Having problems with your Kirby G5 Bagged Upright Vacuum ?

Smelly bag . How do I get it off?

\015 Smelly bag . How do I get it off?\015

Answers :

See tthe instructions how to install/ remove disposable bag:
\015\012http://www.goodvac.com/articles.asp?id=137#1.2.2
\015\012
\015\012If you need extra bags you can order them on our website
\015\012http://www.goodvac.com/
\015\012
\015\012Good Luck,
\015\012Rocky
Unzip the bag from the back and at the top of the plastic/rubber intake hose where it connects to the filter bag you should just have to twist it about 90 degrees or so and it will detach the filter bag. Then you place a new bag back on the intake tube and turn it the 90 degrees again, zip the bag back up and your ready to go. If you want to take it off the actual vac you twist the whole bag at the bottom where it connects to the vacuum on the outside and the "boot" looking part will come off.
Repair Help & Product Troubleshooting for Kirby G5 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Smelly bag . How do I get it off?


See tthe instructions how to install/ remove disposable bag:\015\012http://www.goodvac.com/articles.asp?id=137#1.2.2\015\012\015\012If yo ... Kirby G5 Bagged Upright Vacuum

Why am I getting a smell out of my Kirby when I am vacuuming, I have tried changing the bag thinking it was something to do with that, but even with the new bag I get the same horrible smell. Can you help please. Thank you.


If it is a burning rubber smell then that means that the belt needs to be changed. Here are the belts you need:Kirby Ultimate G Belts ... Kirby Ultimate G Bagged Upright Vacuum

I am getting very little suction from the motor. The hose is clear, the bag new. When I open the bag cover, plug the hose in and turn the vacuum on, there is next to no suction from the motor. What do you think is wrong? How do I remove the cord retractor to get to the two screws that hold the back of the canopy cover?


Your problem is probably is you don't have a proper seal in your chasis. A vacuum has to be sealed tight or the air will leak out and the seal broken. Check around the whole body after the bag is in and check for any airflow noise. I could help more ... Vacuums

How do I clean the bag? I loaned it to someone that had 4 dogs! Needless to say the bag was very dirty, full of dog hair and smells really bad. I emptied the bag out but still cannot get all the hair out and wondered about how to clean the bag. Can I wash it? Thanks so much, Cindy


Yes you can wash it if it is from textile material, hand wash it i recomand, but not to sure if u can get all the hair out, but at least it will smell nice.\015\012\015\012A new bag isnt't to expensive either, depends on the model.\015\012\015\ ... Vacuums

When removing the canister bag, the plate and spring that it slides into popped out. When I put them back in, the bag full indicator is completely red. It is a new bag and filters. I think I am not getting the plate and spring back in the canister correctly. Any instructions or pictures showing proper insertion and configuration of these? I looked in the manual and the part is only shown while bag being inserted.


... Miele S514 Solaris Bagged Canister Vacuum

Dirtbags Hi, I would like to know where can I buy dirt bags for my electrolux z4870. The number on the bag is E80 and I'm struggling to get hold of the bags. I live in Witbank Mpumalanga. Can you please help me and can you tell me if it is possible for me to buy the dirt bags direct from the factory. Regards Patricia


... Electrolux 4870 Bagged Vacuum

I have a windtunnel2,bag,upright, all the sudden stopped working.Its getting power, but something behind the bag clicks.. and nothing happens.


Jana, There's nothing behind the bag of the machine that should make a clicking sound at any time. As to why it stopped, there are several possibilities, including a faulty switch, motor, wiring, etc. I see you're in White Pigeon, my shop is jus ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I just notice when I went to change bag in my Kirby G4 that the whose inside was split open, which made all the dust fill up in the bag. How do I get a replacement part for this and what is that part called. Do I need to buy the whole outer bag?


You do not need a whole bag. The bag fill tube is replaceable. can be temp fixed with duct tape and new one installed at home. vacuum inside with another vac and you will be set to replace ... Kirby G4 Bagged Upright Vacuum

My Oreck is 10+ years old. The bag will not remain on the opening of the handle inside the bag. Dust goes into the cover rather than in the bag getting in the zipper which makes it very difficult to unzip the cover. Any suggestions?


Check and make sure bag collar is behind the two lips. if it isn't it will leak dust and make it hard to open. ... Oreck XL Ultra Bagged Upright Vacuum

I have a HSCU800B upright. The bag slipped off and the contents is inside all over the cloth bag. I need to remove the outer cloth bag in order to get it clean. How can I do that?


... Hoover Vacuums

Hi, I have a Dirt Devil Model # M08100REDC. I desperately need to change the bag, but I don't see an obvious way to do it. I'm afraid to try pulling on the cloth tab thingy that's just below the handle, between the rubber ring that holds the bag on the vac, because it seems like stuff will fly everywhere from the force required to remove it, and I might not be able to get it back on there. Should I just pull on that cloth tab until the bag comes off? Thanks, Roberta


You can pull on the tab to remove the bag, but probably a better way is to gently pull on the rubber ring that attaches the bag to the back of the vacuum body. If you don't yank and ****, it should come off without spilling the dirt. There may also b ... Dirt Devil Classic M08100 Bagged Handheld Vacuum

I have the Aerus Lux7000-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes. I changed the filter on the back and put in a new bag. Help please :)


Hi, you very likely have a defective control valve under the dial on top of\015\012the vac , or a kink or blockage in the tiny pressure hose that feeds\015\012the air from the throat of the vac or the back of the bag chamber\015\012against the two si ... Electrolux Guardian Bagged Canister Vacuum

I have the electrolux guardian-My full bag light indicater is coming on even with a new bag. It gets worst-the machine will cut off when I insert the hose or put my hand over the hole where the hose goes. I changed the filter on the back and put in a new bag. Help please :)


Hi,\015\012Check your hose you have something stuck in the hose...stretch it out straight and run something through it to push out whatever is stuck in there...\015\012\015\012heatman101 ... Electrolux Guardian Bagged Canister Vacuum

Can't get the covers off Electrolux Model C102G, acts as if bag is full, but bag is new and empty!


... Electrolux Vacuums

I went to change the bag on my eureka powermite 930a and the whole thing came off. I don't know how to get the part that holds the bag back on. Help!!


... Vacuums

I need to know where i can get i spring that holds the bag in place for eureka c2094g bag type f&g


Hi gina29_33547,If you are unable to locate a store in your vicinity which supplies spares, there are a number of wesites which do and they will gladly send the spring to you.There is one in particular that even supplies diagrams with an ... Eureka Vacuums

Bissell powerforce My lower pickup tube became clogged so I removed it and cleaned it out and reinstalled it.Now everything runs good but the vaccum want pick up any dirt .I replaced the bag andf when I turn it on it just exhaust air but does not have any suction,I tired tp pull the bag door of while it was running whick I could not do so it has plenty of suction inside just not getting any outside can you help?


... Bissell Vacuums

Where can i get the spring that holds the bag on on my eureka c2094g bag type f&g


In your owners manual there is a Customer Service number. Call that number and see if they have a spring for your unit. My mother-in-law has a Eureka bag upright. It's over thirty years old and still has the spring. What happened to yours that yo ... Vacuums

I put in a ne Kirby Bag and it still is not sucking up the dirt. The brush is turning but the bag does not seem to be getting any sucking snce it is not expanding


See if this helps:\015\012http://www.goodvac.com/kb_results.asp?ID=13\015\012\015\012Good Luck,\015\012Rocky ... Kirby Ultimate G Bagged Upright Vacuum

Hoover self propelled bagged windtunnel upright model #U6435-900...how do you remove the green plastic shell cover to get to the part that secures the v belt...we need to secure the bolt and cannot get the area. Brushes and transmission wheel not rotating? thanks


Greetings from GoVacuum,\015\012\015\012Here's a great video repair tutorial that we've put together to try and help you with the repair on your Hoover WindTunnel. I hope that this helps you with your repair. If you found this solution ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Wondering if the head is plugged up because it makes a sound like air is escaping somewhere. I've replaced the original cloth bag with a comparable "O" paper bag from Sears. I tried to see if there was a clog in the hose by placing a broom handle in the hose to see if something would loosen. I also cleaned the filter and the air filter. If the head is plugged, how can I fix it? We can't get the vacuum apart. Thanks.


I had this problem, but suction improved when the attachments were properly secured in their holders. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

When i change the bag, the indicator strip shows a full bag. Can't get full suction.


You have a clog, either in the hose, the dirt inlet by the brush roll, or the filters are clogged. ... Vacuums

I have 2 Hoover Wind Tunnel-self propelled bagged vacuums-U6433-900 model.The roller bar does not agitate, the self propelled feature does not work and, in general, the vacuum is not performing well. I have replaced the roller bar, the v belt and the wide belt. The filters have been replaced and it has a new bag. I have had both of these since 2004 and they were fairly expensive $200 each) but if the repairs are prohibitive, I might as well get new vacuums. Suggestions? I just spent $100 for bel


The Hoover WindTunnel self propelled is a machine that we see in our retail stores (Vacuums Unlimited) constantly. The benefit of having a supposed "self-propelled" machine wears of quickly after the numerous time you will need to take this machine ... Hoover Vacuums

Hoover tempo upright is clogged. I can only vac for a few minutes, then I have to unplug it and turn it over and clean out the under part under the roller. It is totally stuffed with dirt and dust and carpet fibers. I have a new bag in. It is like it is clogged up inbetween the bag and the roller. Also gets clogged when using the hose. It is maybe a year old. How can I take it apart and unclog it?


Disconnect the hose and head and wands. Drop a quarter thru the hose, the handle sometimes clogs. peer thru the wands and inspect the elbow on the head for blockage as well ... Vacuums

Kirby G3 I threw out my last bag for my kirby. I have an other model and now i dont know which type I need to get. I have 4 Style #2 bags but they are not the right ones... Help!


Beginning with the G series, G3 and G4 had round openings for the dirt intake. Prior models had oval so they will not fit, so find G3 or G4 bags and you will be set ... Kirby Generation 3 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0602 seconds