Having problems with your M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum ?

No suction from wall outlet. Power to powerhead. Breaker has not been tripped. Manual mode works on cannister in garage. AirVac VM458.


Answers :

I had the same exact problem and it took about 4 months to find out the problem. I had a paper clip stuck to one of the orifice in the hall way of my house and that is what I had experienced. The other thing is to check the entire tube system because maybe a mouse or rat has chewed into it. It has all to do with the electrical wire throughout the system. Good Luck
Repair Help & Product Troubleshooting for M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No suction from wall outlet. Power to powerhead. Breaker has not been tripped. Manual mode works on cannister in garage. AirVac VM458.


I had the same exact problem and it took about 4 months to find out the problem. I had a paper clip stuck to one of the orifice in the hall way of my house and that is what I had experienced. The other thing is to check the entire tube system becau ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

How can I get my Hampton Bay Exterior Motion Sensor Wall Lantern Light to stay on for 2 to 6 minutes. The motion sensor only works on the test mode. I want it to work when I move the selector switch to 2 or 6 minutes on High sensetivity


... Vacuums

I was vacuuming and the power abruptly stopped working. The plug had slightly slid out of the wall socket, but when I put it back in, it wouldn't power up again. The wall socket is working for other appliances.


The first thing to suspect is that the wall plug on the vacuum cleaner is defective, to confirm this you will need to access the on/off switch on the vacuum, there will be three wires coming to the switch from the cord ... Hoover S1361 Bagged Canister Vacuum

Suction only works using the hand held mode, there is no suction when try to use on carpet mode,


There must be a clog in either the hose, dirt inland by the brush roll, or bad filters. If you have suction at the end of the hose, then look lower all the way to the brush roll. ... Vacuums

We have a dyson dc 07 animal the machine was working fine then switched off after returning to the machine minutes later it wouldnt switch on, i removed on off switch cover and used a short piece of wire across the brown wires flicked the wall switch and it worked, aha i thought faulty switch aquired a new one to no avail and now even the short piece of wire trick doesnt work, has the motor died do you think, it wasnt over heating or making strange noises prior to refusing to work


It could be the motor. I'm having to replace the brushes on my DC 05. It appears that you can only get brushes for the YDK motors in the DYSON, not the Panasonic motor. Which might be saying something about the YDK motors. What happens is that the ca ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

How long are the batteries for virtual wall supposed to be working for? Even though I try to remove them after each cleaning , or use fresh batteries, the wall does not respond straight away. I can n


... iRobot Vacuums

Spotbot will not light up in handsfree mode, but works fine in manual (hose) mode


You may want to contact one of our Authorized Service Centers to have a quality technician inspect your machine.Here's a quick link to locating one. \015\012 ... Bissell SpotBot Robotic Wet/Dry Vacuum

Suction Problem I was vacuuming and stopped to empty the cannister. When I started vacuuming again - the suction wasn't working properly. The vacuum was just pushing stuff around the floor. I cleaned the hair out the brush on the bottom and it still isn't working. It was working fine before I emptied the tube :( I can't figure out what happened.Help!


Greetings from GoVacuum,\015\012\015\012I believe what may have happened is that your vacuum cleaner belt has either broken, or been stretched so far that ithe brushes are no longer spinning fast enough. \015\012\015\012Here' ... Vacuums

We have a Eurolab XR210 Robotic Vacuum, it has stopped working. The fan will run, but the wheels do not drive, the UV light does not work, however, it will work in Docking mode. Can it be fixed?


... Vacuums

I was vacuuming with my DC28 Animal and all fo a sudden the beater bar stopped working and NONE of the floor mode buttons work.. no lights or anyhting. I checked for obstructions per the Dyson manua


... Dyson DC28 Animal Bagless Upright Vacuum

All lights work opener operates from head, but will not operate from wall control or remote the wall control does turn on the lights like it is suppose to on genie garage door opener model 2022


... Genie Company Vacuums

Shut off The vacuum cleaner was working just fine until it just shut off!! I tried a different wall outlet but still won't work!! Called Hoover and they just want you to bring it in and pay for repairs!! Seems like it should be simple...Anyone who can help?


From your description, you problem sounds like it could be an electrial one, not very hard to diagnose, but some dis-assembly is required. you would have to remove the hood, motor cover, turbine just to get to the motor. I would check the carbon brus ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

The telescoping wand on my kenmore magic blue cannister vacuum stopped working shortly after I bought it a few years ago. After 10 minutes of pushing sometimes I get it to work. It gets longer easier than shorter. What could be causing this problem? Please help!


... Kenmore Magic Blue 24195 Bagged Canister Vacuum

Doesn't work Our home was built and finished in August 07.  The central vac doesn't work.  There is supposed to be a slot that opens in the kitchen where you sweep the dust and it sucks it up.  Also, the mounted unit on the garage wall has a hose that goes up into the house but there is a hole open at the bottom of the unit.  Where can I get someone to help us?  Or, is there an installation manual I can download to see if the builder did it properly.  He stole our solar heater for our pool and s


Has the slot in the kitchen (VacPan) been installed? Or is it just not working? There should be tubing coming into the unit in the garage, and possibly another piece to exhaust the unit to the outdoors, although this isn't always necessary. The intak ... Electrolux Centralux Vacuum

Have a quite new easyvac. Worked great the first time. Emptied the cannister, put it back together, and now have no suction. Only hot air flowing out from near the bottom of the clear cannister.


Check the clear canister. You may not have:\015\012\015\012gotten it seated correctly\015\012there is dirt or some other object preventing a good seal\015\012you lost or dislodged ... Bissell Vacuums

Hi i have a dyson dc07 it doesn't work in the upright mode. It works with the tools only .... think the brush isn't turning. it's not making any nasty noises just not picking anything up!


Has the belt snapped? ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Kenmore Progressive Cannister Vacumm, Powermate Floor Unit quit working. I replaced the reset switch but still nothing. Light doesn't work either.


Is it working on other mode?.Or its not having any power at all?.\015\012\015\012Select a switch position o the handle.OFF MODE.\015\012\015\012FLOOR:-- turns on the canister motor only. \015\012CARPET :-- turns on both the canister and the Power ma ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I have a remote Hunter Ceiling Fan w/ remote 1-2-3 fan speed buttons and one on/off/dimmer light button. Model Number CP-9110R. It only has one pull string and it is for the light. I would like convert the light to work off of a simple wall on/off switch and the fan to be controlled by a 3-speed pull string. Can I by-pass all the sensors and make it work?


I see noone has answered so I will.Yes,it could be done,but if there is not a conversion kit for your fan,it would not be wise to do it.For starters,all of the things required would probably cost at least $15.Also,there is at least one tool you would ... Vacuums

Have a kenmore cannister vaccum, brush is working but it is not picking up anything the suction is not working ?


Remove the hose and clear any obstruction from inside of it. If that does not work check the bag and filter if one is installed ... Vacuums

My dyson works fine in the bare floors mode but when i turn it to carpet mode it makes loud noise and wont **** up.


You need to replace the belt. Here is a link to the manual and to the belts you need:Dyson DC07 Manual and Belts ... Dyson DC07 Bagless Upright Cyclonic Vacuum

In the manuel mode spray will not work. In automatic mode, brushes will not turn.


How do I turn on the light for my kurby? ... Bissell SpotBot Robotic Wet/Dry Vacuum

I have central system vacuum cylinder engine is working but on the wall conection nothing is working.


Check to see if the low voltage wires are attached to the tank. At the tank, if you switch it to manuak, will it work then? If so, then replace the relay board that is inside the tank. Is the problem at all outlets, or just one of them, if just on ... Hoover Vacuums

Dear Expert, the vacuum is not working in normal mode but if i use pipe then it works. Any suggestions? thanks khangee


Hello, So usually when an upright vacuum works well when using the attachment hose, but doesn't work well when vacuuming on the floor mode, this typically means that you have a belt problem. This is very easy to diagnosis. Turn the m ... Hoover Elite U5061-900 Bagged Upright Vacuum

Hi! I cant recharge does not work . When Im charging on the off mode a red light on when I disconnect from the charger the light is not on and does not work at all.


Need sweeper schematic circuit ... Vacuums

The vacuum works on carpet mode but not floor and only when the wand is attached to the floor brush otherwise it does not work at all


Please define "works" on carpet mode" do you mean when you say it does not work at all, that it does not run, or does not have suction. This sounds like the symptom of a clogged hose with blockage like this another vac needs to be used to draw ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0661 seconds