Having problems with your M&S Systems ZX-6000 Bagged Central System Vacuum ?

Will not cut off unless unpluged

\015 Model AV425A -17 years old . I have checked the connections at all wall inlets ,none were loose. Next I disconnected the wall inlet wires from the unit and it still would not cut off .Help!-or name of nearest dealer. Zip 23833 Thanks\015

Answers :

You probably have a stuck relay or wires are touching. Pull the low voltage wires off the vacuum, if it keeps running it's the relay. You can try tapping with medium force next to where the low voltage wires are attached to the unit using the handle end of a hammer. Even if this works it's time to replace the circuit board. Check these guys out:

http://www.vacuumsystems.net/



Repair Help & Product Troubleshooting for M&S Systems ZX-6000 Bagged Central System Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Will not cut off unless unpluged


You probably have a stuck relay or wires are touching. Pull the low voltage wires off the vacuum, if it keeps running it's the relay. You can try tapping with medium force next to where the low voltage wires are attached to the unit using the handle ... M&S Systems ZX-6000 Bagged Central System Vacuum

Hayden Super Vac Premier will not stop unless I unplug


One of two problems cause this. first is a short in the wires that turn it on, the small wires going to the side of the body unplug one of them to see if thats the problem\015\012second is a stuck relay inside the top cofer of the main body ... Hayden Industries SuperVac 6000 Central System Vacuum

Unit will not turn off, unless unplugged


This sounds like a relay sticking on the control board inside the unit. The only other thing I've seen cause this, would be a short in your low voltage wiring. I had a service call where the wires were laid across the top of metal studs and the insul ... Electrolux Centralux Vacuum

The vacuum is always on unless i unplug it


Sounds like your controll relay went bad in the main unit its an easy repair but i would still have a reputable vacuum shop do it. ... Broan-NuTone CV554 Cyclonic Bagless Central System Vacuum

My Dyson Animal won't turn off. It turns on and then unless I unplug it it continues to run. Any suggestions?


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Ive got a miele revolution 5000 power plus and its just cut out the green power button on the handle is on but the orange button on the body does not come on it just flickers unless i open it up, any ideas?????


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=640910\015\012Generic problem for all Vacuums\015\012I’ve got a Miele revolution\015\012Posted by ... Vacuums

Central vac won't turn off unless we unplug - Broan-NuTone CV350 Central Vacuum


Some units have an on/off switch on the power unit itself. Check to make sure that is not turned on. Unplug your power unit and remove the 2 low voltage wires (not the power cord itself) . The low voltage wires start at the unit and run throught your ... Broan-NuTone CV350 Central Vacuum

My Electrolux central vac wont cut off when you turn the switch off or unplug the hose from the wall. Any suggestions? Sheldon


Hi,\012The realy that turns it on is stuck... the relay will need to be replaced...\012\012heatman101 ... Electrolux Central Vacuum

I have the Airvac zx7000 and it won't turn off unless I unplug it from the wall. Is this an easy fix or do I have to replace the system?


... M&S Systems ZX7000 Bagged Central System Vacuum

Electrolux Centralux I have a Electrolux Centralux. When I plug the hose in at one of the wall outlets the motor will not start. If I go to the motor and slap the unit it will start.....then...it will not stop unless I unplug the power cord to the motor. If I plug the power cord back in, the unit will not restart until I slap the motor unit again. The unit has only been used 20 - 30 times. Any suggestions?? Thanks, Bruce


I dont know if you had your unit looked at yet but it sounds like the Power module is going. I repair the machines so I know some of the work. ... Electrolux Centralux Vacuum

It will not shut off unless we unplug it at thje unit ouside


Bad switch ... Eureka Mega Boss 4460DT Vacuum

I have a Eureka Central Vac CV1601b. The motor does not stop unless the Unit is unplug from the electrical outlet. Any Idea?.I removed the control unit to check if there was disconnected wires or burnt wires. Everything look normal. The circuit board does not show area that overheated. There seem to be 2 relays. Likely one of the two went bad. What do you think.


If the unit is relay controlled, there is always the possibility that when the unit was turned on, the relay contacts welded themselves shut making the power button ineffective. \015\012\015\012If you're familiar with relay pinouts, with ... Vacuums

Can't find the manual for Biddeford electric blanket (warming blanket) '08. Controls are acting up. One side keeps turning itself off and says 'E'. I'm assuming this means error. The other side only registars '8' and can not change or turn off unless I unplug.


... Vacuums

My new Hoover Wind Tunnel Upright UH50000 will not turn off unless I unplug it.


First I would be sure the handle was properly installed. Remove the two screws holding the upper handle in place and tap it bacwards to remove it. Set the switch inside to the OFF position. Next set both buttons on the handle to the OFF position and ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

My dyson dc25 ball animal has stopped working. Cut out yesterday. Checked for blockages and unplugged left off for over an hour and overnight. Have absolutely nothing still this morning.


... Dyson Vacuums

Starts when plugged in (switch is off) and will not turn off unless unplugged.


Go to a fixya.com advertiser, local appliance parts place in your area or www.repairclinic.com and get a new switch. Yours is bad.\015\012\015\012Thanks for using ... Electrolux Epic 3500 Vacuum

I have a Kenmore Progressive upright model 216-37100800. It is only around 1.5 years old. My wife said that one day after she plugged it and turned it on, it whirred up but then shut off. Since then it will not start. I have noticed that right after I plug it in, if I try to turn it on, the first yellow light in the series of dirt sensor lights turns on then shuts off. After that the light will not light up on pressing the power button, unless I unplug it and plug it back in again. I have seen o


... Kenmore 25512/ 25513 Progressive Canister Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis


Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

Power cut off after handle was dropped on floor while vacuuming


Connections inside the handle came loose. happens to me all the time. take the handle apart and connect the wires back. ... Oreck XL Ultra Bagged Upright Vacuum

Roomba cuts off after a minute or so.


If you have a 400 series Roomba, try removing the battery, then holding down the power button for ten seconds, then recharging the unit before you run it again.\015\012\015\012If you have a 500 series Roomba, don't take out the battery-- ... iRobot 4150 Roomba Vacuum

Why does my dyson dc04 work for about 5 mins then cut out the wire on my dyson 04 needs replacin but i cant get the casing off. My DC04 cuts out after abou 5 minutes use. I think there may be a thermal cut-out somewhere?


Thermal cut out in coils of motor,you have not been keeping filers clea,I THINK.\015\012motor is avaliable ... Vacuums

My neato has just had new batteries but after charging her for 24hrs and unplugging her she asks that we unplug her before she can clean. We have turned her off then back on, we have tried to redownload software, we have plugged her in then unplugged her to no avail. Any one able to help?


... Vacuums

My Andis Easy Clip does not cut the hair very good any more. I greased/ sprayed the blade even bought a new blade but it only cuts for a couple of dogs and then just pulles the hair rather then cut it.


U might need a new belt check it out ... Vacuums

There is a cut at the end of the hose. Is there a way to cut the hose at the split and reattach it to the connection? Thanks.


Unfortunatly the amswer is no you will have to replace the whole part. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC07 stops working after a few minutes. It works again after a further 10 minutes and then cuts out again. I have cleaned the filter and checked for blockages but is still cutting out. Can anyone help?


Have you tried calling Dyson? I had a problem with my Animal, and their tech department talked me though the fix. Worth trying them first. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0218 seconds