Having problems with your Kirby G4 Bagged Upright Vacuum ?

Shampooer won't distribute foam/soap evenly

\015 It appears that the shampoo won't spread over the carpet evenly. Could it be clogged up somewhere and if so where?\015

Answers :

Disconnect the hose from the tray - if you are getting good flow of the foam - I'd say you probably did not lower the shampooer all the way down.

If the foam is not being dispensed continuously - you may want to check:
1. Check the suds screen - make sure it is clean and installed in the tank and is clean f lint
2. Check the sponge where exhaust is inserted in the tank - rinse it. Also look for the clog under the sponge in the valve.

Good Luck
Repair Help & Product Troubleshooting for Kirby G4 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Shampooer won't distribute foam/soap evenly

Disconnect the hose from the tray - if you are getting good flow of the foam - I'd say you probably did not lower the shampooer all the way down.If the foam is not being dispensed continuously - you may want to check:1. Check the ... Kirby G4 Bagged Upright Vacuum

My purple shark wont steam and does not even heat up like I didn't even plug it in

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hi my hoover vacuum, stopped working,does not even turn on,I accidently went over a shoelace but stopped before the shoelace went in, ,,becuase of that the belt came off,and then i put belt back on, and now it wont even turn on

... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

I have a vax steam cleaner v081 the steam wont come out of nosell even thought it is heating up and the green light wont go off

... VAX Appliances V081 Canister Steam Cleaner

Vax carpet shampooer wont release shampoo

If you unscrew a bit on the base that allows you to take off the brush, you will see a black plastic strip with very small holes in it. These are where your shampoo comes out of. Take a needle and re-pierce these holes and it should work again. I hav ... VAX Appliances Vacuums

Agitator brushes wont turn even after cleaning

The brushes will not turn even wen the switch is turned on ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes wont turn on my bissell clean shot shampooer

... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Brushes wont turn on shampooer

Dear Momneville\015\012I have the same steamcleaner and had the same problem, I took mine apart a found a clog between the turbine and the wheel that the turbine moves by vacuum when it gets glogged there is no vacuum to move the wheel. If you ... Hoover F7220900 SteamVac V2 Upright Vacuum

The beater bar wont rotate when set to floor cleaning on bissell aromatic carpet shampooer

... Bissell Vacuums

My bissell proheat rug shampooer wont wet carpet at all

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell carpet shampooer wont dispense water

Bad Pump. You pump is where the belt attaches to spin the brushes and also puts water on the floor. Take it to you local Best Buy to be serviced or a local appliance shop which may service it. ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Red "bag is full" indicator shows even though new bag has been put in and vacuum cleaner wont pick up. Also floor adjustment does not adjust. This is for a powerforce model 3522 series

The red light tell you that it is sensing a full bag. But a clog in the hose or the inlet down by the brush roll will also do this. ... Vacuums

Wand i can not get the wand out. It is suppose to be a quick draw it wont even budge i had 3 people pulling on it and still will not come out. help

I just took my DC17 apart to determine the problem (noted above). Basically it seems like there is a 'nub' on the lower part of the extension wand. Actually, there are two on either side, one higher (white, facing the back) than the other (black, fac ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dyson has stopped working. There was a burning smell and then a strange noise and now it wont even switch on.

The Motor sounds like it has gone bad. Bagless machines like these always have motor problem. If it is under warranty then it will need to be shipped to Buffalo New York. I would trade in in on a Riccar vacuum. You can get 20 years out of those f ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My wertheim 6030 is overheating I have changed the bag and filter even though there was no indication this was needed now it wont turn back on

Have you removed the bottom of the vac to be sure there is no obstructions? Check the intake area for an obstruction. Also look around the motor for vents. Are they clear? Most new vacs have a reset button. This will typically reset the motor. If non ... Vacuums

No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!

I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

The brushes wont spin on my Hoover rug shampooer Model # f7220-950.

Try cleaning brush...\015\012if sam problem need replaced turbine part no:\015\012\015\012\015\012\015\01243191009\015\012 Turbine & Gear Assem ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brushes wont spin ,even though the belt is intact

The belt can develop a worn spot. It will be intact but not spin. Replace the belt and make and remove any hair or other garbage from around the ends of the brush bar. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I am wondering if there is a reset button on the g4 kirby vacuum? I used it 2 days ago works good and today wont even turn on and I have tried several outlets in my house

Hello Sheri_stange.Unfortunately, there's no reset button on this vacuum. What you can do is make sure that the brush roll housing and the bag unit are on firmly as there's a safety switch that will disable the Vacuum to turn on if either ... Kirby G4 Bagged Upright Vacuum

My kirby vac when using the shampooer doesn't distribute the solution

Make sure that the small round suds screen is in place on the shampoo tank where the hose connects to the tank. \015\012Here is a step by step guide to help you out...\015\012\015\012 ... Kirby Ultimate G Bagged Upright Vacuum

I have a Bissell powergroom vacuum cleaner and i sucked water into it and now it wont even turn on what could be wrong with it??? It was a very expensive vacuum and i dont want it to be thrown out

... Vacuums

I forgot how to use the shampooer...misplaced the manual along with the DVD! I don't remember how to distribute the foam/bubbles and then how to take up the bubble......Any advice would be appreciated.

Here's my free online guide. If it helps, please be sure to rate it. Thanks!\015\012\015\012 ... Kirby Ultimate G Bagged Upright Vacuum

Stopped sucking up dirt a week ago, and now it wont even come on, it's only about 4 months old, and i havent used it much. it is a shark (model # v1310pt n

... Vacuums

Eureka Atlantis Rug shampooer wont **** up the water, how can I fix it. Thanks Dennee

Make sure that the two slide-tabs on the front of the machine are all the way down so that they can hold the front see-through cover down and create suction at the front. I did the same thing. you can tell when they get moved while cleaning because y ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

Shampooer the small ring screen that makes the subs basically wont stay in place. no matter what i try it keeps popping off

Hi,\015\012I suggest regular scotch tape or masking tape. Just take the screen out and cut a piece of tape into strips that are just wide enough to fit the outside of the screen ring without any excess. Put the tape strip(s) around the outside ... Kirby Ultimate G Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6223 seconds