Having problems with your Kirby G4 Bagged Upright Vacuum ?

Impeller installation i took the whole vacuum cleaner apart to replace the impeller . i did not take note of the way the bushings need to be put on the shaft . do you know of a diagram out there that shows how to do this.


Answers :

Here is my online guide to changing the fan. Hope it helps...
\015\012
\015\012http://reviews.ebay.com/KIRBY-VACUUM-REPAIR-HOW-TO-REPLACE-THE-FAN-IMPELLER_W0QQugidZ10000000003711302
\015\012
\015\012Marci
Repair Help & Product Troubleshooting for Kirby G4 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Impeller installation i took the whole vacuum cleaner apart to replace the impeller . i did not take note of the way the bushings need to be put on the shaft . do you know of a diagram out there that shows how to do this.


Here is my online guide to changing the fan. Hope it helps...\015\012\015\012http://reviews.e ... Kirby G4 Bagged Upright Vacuum

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm


I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

It's been awhile since I have used my shampoo system on my Ultimate G series Kirby. Well, as instructed I took it apart and cleaned it. Now I can?t figure out where to put the ?screen cap? and ?sponge filter?. I have my manual in front of me and the only place it shows the filter and sponge (page 35 in the manual) is when it?s been taken apart to clean. It doesn?t show where to put it back. I don?t know what I would do without all the pictures in the Kirby manual. HELP! Thanx. Visual Kirby Vacuu


Hello,\015\012The littlew round screen goes in the hole where the hose attaches to the tank. The round foam filter goes up in the hole underneath the on/off valve for the foam. Here is a guide if you need any more help...\015\012\01 ... Kirby G6 Bagged Upright Vacuum

I need to know how to put together a Hoover Slider vaccum. I had to take it apart and now i need to put it back together.


... Hoover S2105 Slider Bagless Stick Vacuum

I need to know how to put on the vacuum cleaner


Remove the brush bar. Then link the belt onto the motor spindle. Then insert the brush bar into the belt and snap it back into the vacuum chassis. ... Vacuums

Need a bushing for motor shaft and new brush


... Bissell 2050 QuickSteamer Upright Vacuum

Cleaning Solution It really isn't a mechanical problem. I would like to know what kind of solution I need to put into my machine. I bought it used and if didn't have a manual and I can't recall what I was told to put into the machine. I hope someone can answer my question. Thank you in advance Phyllis Woodall.


Most any brand name carpet cleaning solution will work. I like ZEP from the Home Depot. Nice fragrance, low foam and economical vs. Bissell, Hoover, other appliance brand names. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Grandchild screwed tension knob completely off my Rica 1570 sewing machine..., and sprin g and discs are off and don't know how to put it back together....need to know order they go on spindle


Howdy, I was able to find this manual:http://www.riccar.com/ftp/whitepapers/1570-6950-bl2800-695.pdf \015\012\015\012I did not see the exploded view, though, there is a picture of the assembles tensioner, which may help some. sorry I coul ... Vacuums

D.d vaccum i have a dirt devil dynamite...i bought a new for it i put it on and not even 1 minute of using it the belt broke again!!!!i dont know whats going on do i have 2 put it on a certain way does it need grease or what!


Did you check the brush roll, if the ends aren't turning freely, then it needs to be replaced also. ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

I need to know if roller brush is supposed to turn it doesn't if it needs a belt pleasr show diagram or video how to change


... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I need to know what compartments to put the water in, and to put the cleaning solution in.


Hi There,The Larger compartment is for the clean water, and the secondary tank attached to the larger tank in the back of it is where the shampoo goes. This machine is handy as it will automatically mix the two solution tanks together f ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Car dies when u put it in gear but u can drive it but when u go to stop it will die it is a 1992 chevy camaro rs 350 throttle body with brake booster vacum un done it will sit and idle with it on it will idle for about 3 mins. but with it off it will still die when u put it in gear what do i need to do john henry sparta tnn. 38583 (931)808-3624 cell phone i have tried everything i know to do ????????


Go to autozone and buy you 2 bottles of heat and put it in the gas tank.it sounds like you have built up some condensation in you tank an its pumpimg the water thats accumulated in you gas tank.put the 2 bottles in the gas and it will dry up the wate ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I need to replace a belt on the shark infinity pet care system upright vacuum. I have the belt I need a manual to show me how to put it on


... Euro-Pro NV31 Infinity Vacuum

I need to know how to put bissell proheat 2x back together


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I need instruction manuel for bissell pro heat 8910 steam cleaner i do not know how to put the belts back on


Water don't come out ... Bissell 8910 ProHeat Clear View Upright Vacuum

Need video or large diagram instructions for what to put together


Before using steam mop, vacuum up or run dust mop over floors to release all loose dust and debris. Notice if anything like tar or stuck on food that sticks up a bit from floor and remove. (The stea, mop can clean surface drips but not something tha ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Does anyone know where I can get a motor bearing for the 3595 upright vacuum. Called Bissell and they say I have to be an authorized dealer to get "internal" parts and called their "authorozed dealer" and they told me they cannot get the part and I needed a new motor...ridiculous! Anyone put a bearing on these and if so where did you get it from?


Bought the whole motor assembly for mine, no bearing only part available. THis vacuum now headed for its third motor. " $45 dollars is still cheaper than a new vacuum". That's what I said the first time... ... Bissell CleanView 3596 Bagless Upright Vacuum

Need to know how to put belts back on rollerpart proheat 2x bissell


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

I put boing water in my water tank for my bissel quick steamer it does not want work right any more i need to know how much would it cost for a new water tank, and how i might be able to order one, as well as a free manual


Hi and welcome to FixYa. I am Kelly \015\012\015\012Here are all the parts for your machine. \015\012Click on "read more" for price details \015\012\015\012 ... Bissell 8930M Upright Steam Cleaner

I have a american water heater which we put in lp gas valve now we need to know what size main burner jet for 75000btu on lp


Was the old gas valve natural gas or is the heater brand new that has to be changed over to lp from natural gas? If it is new most hat water tanks come with the proper pilot orfice and burner orfices for the hot water tank. ... Vacuums

I need to know how to put my belt back on my kirby 2000 G6 vacuum belt


Greetings from GoVacuum,\015\012\015\012Here's a very informative video that we've recorded explaining in detail how to correctly install the belt on your Kirby Generation vacuum cleaner. I hope this will help you.\015\012\0 ... Kirby G6 Bagged Upright Vacuum

Oreck vaccum when i put a new belt on, the belt rubs the side of the wall of the vacuum gets real hot and busts. is there any type of washer fitting that goes on the vacuum to hold the belt in place? i dont know i need help thank you. you can reach me at [email protected]


The belt must not be running true to the pulley. You may need a brush roll, but also check the motor to make sure it isn't moving inward after the belt is put on. ... Oreck XL Ultra Bagged Upright Vacuum

Need a manual to show me how to put on a belt. None of the pic


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a kenmore grab n go bagless and I need to know the exact size of the belt, I lost the manual, and I have burn several belts at the bigining of the problem the motor stops and burn the belts I open it and I think it was a little piece of plastic, that cause the problem, but when I put the new belt it looks like the motor works fine,but still burn the belt, I'm using UB-1 #5275 belt am I using the wrong one?


... Kenmore 34722 Grab-N-Go Upright Vacuum

Transmission adjustment I need to know how to put the arm back on and how to locate it


Http://www.greatvacs.com/Kirby%20Transmission%20Adj.shtml\015\012\015\012this is a link to a site with instructions for adjusting the ... Kirby G5 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0897 seconds