct replacement. ... Riccar 1500 Simplicity S24 And S20 Electric Suction Hose Assembly

I'm using a Eureka maxima 12 amp vacuum and where the hose is connected to the vacuum by a screw that part is broken where do I find a replacement hose that includes the clear plastic part that I can attatch to the vacuum?

... Eureka 4700A Maxima Bagless Upright Vacuum

Lower hose broken hoover agility how to replace

To replace a hose on the Hoover V2 is a pain in the you know what. i would recommend 1. take it in and have a professional repair shop do it.2. trade the V2 in for the Hoover PowerMax steam cleaner with spinscrub they are 10 ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Steam Vac F8571-900 hose if broken off at the point where it enters the machine. Can I replace it or where to get it fixed in Bemidji MN area

It will have to be replaced, need to see a service center for vacuums to get the part may cost around 50 dollars for the part. ... Hoover Vacuums

No suction My dirt devil featherlight vacuum has no suction. I have checked all hoses and they are clear. I did replace the belt which had broken and since I did that the suction is gone.

Take the cone filter out of the dirt cup and start it up if you have suction the filter is the problem,if still no suction the you have a clogged hose or a clogged intake hose which is at the bottom it will be a clear hose coming up the backside fro ... Dirt Devil Featherlight Bagless Upright Vacuum

Initially it was not sucking, I replaced the broken belt. Now it is sucking but not throwing in to attachecd container and also the hose is not sucking.

Hi,\015\012Check that there is not an obstruction inside the hose.... Have had a number of them that the hose was plugged up with dirt, fuzz, etc,,,, it can be hard to find sometimes...Take at least one end of the hose off and make it straight, ... Vacuums

Seeking to replace the broken clear plastic part on the surface use end of the hose, Little Green Model 1720-1.

I think this site may help:http://www.fixya.com/search.aspx?cstm=0&_s=Little+Green+Model+1720+1+ManualJim ... Bissell Vacuums

Hi, I have a Sebo X4 which is almost 3 years old. I haven't had any problems with it until the last couple of days when I notice a slight screeching noise when in upright position, coming from the roller mechanism area. If I slightly push the sebo forwards it gets worse, if I tip it back it stops. If I take the roller out and switch on, there is no noise. I have always been careful not to tip the machine forwards when using the hose, but I recently lent it to a friend whose hoover had broken do

I dismantled the top part of the machine from the bottom and there stuck right down in the bowels of the tubes was a piece of card, a dress label! somehow it was only making a noise when the machine was in an upright position. It took a bit of stretc ... Sebo X4 Bagged Upright Vacuum

Eureka The Boss Power PLus Model # 4703 Type A Ser #: 0728007324 Adapter that goes between the hose and the vacuum body is held on two tabs (screws). The screw tabs have broken off. Where can one obtain a replacement adapter?

... Eureka Power Plus 4703D Bagless Upright Vacuum

Progressive Kenmore hose canister connection broken 116,2341130

A regular person with patience can however it is tricky. Kenmore hoses have an arrow at the cuff where the corrugated hose meets the swivel elbow at the machine, and at the cuff where the handle meets the hose. If your parts fit in the handle, the c ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I am replacing the hose on my kenmore canister 11622612200. i easily replaced the handle end of the hose, but cannot see how to replace the end that goes into the canister. can you tell me how to disassemble the canister end for the new hose? many thanks!

Open the canister and locate the hose intack. There is a plastic retainer which slides over the end of hose and is secured to the body of the canister with a few screws. Remove the screws and pull the retaining ring up to release the hos ... Vacuums

Hello, I have a Hoover quadraflex Powermatic central vacuum system Model # s8099-031 that requires a new replacement 35 ft hose...I have contacted Hoover and they do not know where to buy a replacement hose for this model. I live in Canada. Any idea where I can get a replacement hose for this system? Thanks kindly, Tammy

Tammy, no info re your location, so I''l try this.Your Hoover hose is shot because it was made of rubber.There are new swivel handled, tangle proof lighter hoses made of vinyl which will last much longer and can be adapted to the old Hoover hea ... Vacuums

Broken Water Channel Hose Assembly

Hello....do you have the user manual ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hose Problem The hose broke just above the cuff on the inlet end of the hose.  I found that the hose doesn't thread into this cuff but appears to be heat bonded in some way. Can I get a replacement cuff or do I have to replace the hose?

Looks like you can just get the hose, part #38479-4, It should just screw into the adapter or it may be glued in. ... Eureka Sanitaire SC4570 Bagged Upright Vacuum

My bissell proheat upright steam cleaner is spraying out through the attachments just fine, but will not spray to the floor when using upright. we've taken it apart to find that there is no water at all going through one of the hoses, but it appears the hose is connected behind the on/off and heat switches, we can't seem to figure out how to get in there to replace that hose....any suggestions on how to access this?? just curious how you would get in to replace the hose, we know it is the hose..

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Replaced internal pump. Color coded hoses for replacement. Marker has worn off hoses. Need proper routing of hoses from clean water tank, to heater to spray nozzles. An internal schematic of hose routing is preferred.

Hi\015\012\015\012Thanks for using FixYa. Please remove the top cover of your Bissell cleaner. Now place the Auto-Mix selector knob to the water only position. Turn the cover over. You will notice an angle on the ... Vacuums

Broken hose connection

... Dirt Devil M085570 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3385 seconds