Having problems with your Lindhaus HEPA 14 HealthCare Pro Bagged Upright Vacuum ?

Lindhaus HEPA 14 HealthCare Pro stopped working

\015 The unit just stopped, no lights nothing.\015\012Unit was taken apart and cleaned and checked,\015\012nothing obvious. Is there a reset or thermal fuse?\015\012\015\012Thanks\015

Answers :

Repair Help & Product Troubleshooting for Lindhaus HEPA 14 HealthCare Pro Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lindhaus HEPA 14 HealthCare Pro stopped working


... Lindhaus HEPA 14 HealthCare Pro Bagged Upright Vacuum

I have no suction on the Lindhause healthcare pro Hepa


Make sure that the on switch is in the upright position. Down won't give you give you suction when vacuming.\015\012\015\012Make sure that the hose is securly in the lower part of the vacuum.\015\012Test the hose with your hand befo ... Lindhaus Healthcare Pro 14 Bagged Upright Vacuum

Bissell Pro heat stopped working


It sounds to me like you may have a bad brush and/or pump belt. Since you are having a simultaneous problem of the brushes not spinning, as well as the solution not spraying, this is the most logical explanation of your problem. Especially if ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Shark Euro-pro EP621 Bagless Upright Vacuum. Q regarding the brush not spinning / after troubleshooting and taking actions listed below, it now spinning for a few secs, but then stopping. Already removed hair, strings, etc. Checked that belt is aligned properly, checked that small wheel that turns belt is working (spins fine when belt removed. Oiled the turning parts a bit, that made it spin better, but still stops. It turns about 3-4 seconds then stops. If I switch it off and on again, I get ag


... Euro-Pro EP621 Bagless Upright Vacuum

Flightradar24 Pro stopped working


... Vacuums

Subject: Eureka Tru Hepa Wirlwind Amps Model 4383. Working fine then just stopped. Later worked fine again? What is/was the problem? Does it need a new filter?? also has the # 0108017529 on machine


I'm not sure all machines are the same, but many have thermal overloads on the motor that can only be reset upon cooling, so wait 30 minutes and try again.\012Secondly, my vac has 3 filters, one in the dust tray that you empty, one under where ... Eureka 7619AT Vacuum

Pro action vacuum stopped working whilst vacuuming


... Vacuums

Shark (Euro-pro) steam cleaner EP923I stopped working


Just tell you i had 2 shark there **** you cant find parts on them i just said trash bought bissel ... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

Z8220 STOPS WORKING HEPA FILTER LIGHT FLASHING & NEW FILTERS INSTALLED


Check your hose for a clog, id even check from where brushroll is at bottom to the end of hose. sounds like that could be your problem. ... Electrolux Vacuums

Hoover wind tunnel cyclonic with hepa filter just stop working. Model No U5781900. Had this item close to 2 years. Has the motor burnt out? My e-mail address is [email protected]


... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

My pro heat x2 is 14 months old I WAS JUST CLEANING WITH IT AND SMELT A BURNING SMELL THEN IT MADE A SMALL BANG AND STOPPED WORKING DO YOU THINK THIS CAN BE REPAIRED


If it still powers on then check the belt. ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Beater bar motor on Pro AQUA vacuum stopped working how do i fix it?


... Vacuums

We just used our bissell pro heat 25A3/64D9 series and the top half of the handle is not secure. Infact it flies off in my hand as im cleaning the carpet and it almost hit me in the face!!! It just connects to the lower half but there is nothing to keep it secure. If it is not tight the trigger to squirt water doesnt work and I am stopping and starting. It looks like a major design flaw.


I have a replacement pump belt for my Bissell #25A3/64D9\015\012but cannot find the instructions as to how to put a new one on. My son replaced the last belt, and of course he doesn't remember what he did. Is there any way you could please dire ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

The lights which tell you if you are going at the right speed on my Bissell PROHeat Pro-Tech have stopped working. Just wondering if this could be as simple as a bulb or more serious. Also, how do you remove the clear panel at the front for cleaning? Thanks


The clear view window is unscrewed with a philips screw driver on either side of the nosel opening (top) but make certain the handle is layed back so as to alleviate twisting off the clear view cover. There are six (6) screws that hold the top cove ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Kenmore Progressive canister model 116.27514700 Problem: Vacuum motor won't turn on. The power head operates, but nothing from the vacuum. Have checked all areas of airflow: hose, bag, motor filter and hepa filter. All are fine. Have checked and rechecked all electrical connections, all seem to be in working order. Vacuum hasn't run for a week or so, so it's not the thermal protector, unless it's defective. Vacuum was running fine last week. Didn't stop operating when using. Went to v


Hello! The culprit is the PCB Assembly; Part # KC86WBZR3000...Cost is $6.99. I would remove and inspect for burnt components, or broken wires...Then clean connections both male/female using an eraser, toothbrush and alcohol...Using a bright ... Vacuums

Ruro-Pro EP922H Stopped working when plugged in. There is no red or green light at all now.


... Euro-Pro EP922H Canister Steam Vacuum

My Bissell model 8910 pro heat will pump solution or water for like the first couple times you pull the trigger as you can see the mixture window spinning. After that it stops spinning and nothing else will come out until you turn the machine off, and restart. Then again same process works for a couple trigger pulls then quits.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

WAS WORKING, JUST STOPPED - Euro-Pro Shark SC-505 Handheld Steam Vacuum


Throw it away buy cheep bissel one wallmart for 50 bucks i had shark cant get parts for them ... Euro-Pro Shark SC-505 Handheld Steam Vacuum

My kenmore progressive true hepa that I just bought--the electric carpet attachment stopped working. Is there something I need to do? It appears to be plugged in properly.


Hi,These are the only possibilities that could make your kenmore not working.1)Check the cord bad at male prongs.2)Tripped circuitbreaker.3)Blown fuse.4)Loose hose electrical connectio ... Kenmore 25512/ 25513 Progressive Canister Vacuum

My bissell pro heat 2X has stopped dispensing water from the tank, the suction is working and it seems to be dispensing the detergent, so it is not rinsing or washing with water. I have cheaked to see if there is a blockage but that doesn't seem to be the problem...please help


I have a Proheat 2X and had the same problem. I tried the Water Rinse setting and found water came out and was suctioned properly, but on the Light Clean, Normal Clean, and Heavy Traffic settings, the unit failed to do anything. Problem may be with l ... Vacuums

Steam stopped working in my unit - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,Try bottled spring water...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...E ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

How do you reset an EIO Turbo 2400 W Duo Hepa. It just stopped working .... maybe because the bag wasn't emptied????


... EIO Vacuums

I have A BISSELL UPRIGHT STEAM PRO HEAT AND IT JUST STOPPED SUCKING I TOOK APART AND CLEANED EVERYTHING CHECKED THE HOSES FOR CLOGS AND IT STILL WONT WORK


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Our Kenmore Elegance Hepa Filter vacuum has just suddenly stopped working, bag was full, changed it and now no power.


... Kenmore Vacuums

Dirt devil stopped working - Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum


... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0714 seconds