Having problems with your LG Electronics Kompressor Pet Care Upright Vacuum Cleaner LUV200R ?

My LC vacumm won't spin

\015 The beater brush will not spin\015

Answers :

Repair Help & Product Troubleshooting for LG Electronics Kompressor Pet Care Upright Vacuum Cleaner LUV200R

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The bristles wont spin the belt seems in tact yet it wont spin


... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Spin brushes wont spin and the switch wont turn machine off. I have to unplug it. 


For the spin brushes it is most likely the motor is fried if you smell something burning it could be jammed or the wires have be shaken off the motor terminals. for it not turning off you need a new switch. ... Hoover F7431-900 SteamVac Vacuum

THE BRUSH WONT SPIN AND THE SOLUTION WONT COME OUT


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

DC07 brush wont spin on bottom, took all apart and wont work


Hithe belt is broken or stretched, replace it ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Why wont the brushes spin? I have had this machine for about 3 years and it has always worked great, tonight the brushes will not spin at all, it still sprays and sucks up the water. We took the brushes off and were able to spin them by hand


In this machine there is no belt. The brushes actually spin by vacuum and in the turbine assembly there is a small wheel bearign which rusts out. You will need to remove and repair or replace the turbine and gear assembly P/N should be 43191009 ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I cut all of the hair out of the bottom of the spin-brush on the Dyson Upright Animal Vacuum. Now I dont think I can get the brush back in there correctly. If I squeeze it in there (which it is a VERY tight fit...) then it wont spin. Any thoughts?


Check the roller ends for dirt build up, they pull off and you should be able to clean them out.\015\012The roller should just go back into place if pushed together. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a bissell pro heat and it wont dispense water. the little red thing wont spin and it looks like the belt doesn't move. within a few minutes you smell it getting hot.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

The flexible brush on my unit does not spin. It did 'by accident' pick up a cat poo that didnt make the litter tray while I was out, (and it happily spread it all over the house and skirting boards). I cleaned the unit, removed the base and wiped everything clean. I've unscrewed the flexible brush and cleaned underneath it but it still wont spin. Any suggestions?


... iRobot Roomba 530 Robotic Vacuum

The spin brush wont spin but the water is spraying out and sucking up


Possibly the brushes need cleaning http://www.hoover.com/pdfs/manuals/F5914900.pdf manual for your steamvac Press all four latches (B) and pull brushblock out. The brushes can be cleanedunder running waterGodbless ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Vacuum wont spin when on carpet but will spin if tilted off the carpet


Remove the bottom plate of the sweeper. Remove the sweeper brush roller and clean the end bearings of debris. Oil the bearings lightly with 3-1 oil or similar machine oil. Clean the motor shaft with alcohol as well as the brush drive area, and the in ... Bissell 3920 Bagless Upright Vacuum

My steamvac wont pick up the water. it is spinning and blowing out the water, but it wont **** it back in


The most common reason for lack of pick-up is that the lid is not seated firmly on the recovery tank. Lack of pick up is always caused by an air leak. A less common possibility is that the large round rubber seal that the recovery tank sits on has fa ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

My Hoover steam vac dual v's brushes will not spin and the square that the peg goes into wont spin either. There is suction but it is making a loud noise.


Sometime when the brush is not turning their are less resistance to the motor, so it will turn allot faster than normal. The turbine gear assembly which connected to the brush assembly probably broken, all the g ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Is there a way to stretch the hose ? when I use it the vacumm is right behind me and is hard to use.... it just wont extend unless the vacumm is held against something Thanks !


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My hoover spin brush steam vac brushes wont spin


Unplug vac turn it over and check for belts that drive the brushesThey are located at the very end of the brush They are probably missingor they snapped and sitting in the housing somewhere. If you ar mechanically inclined not very difficult ... Hoover Vacuums

Brush wont spin


Was the belt worn or broken? It probably needs to be replaced. Here is the belt you need:Dyson DC07 Belt ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Bissell powersteamer clearview model 8806-roller brush wont spin


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Brush wont spin, belt is perfect


It sounds like the motor that spins the beater brush is burned out,If it is under a yr old it should be covered by the manufacturer warretee. Find a Hoover service center that does warrentee repairs. ... Hoover U8188-900 Bagless Upright Vacuum

Beater brush wont spin for the hoover pet rewind


... Hoover WindTunnel Pet Rewind Upright Vacuum

Vacume. motor wont spin


Most likely the carbon brushes are burnt out and need replacing. However - I wish I knew how to put this politely - if you don't know enough about electric motors to have checked for this already, you may not know enough to do the job safely yourself ... Vacuums

Brushbar wont spin


If still under warranty, take advantage. The brush roller may have bound-up bearings on the ends--usually string, thread, and hair are the problem. Check the drive belt for wear or damage. Hope this helps! ... Dyson DC25 All Floors Bagless Upright Vacuum

The brush bar wont spin on my dyson dc 25... i


Hi its Darran at Dyson.Simply switch the machine off and stand it upright. Press the brush bar on/off switch once and then turn the machine back on. When you release the machine into the vacuuming position, the brush bar shoul ... Dyson Ball HEPA Upright Bagless Vacuum - Iron/Satin Yellow

Brush wont spin on my bissell 93z6


... Bissell Heavy-Duty Vacuum Cleaner, 93Z6

Dyson DC 28 brush bar wont spin


... Dyson DC28 Animal Upright Vacuum New DC 28 Animal

No suction power ,brush wont spin on carpet power nozzle. When it


You need to replace the belt that turns the brush. ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

The brush on my Dyson DC-14 wont spin


Hello, have you checked to make sure you have nothing wraped around the brushes ? also it sounds like your belt needs to be replaced. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0367 seconds