Having problems with your McCulloch MC1275 Steam Vacuum ?

I have a model 2016S chain saw and need to know how the fuel lines are hooked up from the fuel tank to the primer bulb and to the carburetor. does the filler line in the fuel tank go directly to the carburetor or does it go to the primer bulb and then to the carb?


Answers :

Tank filter goes to the primer bulb and then to the carb.
Repair Help & Product Troubleshooting for McCulloch MC1275 Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a model 2016S chain saw and need to know how the fuel lines are hooked up from the fuel tank to the primer bulb and to the carburetor. does the filler line in the fuel tank go directly to the carburetor or does it go to the primer bulb and then to the carb?


Tank filter goes to the primer bulb and then to the carb. ... McCulloch MC1275 Steam Vacuum

Carburetor primer bulb not pumping any fuel for a stihl fs 110 weed trimmer


... Vacuums

Ryobi RPBV2500 My blower only seems to ant to run when the choke lever is at the first position. It did run with the choke completely off but seemed to suffer from what I thought was fuel starvation when it ran for awhile. When I took the fuel cap off it would start up again, making me think it had a fuel lock. I had a garden centre with engineers look at it.They said that they had checked the carb and could find no blockages. Can you please help?


... Vacuums

My floormate upper tank has a screw on filler cap nad the tank tank does not obviously come off the machine. The filer cap is under a hood and also cannot be used with iut removing the tank.I must not have 3000; I bought themachine about 5months ago and have never used it. Frank


I have an H3000 that has an upper and lower tank. The upper tank comes off and has a screw-in filler cap for measuring the cleaner. Just fill the cap with a recommended cleaner, fill the upper tank to the line with water, then add the cleaner as yo ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I HAVE LOST MY INSTRUCTION BOOK FOR THE STEAM VAC SPIN AND SCRUB. I WANT TO USE THE STAIR ATTACHMENT, BUT I CAN'T FIGURE OUT HOW TO HOOK IT UP, OR OPERATE IT. I SEE WHERE THE PLUG IN PART GOES IN THE FRONT OF THE MACHINE, BUT I CAN'T GET THE OTHER PART TO SLIDE INTO PLACE ON THE FRONT OF THE RESOVIOR TANK AFTER I REMOVE THE FRONT PANEL, AS THE DIRECTIONS ON THE FRONT OF THE RECOVERY TANK SAY TO DO. THE FIT IS JUST TOO TIGHT. WHAT AM I DON'T WRONG- OR HOW COULD I GET A REPLACEMENT INSTRUCTION BOO


You can download a PDF version of the manual at the link below. I believe you can contact Hoover as well and they might mail you one.http://www.hoover.com/CustomerService/Manuals/Default.aspxGood Luck! ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Craftman 5hp snowthrower model 53688501 that will not start. It will fire with gas down sparkplug hole, but runs only untill that gas is burned up. Fuel is present at carb, but I noticed that there are two brass fittings on each side of the carb for vacume lines or something, and they have no lines connected to them. Did I lose the lines that should be connected? Or do I have some other problem. The unit is 4 years old and has the Briggs and Stratton eng model 9A413-0202-E1


This sounds like the carburetor needs disassembled and cleaned. This happens over time and the tiny orifices plug up. Usually from letting gas set in them for extended periods of time and it gums up. If you are not familiar with them, I would take ... Craftsman Vacuums

I have a Bissell Proheat 2x Model 9200. The solution goes directly through to the carpet. The tank empties extremely fast even when I am not pushing the button. I have also noticed that I have soap spots on the carpet when pushing the cleaner forward. These spots are not even associated with the cleaning mechanism. I have inspected the cap on the tank, but it seems to be OK. Any suggestions?


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9200 Upright Vacuum

At first when I tried starting my B & S I primed the motor and it ran for a few seconds and died. This happened twice. I drained the tank and took apart the cvarb and blew out the entire carb. Put it back together changed the plug and now nothing. Could it be that the priming diaphriam (#694395) has a hole and thus preventing gas to come up from the carb bowl?


Hi tifix1...\012Yes, that could cause your problem.\012I will offer a few more things to check and repair/replace, maybe there is a few things that you missed.\012Please take time to rate me\012\012Sounds like you have d ... Vacuums

I have misplaced the directions for the Bissell powersteamer powerbrush. I need the directions for filling the u tank etc.


Release the handle and lay the machine handle\015\012back to access the Tank.\015\0122. Remove the Tank from the base of the machine by\015\012lifting the Tank carry Handle.\015\0123. Carry like a bucket to the s ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

My Hoover maxextract 60 clean water tank is draining directly to the dirty tank


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Suction Problem I took my unit to my work and used it, when I returned home it wouldn't suck up anything. I took the recovery take out and it has inward suction. Shouldn't that be outward, so it goes into the tank? It also blows out of the bottom by the brushes. I check the filter in the bottom and that is fine. Is it possible that it is somehow reversed the direction of the air flow (rotor running backwards)? I am perplexed. What am I missing?


There is a stand pipe seal where the bucket sits on, and if it isn't there or out of place could cause a suction problem like you said yours is doing. In the picture it is #10. The motor seal may have gone bad and is leaking # 15.\015\012 ... Hoover F7220900 SteamVac V2 Upright Vacuum

Followed directions on filling water and solution tanks. When I use the cleaner the cleaning solution is not being dispensed.


The tubing is clogged, you need to take the tubing off and clean it out or some how force some hot water thru the tubing and clean it out. this happens when you don't run clean water thru thesystem after using the cleaning solution. The solution drie ... Bissell 8910 ProHeat Clear View Upright Vacuum

I'm trying to light a Robeson Kerosene space heater model # 03-2619-91. I am turning it on and applying flame directly to wick and it is not lighting. I just filled it with fresh fuel but nothing seems to be happening?


... Vacuums

The soap dispenser on my 2X is not dispensing. I wrote with this initial problem and received a reply. We did everything recommended to find a clog. To begin with, we poked holes thru the little holes on the underside with a toothpick. Next we took the machine all apart as directed and cleaned out anything that had accumulated (such as pet hair). Eventually we emptied out the soap dispenser, filled it with a hot salt water solution and let it sit for 10 min. I ran three tanks of hot water


Hello,The solution to your problem is already solved, since your soap dispenser is still under warrant,What i will suggest is that you contact the company that supply you this product and explain everything to them, it is most ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

When I was putting my new rug shampooer together and the directions said to press the trigger and the clean surge button until I heard a snap, I did just that many times and never did hear a snap so I thought it had likely happened and I didn't hear it so I proceeded to fill the solution tank and get busy but no solution came out so I used the clean surge button instead and got the job done (I think). Can I continue to use it that way or is there a way I can get it to snap and use it the way it


My husband figured it out and it now works great! Thank you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hi! My name is george and i forgot how to start my cleaner. I have a bissel proheat # 7901-1. Can U send a copy of the start-up directions after I fill the water mix tank up?


I forgot how to start my Bissell Pro Heat Upright Wet/Dry Please advise ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Dyson absolute dirt bypasses tank and goes to filter


Check rubber seals ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

How to open water tank to fill.


... Oreck Sanapathic DMS2000 Handheld Steam Vacuum

Tank not sitting tight


Some bissell models this cant really be fixed but some can look at where the tank connects some bolt down some twist in and some have a rubber gasket between the the tank and the machine if this is the case, with the age of the machine the rubber gas ... Bissell 8910 ProHeat Clear View Upright Vacuum

How to remove a lid from superfish aqua silver fish tank


... Vacuums

Lost directions to the cleaner.


Hi , check the water level and refill it . ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Leaking tank After I put the water in the tank and put the tank in its spot, water leaks from the bottom of the tank. Also from the detergent tank.


(1) Does water or chemical leak from the tank when filled, but before it is installed? If not, then the tank is OK.\015\012(2) If the tank is not properly aligned to the lower handle when assembled and latched, the black rubber seals on the ha ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Scooba 5800 "check tank" light always goes on. - I have checked tank. I have cleanout brushes, tank; rinsed, sloshed, dumped. The check tank light comes back on when I want to clean. What should I do now? Pat


... iRobot 5800 Scooba Vacuum

How do I fix Bissell Quicksteamer leaking from water tank through wheels? After I place the filled Clean/Solution tank on the Lower body of the QuickSteamer, water pours out from the body of the machine through the wheels even before I turn the power switch on. I checked the tank and there are no holes in the plastic tank.


I have the same problem... seems to be because of a bad, or worn, rubber gasket. ... Bissell Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0322 seconds