Having problems with your Lindhaus Healthcare Pro 14 Bagged Upright Vacuum ?

I have no suction on the Lindhause healthcare pro Hepa


Answers :

Make sure that the on switch is in the upright position. Down won't give you give you suction when vacuming.
\015\012
\015\012Make sure that the hose is securly in the lower part of the vacuum.
\015\012Test the hose with your hand before you put it back to see if you're getting air sucked in through hose. If not it must be clogged up somewhere. You might contact Lindhause home base.
Repair Help & Product Troubleshooting for Lindhaus Healthcare Pro 14 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have no suction on the Lindhause healthcare pro Hepa


Make sure that the on switch is in the upright position. Down won't give you give you suction when vacuming.\015\012\015\012Make sure that the hose is securly in the lower part of the vacuum.\015\012Test the hose with your hand befo ... Lindhaus Healthcare Pro 14 Bagged Upright Vacuum

Lindhaus HEPA 14 HealthCare Pro stopped working


... Lindhaus HEPA 14 HealthCare Pro Bagged Upright Vacuum

There is no suction in my vaccumm - Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum


CHECK LIST1. Full or clogged dust bag.\0122. Dirty air input filter.\0123. Wrong pile height setting.\0124. Open suction control.\0125. Hole in hose.\0126. Canister hood openthis link is for the manual ... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

Bissell Pro Tech Pro Steam Cleaner - no suction @ pump


Take a look at the Service Center Repair Manual (courtesy of Bissell New Zealand):http://newzealand.bissell.com/images/IncludeContent/Service_Center_Help/Upright_Deep_Cleaner_Repair_Guide.pdfThere's a (basic) diagnostic routine for ... Vacuums

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is ... Vacuums

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Mine does the same thing. There is no suction. I found that there is a door that opens when you tilt the handle in the down possition. I think there should be a spring in place so it can open. Until I find a replacement spring I have to open the door ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

I have a Eureka Contour model 2900 type A upright vacuum, the roller works fine nothing clogged, took it apart motor blade is free of debris, no suction from tube and blasts OUT air from the front HEPA filter location. New bag, New belt, nothing in hose.any clues as to why this can be happenning? Air should not be blasting out of the HEPA filter.


Even with your explanation,it seems the hose is clogged.Try taking the hose off,then blow through it or pour water through it.If this doesn't do it,make sure the suction canals are going to the proper areas. ... Eureka 2900A / 2901A Contour Bagged Upright Vacuum

How i fix my euro pro vacuum shark - Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum


... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

My electrolux oxygen cannister has the "bag change" light on when there is a new bag. The light stays on when the suction power is high (to pick up small particles) and it won't pick up, but the ight goes off when the suction power is low (to pick up big objects). I changed the hepa filter, cleaned the motor filter and changed bags, but all that didn't help.


You may have a clog in the hose, and/or the inlet by the brush roll. A clog will turn on that light as well as a full bag. ... Vacuums

Need bags for the euro pro x ep 238 - Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum


Needed bags for this vacuum and FINALLY found them at http://www.totalvac.com/parts/X10-3005.html?zmam=6843742& ... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

Proteam Pro force 1500xp Upright vacuum... When I switch to the carpet setting I have no suction power but the beater bar is turning. If I switch back to the floors setting, the suction is excellent. Wondering if the problem is in the on/off switch?


Just undo the screws on the front part of the switch assembly, carefully check all the leads to the switch. Mine slide off all the time as the switch is poorly designed and subject to damage when the darn thing tips over (easily!!!) new switches are ... Proteam ProForce® 1500XP Bagged Vacuum

My Electrolux guardian C135 vac has lost suction. replacing the bag does nothing. removing the HEPA filter has no effect - what do you suggest? Will a replacement HEPA filter make any significant difference?


No you have a clog in the hose, wand or at the power head. Remove the hose wand and power head from the the vacuum. Turn on the vacuum, put the palm of your hand over the hole in front, you should feel plunty of suction. Then replace just the hose an ... Electrolux Guardian Bagged Canister Vacuum

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

Hi my vacuum (Russell Hobss 2200 bagless HEPA) seems to have just enough ( not loads) of suction til it reaches the cleaning head. the head does not appear to be blocked - but there is then almost no suction at all. It also makes loads of noise when on- and an even louder noise when turning off. is it fixable or is it dead? Thanks


Generic problem for all Vacuums\015\012Hi my vacuum (Russell Hobss 2200 Bagless HEPA)\015\012Hi my vacuum (Russell Hobss 2200 Bagless HEPA) seems to have just enough (not loads) of suction til ... Vacuums

Hoover Windtunnel T-Series UH20700 9 mos old. Keeps clogging in hose just above the beater brush assembly. I think it clogs because the suction is too weak to pull much through. Primary filter is clean and HEPA filter is replaced. Even when everything is unclogged, suction is weak compared to another unit (same model) that a friend has. Any ideas?


... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

Can anyone help with an older Euro Pro EP055, It has very little suction.


... Euro-Pro EP055 Bagged Canister Vacuum

My Lindhaus Diamante 300 has great suction but clogs


Sounds like you have some form of an obstruction in the hose ( i once found a tooth pick sideways in mine) most models allow for the hose to be disconnected from the vaccum itself, also make sure theres not a setting for attachments also, some models ... Lindhaus Diamante 300 Upright Vacuum

Bissell pro heat 25A3 won't suction up water


... Bissell Pro Heat Deep Cleaner Model 25A3, 1 ea

No suction with Eureka Boss Pro Lightweight Bagless Upright, 411A


I checked the vacuum hose to see if there was a clog. 1st, disconnect the hose from the unit so you have access to both ends. Now, place a marble or other ball in one of the hose and see if it will make it all the way through. I found ... Eureka 411A Upright Vacuum

My bissel pro heat has no suction


... Bissell 25A3 Upright Vacuum

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK.


Sounds like a bad motor bearing. If it is, then you would have to replace it. Could be the brush roll, did you check the ends to make sure they turn easily? ... Vacuums

My hoover wind tunnel vaccum has a hepa filter that is supposed to be self cleaning but continues to plug up. it is not easy to get to and takes forever to clean it out so the suction is strong again.


Do you have the SELF-CLEANING, rotating HEPA filter? \015\012\015\012I just fixed my HEPA filter not rotating!! \015\012\015\012It involves taking apart the vacuum HEPA area. All screws are the same size. There are a LOT of ... Hoover U5444-900 5100 Wind Tunnel 15 Inch Wide Hepa Filter Bagged Black VacuumVacuum

Hoover Windtunnel is only cleaning (suction power) approx. 1/2 as powerful as it was when we purchased it approx. 4 years ago. I bought new Hepa filter and replaced the fileter on the side. I looked for possible build up of dust/dirt etc. and all channels are clear.


There is also a filter inside the drum fan, you didn't provide your model number, so i cannot tell you exactly how to remove it. ... Hoover Vacuums

Poor suction in electrolux theboss power 1300W and LG HEPA filter 1500W vaccum cleaner. have checked bags no problem. It doesn't pick up any dirt.


If the motor is truning perfectly without any strange noise,please their be an obstruction suction side ... Vacuums

I need instructions on replacing the belt that drives the brushes on a Bissell powersteamer pro deluxe carpet cleaner. Could the broken belt have anything to do with the suction of the cleaner?


Here is a link to the belts you need and a link to the manual:Bissell 1697-7 Manual and Replacement Belts ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0818 seconds