Having problems with your Kirby Generation 3 Bagged Upright Vacuum ?

Kirby vaccuum the kirby wash cycle does not pull the soap back up after dispensing shampoo


Answers :

My guess is that the belt was not connected properly and the shampooer brush was not spinning.
Make sure that the brushes on the shampooer tray are spinning, that the belt is resting on the driveshaft. The suction alone will pull up some of the moisture but the brushes should be spinning to gently scrub the carpet and deposit any excess moisture into the tray.
Repair Help & Product Troubleshooting for Kirby Generation 3 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kirby vaccuum the kirby wash cycle does not pull the soap back up after dispensing shampoo


My guess is that the belt was not connected properly and the shampooer brush was not spinning. ... Kirby Generation 3 Bagged Upright Vacuum

Water does not dispense on wash cycle


This would be the soap/ water valve. it is stuck closed or isn't opened.( no cure for an non-opened valve, just replace.) ... Hoover F7220900 SteamVac V2 Upright Vacuum

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not


Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Royal MRY7910 not dispensing water or soap? - Royal Vacuums Royal Procision MRY7910 Carpet Injector Vacuum Extractor, Shampoo Soap Dispenser, Brush On Off, Rinse, Finger Control, 8Hose, UphTool, 32Cord 7A 5YR


... Royal Vacuums Royal Procision MRY7910 Carpet Injector Vacuum Extractor, Shampoo Soap Dispenser, Brush On Off, Rinse, Finger Control, 8Hose, UphTool, 32Cord 7A 5YR

I have a new Hoover Dual V steam vac that I bought from a neighbor who only used it once. I have only used it once since then and it worked great. This time, because I am pregnant, I bought some non-toxic cleaner that was much thicker than the very watery Hoover soap. This vac has a wash option and a rinse option. The rinse option works (sprays and sucks properly), but the wash cycle doesn't at all-neither soap nor water comes out. Nothing comes out, but it still sucks. I took everything o


There's a powerful electric motor attached to a fan that sucks in air.Did you checked and cleaned that motor.If the dirt is got stuck up ion the motor then the motor will not spin as per its regular speed.For rinsing the motor spin on one cycl ... Vacuums

It's been awhile since I have used my shampoo system on my Ultimate G series Kirby. Well, as instructed I took it apart and cleaned it. Now I can?t figure out where to put the ?screen cap? and ?sponge filter?. I have my manual in front of me and the only place it shows the filter and sponge (page 35 in the manual) is when it?s been taken apart to clean. It doesn?t show where to put it back. I don?t know what I would do without all the pictures in the Kirby manual. HELP! Thanx. Visual Kirby Vacuu


Hello,\015\012The littlew round screen goes in the hole where the hose attaches to the tank. The round foam filter goes up in the hole underneath the on/off valve for the foam. Here is a guide if you need any more help...\015\012\01 ... Kirby G6 Bagged Upright Vacuum

For the first time, I tried using my Kirby Sentria shampoo attachment. I've lost the manual but found instructions online for making the swap from regular vac to shampoo-er and got it all assembled. The foam laid down just fine, however, when I run the vac back over the foam to pick it up, there is not a stitch of water showing up in the tray. First I thought maybe it was bc I hadn't put that much of the foam/water onto the carpet, but 12 hours later, the carpet is still wet in spots. Clearly


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=638285\015\012Generic problem for all Vacuums\015\012For the first time, I\015\012Posted by MHicks on J ... Vacuums

Can I use the kirby heriatge II shampoo attachments with the kirby heritage vaccuum?


You should be able to. There's not enough difference in the Heritage models to make them incompatible. ... Kirby Heritage II Vacuum

NOTHING WORKS Used the unit 3 1/2 weeks ago, now it will not do anything except turn on. The water and shampoo will not dispense and the brushes will not turn. Is there some type of reset button that can be utilized????????? Have had unit for several years with only one other problem, the soap dispenser had to be replaced because it leaked. Teresa


Check the foam filter on the underside of the recovery tank lid, make sure that it has at least a 1/4 in. gap from the top. There also is a filter, from the bottom, it has a red frame, pull out far enough to clean it.\015\012On the bottom of t ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Kirby shampooer - G4 - hardly used any water from the tank and no suds at all. Pet hair did blow out of the small slotted holes in the tray as I moved the shampooer back and forth, but the carpet was basically dry. I did vacuum before shampooing, so the brush part seemed to work great during shampooing, but no water! The small screen was stuck in the crook of the hose that attached to the tank so I did get that out and put it on the small hole on the tank, but it didn't make any difference. I


Few things:Make sure the sponge and the valve under the sponge (water tank) is clean.Make sure you follow the instructions (f you do not have the manual you can find one ... Kirby Ultimate G Bagged Upright Vacuum

How do I detach the cloth bag from my Kirby G3 Vaccuum to wash it


I would clean the bag by blowing it out with compressed air (lightly). If you do wash it, do it by hand in room temp water and air dry. I'm not too sure how to remove the whole bag on that model. You should call your local vacuum dealer to inquire, ... Kirby Generation 3 Bagged Upright Vacuum

Detergent dispenser does not open in wash cycle


Mght have a lot of dried up sop in it preventing it from opening.clean the dispenser out real good.please leave feedback ... Eureka Whirlwind 4388 Bagless Upright Cyclonic Vacuum

Kirby Shampoo system not dispensing foam


Few possible causes1. Valve under the sponge (water tank) is clogged. Replacement HERE.2. Tray is now lo ... Kirby Ultimate G Bagged Upright Vacuum

Shampoo will not dispense out of the bottle in back of Bissell rug shampooer


\015\012This could be the pump that is broken or it could be that the soap line is plugged or has been disconnected somehow.The other thing is that the button that you push to extract the soap may be faulty. ... Bissell Vacuums

Brush turning slowly while shampooing. It starts out fast, but after a minute or 2 the brush is not spinning very fast. I have powered it off and let it cool down. I just started out so I can't believe the engine is over heating, just doing 2 rooms, can't even get through the first room. If I take the brush attachment off, then put it back on and then turn it on, it spins fast, but after a a few minutes, it's spinning softly/slowly again. Kirby diamond edition


Track not set properly in grooves\015\012there could be a clog or the cleaner has built in feature to slow down heads for better cleaning this does it on its own ... Vacuums

My shampooer is fairly new (less than a year old) and I have only use it a couple of times. Yesterday when I went to shampoo my carpet it dispensed the soap but it wouldn't draw up the dirty water into the reservoir. Also the brushes are not moving. I cleaned out the filter and looked for debris but found none. What can I do?


Is it still under waranty? ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a kirby sentria and after I shampoo'd the carpets I put it back together to be a regular vacuum and now it wont turn on. Any ideas what could be wrong?


The only thing I can think of is the brush head is not on properly.If the head is not aligned right,then the saftey switch wont be activated.Otherwise,I'd say the saftey switch or power switch.Did you make sure not to run over the cord? ... Vacuums

I have kirby and it dispense shmpoo but doesnt take it or clean it back


Follow this manual step by step and you should be able to fix the issue....\015\012\015\012 ... Kirby Generation 3 Bagged Upright Vacuum

I have a very old kirby generation 3 unit that converst to a carpet shampooer. I was attemtping to shampoo the carpets but it does not seem to be picking any of the water back up out of the carpet. What am I missing?


Make sure the belt on the carpet shampoo aggitator is good, (could be stretched or broken) recommend replacing that belt. also make sure your fan in the front of the machine doesnt have any chips or cracks around the center. (this will cause lower su ... Vacuums

My hoover spin scrub machine has stopped scrubbing. It still dispenses and pulls up the water, but the brushes don't move. I've checked the on off button for brush control and cycled it to off and back on, but no movement out of the brushes.


There is a filter on the front right hand side of my F5871-900 Hoover. If you remove the plastic covering and clean that filter (wet finger may do), you're Hoover will begin spinning again! ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Model No. D-37272-100 when I have the brushes off the scrubber, they turn very easily, but once I mount them back in place, and turn the scrubber on the brushes won't move But the machine runs in wash and rinse cycle. WHY??


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

No water/cleaning solution comes out on wash cycle


With this model, the soap dispensed is controlled by electric solenoids. these can be tricky to troubleshoot. I would take it to your nearest dealer. these solenoids fail, and cause a variety of symptoms. ... Hoover F7220900 SteamVac V2 Upright Vacuum

Need a cheaper alternative shampoo for kirby vacuum system. Has to be an encapsulating shampoo. Kirby shampoo is too dear and only does one room per bottle. Need to know where to get some in australia as the postage from america is 3 times the price of the shampoo. thanks


Look up your local janitoral supply companies in the yellow pages. Encapsulation shampoo should be readily available in AU. \015\012\015\012Here is a list of websites to check out: \015\012\015\012 ... Kirby G4 Bagged Upright Vacuum

Rainbow shampooer The soap dispenser on my Rainbow is not dispensing soap when I flip the switch to 'soap' mode. All connections are intact. All plastic hoses are intact. What do you think is going on? The soap bottle connects to a little straw that appears to be free of obstruction, however, it connects into a sealed casing on the hose.


The little "wash/rinse" switch on some of the Aquamate units shuts off the soap flow by kinking the tube inside the housing. If you leave the switch in the rinse position (therefore, kinked) when you're done using it, it may dry in the kinked positi ... Rainbow E series Canister Wet/Dry Vacuum

Kirby shampooer dispensing - NOT a filter problem


I had the same problem and I called my local Kirby guy, he's great, helped me when I thought I blew my kirby up, it was just a cord and he wa able to tell me that over the phone. When I called him with this problem, he knew right away that it was on ... Kirby Ultimate G Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0709 seconds