Having problems with your Kirby Vacuums ?

Green light is not on, wheels are not driving

Answers :

Could be more then one problem, cord may be bad, main switch is bad. Cords go bad more often then the switch, if you have an ohm meter, you can remove the core and check it to see if one side of it open, replace if it is is bad.
Repair Help & Product Troubleshooting for Kirby Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Green light is not on, wheels are not driving

Could be more then one problem, cord may be bad, main switch is bad. Cords go bad more often then the switch, if you have an ohm meter, you can remove the core and check it to see if one side of it open, replace if it is is bad. ... Kirby Vacuums

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.

How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

I have a Kenmore progressive bagless vacuum with direct drive that was working fine but then the Inteliclean Technology just stopped working. Lights stayed green even though it should of been red.

... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

We have a Eurolab XR210 Robotic Vacuum, it has stopped working. The fan will run, but the wheels do not drive, the UV light does not work, however, it will work in Docking mode. Can it be fixed?

... Vacuums

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I

The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

Euro-pro iron. red light on. green light blinks on but iron will not heat up. lights do not progress through yellow (does not go past green) purchased from walmart with warranty extention on 12/08. Never had a problem before--what is wrong.

The inner grid that heats up the iron has an open which will not give continuity to heat the iron up. These grids are not serviced so more than likely a replacement iron will be on your list to purchase ... Vacuums

Hi, we have a Sunbeam electric blanket model no. BLO750 and type 696. It's a double blanket with dual control that can be used for different settings on either side. Both sides have been working ok but last night one side wouldn't heat and the green light kept flashing and now, whatever we do the green light keeps flashing except, when we set the control to "off". We can't find our Owners Manual to see what we are doing wrong, can you help please...or can you advise us where we may be ab

... Sunbeam Vacuums

My braun 's 5510 charging light was blinking and never reach fully charged(steady green).I was able to use it as long as its pluged in. but now, no green light at all.and completly dead. is my battery dead ? or the charging circuitry bad ? i do have the skill to solder a pair of batteries on to it.

... Vacuums

How do I put the belt on the Kirby the correct way in order for the green light to come on? The green light indicates that the Kirby will pick up.

The G4 has a magnetic block on one end of the brush. It must be aligned on the LED end of the brush housing. ..with adjustment screws facing out. When setting the housing back in place use the pedal to lift the carpet nozzle up off the work surface ... Kirby G4 Bagged Upright Vacuum

My dyson DC05 has been playing up for a while. The motorhead would start fine with green light on and after a few minutes would stop and light would go green. then the power would go on and off - seemed to only work when I had the handle a certain way. Now no power at all. is there a way that I can check if its the power in the handle section as thats the only way you can turn this machine on? Thanks in advance

As the wires that control the motorhead run all the way down the hose it is a break in the wires you will need to buy the hose assy sorry its not thesort of thing you strip down and repair  ... Dyson DC05 Bagless Canister Cyclonic Vacuum

Dirt finder I have a Hoover U6439-900.  After the cleaner was used a few times, the dirt finder light cycles between green and red on the regular setting and will not go to green.  On the sensitive setting, the red light stays on most of the time.  I have tried to run the cleaner to remove any dirt but have not solved the problem.

The sensor may be bad, or it may be coated over with dirt. Re,ove the hose at the back of the vacuum, the head of the sensor is down inside that opening, reach in there and clean it off and see it that corrects the problem, if not replace the sensor ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?

That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

My Roomba ha sboth light flashing green at the home base station. It seems as if it will not take a charge when I manually docked it to the home base. Why is it flashing both green lights at the home base?

... Roomba Virtual Wall 3002 Vacuum

The needle on the pressure gauge of my whitewing steamer does not move even after half an hour to be on. The green light illuminates, and just for the first time it release steam, After that nothing happended even with the green light illuminated. What am I doing wrong?

... Vapor WhiteWing Steamer Canister Vacuum

On my kenmore central vac no power unplug unit plug it back green light comes on but try turning vac on green light goes off again .

Please clarify that we are talking about the central vac LED/switch panel panel and plugging it into a 110 V wall receptacle. If I understand when you unplug from the power source ,then plug back in the green LED comes on, looking normal ? But ... Easy Flo EF1400 Central System Vacuum

I have the IROBOT discovery that just got a new battery. IT ran great! As the battery was dying, I put it into the home base. The "brick" is green, the home base has two green lights and the on/off pulsates red. It never charges though. Eventually the red light stops pulsating. Customer service said to reset it, clean the metal, and nothing works! They told me to just buy another one. The problem is that I know it was working! Help!

The best thing that you can do is take the charger into somewhere that can test it for the proper output voltage. It should be somewhere very close to 22 volts with no fluctuation. The charger is the easiest thing to test in this case. ... iRobot Roomba 4210 Bagless Robotic Vacuum

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi

Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

Vax 612 Green pump light now orange after originally glowing green so what would cause this to happen?

... VAX Appliances Vacuums

Roomba pro elite change drive wheels

Just click the below link...ur pro will be solvehttp://www.wikihow.com/Fix-a-Vacuum-Cleanerthanks for using fixya...rate tis solut ... Roomba Pro Elite Bagless Robotic Vacuum

My irobot Dirt Dog won't go into a cleaning cycle. It is charged, but when i hit the clean button it does nothing. new battery installed a week ago. the LED lights under the "clean" button are flashing in sequence, "Green, Green+Red, Green". Then the sequence immediately stars over. Can someone help me?

Hi, A very common problem with the I robot is the wheels on the underside become clogged with dust and dirt. Turn the device over, and remove the bottom cover that is covering the wheels. At this time, remove the dirt and blockage from the wheels, an ... iRobot 1100 Dirt Dog Bagless Robotic Vacuum

After being on the charger for days and the green light is on I press the clean button. The Roomba leaves the charging unit and travels about 1 foot then the red light comes on and it beeps and won't do anything more the red light continues to pulse.

Buy a new battery ,the old one isn't holding a charge ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Miele S5000 (revolution 5000) vacuum cleaner - How do I open the casing? When the power button on the handle is pressed the green power-level lights on the handle light, but the motor sounds like it gives a little 'jump' but nothing more. The orange power light on the body also dims. I assume the motor or fan is jammed, but I can't open the body to find out. I've taken out to screws inside near either end of the handle, but to no apparent effect. I'm assuming the body is held together by plastic

... Vacuums

Ihave a Hoover Windtunnel self-propel model U6445-920. The belt from the drive motor to the big wheel will not run in the center of the wheel. The belt runs about 1/3 off the wheel. I have tried several new belts and still the same problem. What do I need to do to repair this problem.

The large wheel may be worn off center. If the belt stays on and is not thrown, you can run the vac. if there is wobble in the wheel causing a genuine belt to slide off replace the wheel mechanism. ... Vacuums

The unit is charged, the charge indicator light is green, and the three lights on the top are lighted and steady but nothing happens. What am I doing wrong?

Press each cycle button and see if it starts up. I don't know if this is new and you just got it, but if so, you may need to remove any straps and retainers blocking the brushes etc. ... iRobot 4150 Roomba Vacuum

My ez1 Monster Floor Steamer - green light goes off when I lower the handle and stops steaming

It could be calcium deposits in the tank. Clean it with white vinegar. Good luck! ... Euroflex Ez1 Monster Floor Steamer - Cleans & Sanitizes
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0407 seconds