Having problems with your Kirby Generation 3 Bagged Upright Vacuum ?

Generation 3 light

\015 Belt light, motor noise\015

Answers :

Need more info about fault !
Repair Help & Product Troubleshooting for Kirby Generation 3 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Steam won't build up and main generator switch doesn't light up. however,accessory switch light is on

Sounds like the heating element has burnt out ... Polti Vaporetto 2400 Canister Steam Vacuum

Generation 3 light

Need more info about fault ! ... Kirby Generation 3 Bagged Upright Vacuum

My Hoover Deluxe Hand/mop steam cleaner (H1005) is not working. The light comes on and you can hear the steam generating but nothing comes out of the nozzle. Do you have a solution for me?

... Oreck Sanapathic DMS2000 Handheld Steam Vacuum

I have a coleman mach central system that works of of my generator, but not shore power, ther is 120 volts at the plug. the green light on control panel flashes 4 times break, and 4 more times . The

1) test the power cord for break or ope2)see if the c.breaker are tripped or blown fuse3) see the vacuum has reset switch do it4) Power button defective or open 5) switch inside defective or open repair or replace6) Motor defectiv ... Vacuums

When pluged, in the unit turns on ( green light illuminates ) and feels warm. Yes, I filled the water container. The unit does not generate any steam. For some reason, I do not have an "operation manual" --- but it doesn't seem to be all that complicated! Have left it plugged in for 25 minutes. A small amount of water came out while just sitting. Then another small amount of water comes out when I push the handle in. I will assume that steam should come out when I push the handle in. Well, it do

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Andorra collection, withcommand system 2000 wall control. Light will not turn off by light switch, when light switch is depress light blinks is it the wall switch or the light?

I searched under the following search terms and did not find it on the Internet:\015\012'andorra collection withcommand system 2000 light control'\015\012\015\012and found:\015\012\015\012 ... Vacuums

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I

The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

I have a Kenmore Progressive upright model 216-37100800. It is only around 1.5 years old. My wife said that one day after she plugged it and turned it on, it whirred up but then shut off. Since then it will not start. I have noticed that right after I plug it in, if I try to turn it on, the first yellow light in the series of dirt sensor lights turns on then shuts off. After that the light will not light up on pressing the power button, unless I unplug it and plug it back in again. I have seen o

... Kenmore 25512/ 25513 Progressive Canister Vacuum

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi

Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

I have a clarke bench grinder model 1002. I have a light that I would like to attach into the wiring though the grinder wiring in it's base. The light has two wires, and the grinder has a ground that is grounded to the base, a black that goes to a switch then to the motor. The white goes directly to the motor. where would I have to splice in the two wires from the light? I have a switch that I would like to put in for the light on off also.

Attach the white wire on your lamp to the white wire on the grinder.\012Attache the black wire on your lamp to the black wire on the motor side of the switch.\012This will give the lamp power any time the grinder is turned on.\012Yo ... Vacuums

I have a Casa Blanca Intelitouch ceiling fan. Panama5 12004T model no.?? serial no.: AU16550 A casa blanca tri-switch on the wall: lights-fan-power When I turn it on, the lights and fan work fine. After a period of time, the lights go off by themselves. I don't remember the fan ever going off by itself, only the lights.

The light are going off only because after a period of time the circuit lets off the trigger on the switching thyristor. So the fault is within the control box of the unit which must be taken out to confirm.\015\012Now attempt to do the job onl ... Vacuums

Confusion and embarrasement have caused me to appeal for expert advice. I need to add a second flourescent light fitting in the loft. I recently added one from the existing wiring circuit via junction box and pull chord switch and it works fine. I have wired in the second light and now neither of them work. I have replaced the starter (as I had a faulty one in the first light. But i annot get them to work. I have installed a second junction box for the second light and wired all like terminals

... Vacuums

I have a Propress 2500 series steam cleaner which requires a heating element. It stopped working during a small steaming session. I notice now that with sufficient water in the cylinder both lights come on, the on light and the low water light , the second light remains on all the time. Can you help.

... Vacuums

When i turn on the vacuum it shuts right off. the speckled bag light is on (2 lights under the plug light)

Im going to guess you have an Electrolux Tank. the control valve inside probably went bad. normally i just disconnect it. Do no try to take it apart if you don't know what your doing. take it to a vacuum shop. ... Electrolux Vacuums

Bosch sensixx 25l is not working. green steam light is not coming on!

... Vacuums

I have a light ballast that stopped working. The lights around this one bulb still work but changing the light bulb did not fix the problem. Any idea what is going on here?

The ballast is like a fuse and the ballast is blown .\015\012you will need to replace the ballast as it will let current thru for some bulbs but not enough to light them all up.\015\012also if you use old bulbs that are alomst blown and n ... Vacuums

Euro-pro iron. red light on. green light blinks on but iron will not heat up. lights do not progress through yellow (does not go past green) purchased from walmart with warranty extention on 12/08. Never had a problem before--what is wrong.

The inner grid that heats up the iron has an open which will not give continuity to heat the iron up. These grids are not serviced so more than likely a replacement iron will be on your list to purchase ... Vacuums

The unit is charged, the charge indicator light is green, and the three lights on the top are lighted and steady but nothing happens. What am I doing wrong?

Press each cycle button and see if it starts up. I don't know if this is new and you just got it, but if so, you may need to remove any straps and retainers blocking the brushes etc. ... iRobot 4150 Roomba Vacuum

I have a 2 fluorescent light fixture in my bathroom. The right side light quit working. I took the starter out of the left side and put it in the right and it worked. Starter, right? I bought a package of 2 Leviton starters FS 2 15w. They didn't work. Thinking bad, I returned it for another package. Still not working. The original starter is a Sylvania FS 2. Is it possible to have FOUR bad "new" starters? Do I need to replace it with the EXACT same starter? This light fixture is 38 years old. No

It is not likely that you had 4 bad starters.I assume you have more modern lights in it too(not 30 yrs old).Here is a link to Sylvania.It may be just that it requires certain something(who knows what)that only Sylvania has.It seems strange because th ... Vacuums

After being on the charger for days and the green light is on I press the clean button. The Roomba leaves the charging unit and travels about 1 foot then the red light comes on and it beeps and won't do anything more the red light continues to pulse.

Buy a new battery ,the old one isn't holding a charge ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Charge light on roomba won't come on when charging. Light on charger is on and shows unit is docked, but no light comes on roomba red unit itself. Is this a bad battery or problem with unit itself??

... iRobot Roomba Red 4100 Bagless Robotic Vacuum

Miele S5000 (revolution 5000) vacuum cleaner - How do I open the casing? When the power button on the handle is pressed the green power-level lights on the handle light, but the motor sounds like it gives a little 'jump' but nothing more. The orange power light on the body also dims. I assume the motor or fan is jammed, but I can't open the body to find out. I've taken out to screws inside near either end of the handle, but to no apparent effect. I'm assuming the body is held together by plastic

... Vacuums

Warning Light What does the light mean on the canister that has two prongs on one end and one on the other. The vacuum works fine but the light is on. I changed the bag and filter.

Check the hose and wands for a clog. Usually that light means a full bag, but a clog or restriction will also cause it to come on. ... Electrolux Epic 6500 Vacuum

When I try and turn it on it comes on briefly but then immediately turns off. Also the plug light and 3rd light to the side of round knob light up.

Check the dial setting. It should be on either the smallest dot or the one next to the smallest dot on the dial. If it still cuts off,your valve assembly (full bag control) is probably the cause and needs to be replaced. The best thing for you to do ... Electrolux Epic 6500 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0366 seconds