Having problems with your Kirby G6 Bagged Upright Vacuum ?

Plug in kirby vac to do the floors and it won't start.

Answers :

It could be the power cord or even the switch. I suggest taking it to an authorized Kirby repairshop and have it looked at. It could be something as simple the power switch
Repair Help & Product Troubleshooting for Kirby G6 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Plug in kirby vac to do the floors and it won't start.

It could be the power cord or even the switch. I suggest taking it to an authorized Kirby repairshop and have it looked at. It could be something as simple the power switch ... Kirby G6 Bagged Upright Vacuum

Kenmore canister model 116.25513506 wont turn on. when handle switch is turned to floor. vac motor does not turn on. When switch is turned to carpet, floor nozzle works but vac motor does not. I checked fuse, all o.k. checked continuity for plug, o.k. removed wires for bag full switch...motor wont run. I wired motor directly power cord...motor runs. Thinking it must be the circuit board, how do I bypass it or test it?

... Vacuums

Miele s4210 carina bagged vac,wont start,tried fuse in plug,ok,no click on switch ,should there be a click?

... Miele S4210 Carina Bagged Canister Vacuum

My Dyson animal seems to have an electrical issue that I am unable to pinpoint. Neither the wand nor the floor vac have any suction AT ALL. In fact the vac makes absolutely no sound and you wouldn't even know that it had power to it unless the rollers are turned on, the rollers work just fine. I had this problem start about a month ago and then it just started working again after messing with it for a while, now it has happened again and I am getting a little agitated! Please Help!!!!!!!!!!!

There is a filter inside the canister, and by your description it sounds like it needs to be cleaned. if you remove the filter and blow it out using a air compressor or using a slightly ridged brush and tapping the filter out this should solve your ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Ryobi 720r wont start. Absolutely no response at choke + engage lever. I checked the spark plug but no luck. Just test i put little gas in the spark plug chamber. It started only to burn what was in the chamber then stopped.

... Vacuums

NuTone CV353 Central Vac does not start when hose is plugged into

Try to plug the hose in sideways. So the top of the hose is rotated 90 degrees. If the unit turns on then there is something wrong with the hose. It might be a short or it could be a bad switch on the handle. If the unit still wont turn on I woul ... Broan-NuTone CV353 Central Vacuum

The kirby wont start no power

... Kirby G6 Bagged Upright Vacuum

Kirby Legend 2 wont start

... Kirby Vacuums

I have a kenmore upright model 116.36933 vac. motor wont stop unless i pull th plug the buttons work on everything else but stopping the vac

... Vacuums

My kirby wont start - Kirby Vacuums

Check the plug,then check the switch. ... Kirby Vacuums

Hi...my dyson cylinder vac,DC08will not start when plugged in and switched on...after working fine yesterday...have checked plug etc. Any ideas??? Thanks.

Hi its Darran at Dyson. If the machine had been left overnight and then would not switch on the next day, then this sounds as though there may be a problem with the switch or the motor. So that we can help you further, please ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

My kirby is shorting out when i plug it in and turn it on it wont turn on and then after a little bit it will turnon but twhen you move it it will turn back off.. and there were sparks from the cord.... i was wondering if i still have a warrant to get another one ive never had a problem with my kirby i love it but am dissapointed that i cant use it

... Kirby G5 Bagged Upright Vacuum

My Shark steam cleaner S3325 wont start. Only used it 2 times. when plugged in the start light should come on and go off when the ready light goes on. Instead the ready light goes on and there is no heat. Any suggestiins will be appreciated.Thank you, Mary A

... Euro-Pro S3325 Handheld Steam Vacuum

Kirby Sentria I just got done usting the carpet shampoo system and now my Kirby wont start

When you replace the outer bag assembly, you have to make sure that it is turned clockwise untill it fully stops. There is a small switch on body of the Kirby that is only engaged when the bag assembly is installed correctly ... Kirby Ultimate G Bagged Upright Vacuum

Hover windtunnel It will start when you plug it in and wont turn off with the switch you have to plug it in and unplug it to get it to work.

I had the same problem with the Hover windtunnel. All I had to do was remove the two screws holding on the handle and then pull the handle off pulling horizontal to the ground. Then I manually turned to swith off. Check it to make sure the switch ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Vac wont pull/**** anything while we try to vac floor,

Hello RonD30,\015\012If you are getting suction thru the hose and not from the bottom section.. you have a clog somewhere inline with the base area... If you have access to a shop vac ... unplug the Hoover, open up the base and remove the beate ... Hoover Vacuums

We have an Eureka The Boss Central Vac Model ACV2001B. When you plug in the vac the motor starts momentarily and then stops. What could be the problem? Thank you.

Most likely there is a short in the low voltage wiring in the hose. ... Vacuums

Kirby sentria wont start

... Vacuums

Kirby G3A Attempts to start but wont run

Http://www.ebay.com/gds/COMMON-PROBLEMS-WITH-THE-KIRBY-VACUUM-TROUBLESHOOTING-/10000000003800312/g.html ... Kirby Generation 3 Bagged Upright Vacuum

I bout this vacume in mid December 07 and about February-March it started not picking up the dust on the floor. So in early April I bout a new filter and it still wasn't picking up the way it had in the beginning. I've taken it a part several times and cleaned it out with it being plugged at the bottom hose with dust bunnies. Well I just took it back to Walmart where I purchased it and I failed to keep the reciet they could not do any thing about the sweeper. I went back to the sweepers and re

Pull the hose out of the holder, is there suction there. If not, then there is a clog in the hose. If there is suction, then check the dirt outlet by the brush roll. Also if the belt is slipping, it may appear to not have as much suction, belts wi ... Dirt Devil Vacuums

My kirby legend II started spitting out sparks near the foot plug. How can I fix it please? Thanks Candy

Depends where the sparks are spitting from.Unplug from the wall and try to detach the cord from the vac itself, where it plugs in. If there is a small hole burned in the side you will need to detach the entire cord from the handle where it clamps on ... Vacuums

Our Riccar SupraLite Upright Vac used to glide across the floor so easily, but now we have to push it pretty hard. This just recently started. What can be wrong?

Suggest you check the wheels to see if they are moving freely.\015\012Also check the beater brush to see that it is moving freely.\015\012Be sure the belt has not broken. If it has, replace with a new one.\015\012Also take the time to clean the beat ... Riccar 8955 Upright Vacuum

We have a 2001 Kirby G vacuum. The cleaning lady was using it in one room, then brought it to another room and plugged it into another receptacle. It wouldn't start. Naturally we tried other outlets on other circuits without success. Is a switch or motor demise this abrupt? Is it worth pursuing repair?

Hi,Such an abrupt fault is more than likely a very simple fault, such as a loose wire or damaged electrical cord or a faulty switch. I would most certainly check or have these components checked before purchasing a new machine. They should be r ... Vacuums

I cant get my kirby to blow out...bag is removed from seating...its plugged in...i attach the hose to the place where the bag goes, but it wont run

I did get it to work! It was a struggle, but It finally hit that hidden switch just right. The hose attaches to where the bag goes, and it just wouldnt seat properly. I suppose there might be some wear there on the hose end that twists in . ... Kirby Vacuums

I have a rebuilt Kirby Classic and it started smoking and now will not work. Even when it is plugged in and the on/off button is pressed it does not power on. Johanna

Get it fixed, it's 40 YEARS OLD! ... Kirby Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0762 seconds