Having problems with your Kirby Ultimate G Bagged Upright Vacuum ?

Won't **** the water back up, what is wrong?

\015 Everything seems to be attatched correctly , but I can't get the water to **** up into the tray? What can I do?\015

Answers :

Hello,
\015\012Either the height adjustment isn't on the lowest setting or the belt isn't on properly so that the brushroll will spin. Here is a guide to tell you how to properly get the belt connected. It is written for the main power nozzle, but should give you the basics because the shampooer head works the same way as far as the belt hook-up is concerned...
\015\012
\015\012 http://reviews.ebay.com/CHANGING-THE-BELT-ON-A-KIRBY-G3-G4-G5-GSIX-ULTIMATE-G_W0QQugidZ10000000003720039
\015\012
\015\012Hope this helps,
\015\012Marci
Repair Help & Product Troubleshooting for Kirby Ultimate G Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My steamvac wont pick up the water. it is spinning and blowing out the water, but it wont **** it back in


The most common reason for lack of pick-up is that the lid is not seated firmly on the recovery tank. Lack of pick up is always caused by an air leak. A less common possibility is that the large round rubber seal that the recovery tank sits on has fa ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Why wont my steamvac **** the water back up after shampooing


Go to page 16 off this link> http://hoover.com/file/605/ ... Vacuums

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?


That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

Won't **** the water back up, what is wrong?


Hello,\015\012Either the height adjustment isn't on the lowest setting or the belt isn't on properly so that the brushroll will spin. Here is a guide to tell you how to properly get the belt connected. It is written for the main power nozzle, b ... Kirby Ultimate G Bagged Upright Vacuum

Dirt devil vibe steam cleaner wont suck water back up


... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

I have a Bissell powergroom vacuum cleaner and i sucked water into it and now it wont even turn on what could be wrong with it??? It was a very expensive vacuum and i dont want it to be thrown out


... Vacuums

Hoover steamvac Model F5808 I took off the nozzle cover to clean out the hair and fuzz buildup and put it back on correctly. But now it won't **** up any water... what could be wrong?


... Vacuums

I have a kirby sentria and after I shampoo'd the carpets I put it back together to be a regular vacuum and now it wont turn on. Any ideas what could be wrong?


The only thing I can think of is the brush head is not on properly.If the head is not aligned right,then the saftey switch wont be activated.Otherwise,I'd say the saftey switch or power switch.Did you make sure not to run over the cord? ... Vacuums

Hoover F7431-900 my carpet shampooer/steam vac was working fine until the brushes at the bottom of it just miraculously stopped working. they wont spin at all. Is this a motor problem? perhaps a water flow problem? please write back if you can be of any help. thanks


If the screen is not dirty, and the flapper valve to the turbine inlet is open, then the problem is mostly a stuck turbine impeller. The turbine impeller on my F7431-900 has seized TWICE!! The shaft for the turbine is not made of stainless steel, t ... Hoover F7431-900 SteamVac Vacuum

II have the kirby sentria, i have it in canister mode with blower attachment on the hose is on with the hand sprayer attachment the problem is the foam is not coming out the sprayer used it just fine all day went to refill w/ water and cleaner now the foam wont come out whats wrong with it?


Make sure the "straw" is in.See if dust coming out of the hose did not clog the air passages. ... Kirby Heritage II Vacuum

I changed the hepafilter on my eseries Rainbow Vacuum cleaner, I rinsed it with water,put everything back and now it wont turn on.


Please dry the hapafilter before putting it back \012and then try switching on \012thank you \012with regards\012Trilok ... Vacuums

Wont **** dirty water back out of carpet and it has nothing to do with the lid not being on properly, just no suction...


Please check and see if the round gasket is on the round vacuum pipe under the hood, that contacts the dirty water tank. It should be a soft seal that touches the round open cylinder on the base of the dirty water tank. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Producing steam i just got the shark assembled the mv2010, then it is not doing anything, it vacuumed just fine, but when i put the steam pad on it wouldnt ever produce steam or do anything,it felt like the water was heating up but even after it sat for 20-30 minutes when i pull handle back towards me nothing happens, no lights no steam no nothing, so why wont it work


This link is for the manualhttp://www.sharkclean.com/manual/MV2010_11_IB_ENG_110103.pdf ... Shark MV2010 Vac-Then-Steam 2-in-1 Vacuum and Steam Mop Purple

I lent it out (NEVER AGAIN!) got it back and no water squirts out of it in front I looked at it with the cover off but it doesn't come all the way off anyhow nothing looks clogged the belt is all fine too. Clean all the grime is seen and still doesnt work. What's wrong?


It might be pet hair caught in its hose. You might have to disassemble everything just to be sure. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Hoover spin brush model f5914-900 wont draw water back out of carpet


Please remove the recovery tank and check and see there is a black rubber ring seal on the large vacuum tube that rises from the base to meet the bottom corner of the recovery tank. This rubber seal may have fallen off the tube and be found laying u ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Carpet cleaner, Bissell pro heat will release the water but will not **** it back into the the bas. Whats wrong with it


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My rainbow vacuum is spraying water out of the back by where the filter is. What is wrong with it??


Mine is too, would like to know why. ... Rainbow E series Canister Wet/Dry Vacuum

Lately we've been having plumbing problems to where our washing machine floods up our bath tub and toilet. And it happens while we have the washing machine on of course. Another problem is that whenever we are taking a shower our tub starts to clog up and water starts pouring out from the bottom of our toilet. We had a plumber come by to root out our pipes just last week and it was fine for about 3 days. And now the problem is back and driving me crazy. WHAT IS WRONG AND HOW CAN I FIX IT??


Possible tree roots best thing is to hire a plumber with a camera snake ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

My keurig platnium brewer is running slow like it clogged and its spitting the water back into the resivor rather than filling the coffee cup??? whats wrong??


... Vacuums

Bissel pro heat wont dispense any water


These pumps always fail. try to replace the pump. also check for clogs in the spray nozzles and tubes ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My bissel proheat 2x wont pick up the water


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My Bissell ProHeat 2x is pouring water out of the bottom anytime it's turned on. I had it in the shop for no water, took it back again for the same problem, took it back again because it had no suction, finally took it apart and found the problem with the suction and fixed it myself. Worked fine for a day and now it is constantly leaking water, if it's turned on, and is useless for anything except for making a mess.


Took the unit apart and discovered my heater had small pinholes in the metal and they had put in silicone, instead of a gasket, which didn't seal. So much for the place I took it to "saving" my heater for me. I repaired it myself by getting a few o ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Pickup water wont pickup the water after putting it down very little comes up into the tank .it worked fine when we baught it but after not useing it for some time it worked now it wont **** water up at all can anybody help.


The clear shroud covering the front of "hood" has two sheet metal type screws at the bottom in front of the brushes, these two screws also hold the little straight brushes ( one on each side) in place. I found one of these screws had broken it's plas ... Hoover F6020-900 SteamVac Upright Vacuum

Dear Sir: I just purchased a Bissell Rug Shampooer at a garage sale. The only thing I find for a model is on the back and it says Model 1695 there. Nothing on front. It is Navy blue and has a grey tank on it with a smaller one inserted at bottom of the large tank. It has two switches on the back of it and the trigger switch at the handle. The cleaner works, BUT, it does not extract any water back into the tank that is to pick up the dirty water. Could you suggest what I may look at t


... Bissell Vacuums

I have a george wet and dry (A26A), it wont pick up any water. the tube which goes from th lid into the water wont pick up water?


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0633 seconds