Having problems with your LG Vacuums ?

I have a brand new LGV200R vacuum sweeper.. from the very beginning it never will stay turned on.. it is brand new.. I have checked every thing in the book that says to and then some.. why wont it stay ON


Answers :

Repair Help & Product Troubleshooting for LG Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a brand new LGV200R vacuum sweeper.. from the very beginning it never will stay turned on.. it is brand new.. I have checked every thing in the book that says to and then some.. why wont it stay ON


... LG Vacuums

I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test


If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001

Hello good afternoon, i have a Royal Sovereign water dispenser with a little fridge on the bottom part and the problem i am having is that the dispenser wont release cold water and the fridge wont cool either. i would like to know is there any thing i can buy to fix it or do i have to buy a brand new dispenser! Thank you for your time!!


... Vacuums

Re UH70040W seriesZF12.0.I can't seem to get the brushroll agitater to work it just stays off and the brushroll does'nt work the belt that drives it wont grip the roll? It's brand new!


I followed the instructions,you have to release the handle as though you were vacuuming and it works automaticly you can't put it on ON when it's upright!! Duh ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Belt wont stay on Bissell cleanview bagless. Falls off within minutes after fixinging it- brand new belt. How do I fix this?


Make sure the roller turns freely with almost no resistance if not get a new roller. ... Bissell Vacuums

Hoover windtunnel t series belt is loose- roller brush doesnt turn. Its brand new belt is slipping. we bough new belts and putthem on same problem. Can not find solutio in manual. Is the belt supposed to go around the "metal pulley". I know it goes around the little metal motor thing, then thru the guide and around the brush. What is the metal pulley??? Is is the larger round silver thing between the guide and roller?


I also have a loose belt and have bought additional belts but have the same problem. I put the it around the metal rotor and around the brush roller a shown by he Hoover video, and it is loose. ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

My bissell brush band has come off and wont stay on thus the brush will not turn, there is also a black arm type thing on a spring inside (on both sides) on the pump belt side it has broken - the side where the brush belt is, help im searching for parts and a way to fix it but im getting no joy, incidentley the brush belt thickness looks way to thick for the small thickness for the brush belt cog (?) to stay on........am i missing something? so i need to get the arm thing replaced plus find a


... Bissell ProHeat Deep Cleaner Upright Vacuum

I have an eye vac professional that will not stay on to **** up the dirt. There is power to the outlet and the blue on/off light does stay on, but in Auto mode if I stick my hand near the dirt sensor it just pulses on and off. I can feel the suction, but it won't stay on. I've unplugged it, removed the dirt bin and filters and nothing works. Help!!!! This is brand new and I've only emptied the collection bin once and it hasn't worked since.


... Vacuums

Electrolux epic series 6000 sr model canister...we put a new bag in machine but it wont turn on and the light is on saying the bag is full and needs to be replaced...we tried the on-off switch several times but it wont turn on...why?


... Electrolux Vacuums

Lost suction I've only used this vacuum a few times, it's practically brand new. Now, one I turn it on, it sounds fine, and the hose feels as if it's getting some suction, but it's not strong enough to actually **** things up from the carpet into the canister. I have completely emptied the canister and bought a new filter. Nothing seems to help.


TOSS IT and forget it! I have never used a hand vac that worked that was worth the effort of turning it on .... I suggest they are all junk ... I found very few vacuum cleaners ... actually **** especially anything made by dirt devil ... I do have a ... Dirt Devil Vibe AllPurpose Hand Vacuum Bagless Vacuum

I have the original remote for a Lift Master 1050-6C. Just replaced the battery and I can't get the thing to work. Battery is brand new and I see the red light come on. Can anyone help me with this?


Make sure battery is in correctly, then re authorize the remote, the instruction are on the side of garage door opener motor ... Vacuums

I recently purchased a Hoover SteamVac to replace an old one because the brushes would not turn. I used it last week and then tried to use it last night and the same thing happened w/ the brand new model - the brushes won't. I've cleaned the brushed, the filter and everything else I can see. Can you help?


Those things are a waste of money you better off renting one. but the only thing i could think of is that something is stuck or your belt came off track ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Will stop running for no apparent reason. The light stays on and you can amp up the power to restart, but the problem is persistent. The book says to change the filters, which has been done.


Greetings from GoVacuum,\015\012\015\012This problem is caused by the static electricity which causes the hose controls to jump back down to the off setting. I have seen this issue on several Silver Moon and Blue Moon models before. ... Miele s558 Silver Moon Vacuum

My windsor sensor 12 inch vacuum is to hard to push. I bought a new one and its doing the same thing. My vacuum repair man says he cant fix the problem. My shoulders are sore from working so hard. Help


It\\'s possibly the type of carpet you\\'re using it on. The sensors use the brush speed and the amount of air flow to determine carpet height. Some berber, and tweeds make these things horrible to push. We sell sebo, who make the windsor and we\\'ve ... Windsor SR12 Sensor Bagged Upright Vacuum

Brand new electrolux range oven wont work, all that shows on display is F15


F15 means : signal lost between oven relay board & EOC(main computer board)\015\012\015\0121. Test the harness and connections from EOC connector P16 to oven relay board J2.2. Replace the oven relay board.3. Replace the ... Vacuums

Went to turn it on after not using for several weeks and it states not ready to brew like usual but after about four minutes it just turns off. Wont let us brew a cup or access the menu even to choose size of cup or anything. It sounds like it's sucking up water to make cup and pokes hole in the coffee but nothing more than that. It is almost brand new


You have posted the fault in the wrong column with no instruction of the make/model.\012Assuming it to be new , Is it passed the warranty period before we take a look ,?\012Just lave it on for sometime and see if there is any change. per ... Vacuums

Dewalt 2gallon corded/cordless vacume...unsed one time brand new wont turn on. motor and switch both tested and work...any ideas


Check the battery contacts... a common problem on this model. they are easily bent and prone to corrosion. ... Dewalt Cordless/Corded Wet/Dry Vac 2 Gallon Vacuum

Just properly installed a Hampton Bay ceiling fan - Midili, 44inch Model #44-MDL. Loaded the remote control with a 9 volt battery and the remote is EXTREMELY HOT. Changed out the battery with another brand and the same thing happened again. It is so hot you cannot even hold the remote! Help...! I want to use my new fan.


... Vacuums

I just purchased and electric percolator. I plug it in to see if it worked. It percolated but never shut off. The electric cord and pot look brand new. On the bottom it is stamped US patent 1999329 108-115 volts 425 watts. Percolator No 201. It says there is a fuse inside. Could this be the problem? I haven't used and electric percolator and do no t know what to expect.


The fuse would not be the problem as it would cause the percolator to not work at all.The patent expired in 2007 and wasn't renewed so the company is likely out of business meaning no parts.Is there a removable panel somewhere?If there is,would you o ... Vacuums

Roomba 4270 stops too soon. my roomba got weird all of a sudden. it started not moving all over as it should. so I tore it all down as I had done before and cleaned all the hair and dirt out of every thing I could without getting down to the basic shell. it does work now and does move all over but stops after about 10 minutes. brand new battery so not a battery issue. could I have plugged some of the sensors in the wrong 'plug'


... iRobot Roomba 560 Robotic Vacuum

I have a self propelled Royal Dirt Devil vacuum model number 087900 and it goes backward fine but forward has to be pushed so hard it's impossible. Is this a switch? Do you know about how much the part would cost and can it be done by a beginner. We fix a lot of things ourselves but we aren't mechanics by no means. We put a brand new belt on it. I don't think it can be put on backwards and brush turns fine. Where is the switch? Use layman's terms.


You might try a new belt and/or brush roll. The brush roll is what helps pull a vacuum forward, the power drive helps, but if the brush isn't turning like it should, then it will hinder forward motion. The belt may look ok, but they stretch to the ... Vacuums

My Roomba runs for a while and says error 2 to clean the brushes. This happens with cleaned brushes. And I have followed the instructoins. i have got a brand new set of brushes also. When inserting them the same problem continues. The floor is clean.


Remove the two round rings.....this has worked for me like a charm since! So glad to have the Roomba back up and running! ... iRobot Roomba 560 Robotic Vacuum

The unit works well for 3~4 minutes and then stops. Wait another 10 minutes to cool down and it works again but the same issue happens again and again. It is a brand new unit. I read the manual for the thermal detector and did what it says but the issue is not resolved. Thoughts?


Hi, I have a Hoover Bagless myself. I also have worked professionally fixing Vacuum Cleaners. There may be some material caught between the roller end and the end bearing or the edge of the roller compartment. This could b ... Hoover UH70015 Bagless Upright Cyclonic Vacuum

My Dyson DC44 is charging on the wall mount, and when I go to use it it wont run:( it has worked because its basically new. when i pull red trigger a green light comes on where it says max and on top.


... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My brand new Bissel pro heat allrounder wont spray any water out?


I would suggest RETURN it while still in warranty ! We were too bussy living, did not use machine while still in warranty - and now we are stuck. Same problem as yours. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0466 seconds