Having problems with your McCulloch MC1275 Steam Vacuum ?

I need the fuel/gas mixture for a small (12") McCulloch Chain Saw. It has a 2.0 C.I.D. label with Fuel Mix I lnoted at the fuel cap. ja


Answers :

The 2.0 CID is Cubic Inch Displacement, the size of your motor. As for fuel mixture, generally a 50:1 is a benchmark for this. Typically, it should be 1 gal. of gas for 2.56 oz. of two stroke oil. They sell pre-packaged, pre-measured oil at your local DIY shop or lawn mower repair shop.
Repair Help & Product Troubleshooting for McCulloch MC1275 Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need the fuel/gas mixture for a small (12") McCulloch Chain Saw. It has a 2.0 C.I.D. label with Fuel Mix I lnoted at the fuel cap. ja


The 2.0 CID is Cubic Inch Displacement, the size of your motor. As for fuel mixture, generally a 50:1 is a benchmark for this. Typically, it should be 1 gal. of gas for 2.56 oz. of two stroke oil. They sell pre-packaged, pre-measured oil at your loca ... McCulloch MC1275 Steam Vacuum

What is the fuel mixture for a stihl ts 460 cut off saw


... Vacuums

I have a model 2016S chain saw and need to know how the fuel lines are hooked up from the fuel tank to the primer bulb and to the carburetor. does the filler line in the fuel tank go directly to the carburetor or does it go to the primer bulb and then to the carb?


Tank filter goes to the primer bulb and then to the carb. ... McCulloch MC1275 Steam Vacuum

Ryobi RPBV2500 My blower only seems to ant to run when the choke lever is at the first position. It did run with the choke completely off but seemed to suffer from what I thought was fuel starvation when it ran for awhile. When I took the fuel cap off it would start up again, making me think it had a fuel lock. I had a garden centre with engineers look at it.They said that they had checked the carb and could find no blockages. Can you please help?


... Vacuums

I need the manual for a 1988 Hino Rainbow CH160A With a : WO6E Hino Engine, I am trying to lean out the fuel mix from the injectors to compensate for a hydrogen conversion kit


Dear Conway sanhttp://vicbus.com/portfolio/hino-rainbow-ch160/Can't you get the manual in English from this Australian company since it seem ... Vacuums

I have 1699-R Proheat carpet cleaner recently I was replacing the food pedal during the process some tubings that carry water/chemical got mixed to the point that one side instead of spraying chemical sprays only water from oneside the other side that is connected to the flow indicator cap is completely dry does not move at all. I am looking on line to see tubing diagram for model 1699-R


The instructions in this Repair Guide pertain to the Bissell PowerSteamer ProHeat (#1698)\015\012and the Bissell ProHeat ClearView(#1699). \015\012If your unit matches this model numbers then the repair guide plus diagrams for this unit is mentioned ... Vacuums

The smart mix bottle is not dispensing any fluid. I have been using this Bissell 8910 for 6 years. The cap and seal seem to have all the parts. thanks -LaRie-


... Bissell 8910 ProHeat Clear View Upright Vacuum

I have Bissell Model 1699-R Proheat carpet steam cleaner one of the tubings that connects into spray got mixed with some tubings during tubing replacment to the point that tubing that is conected into flow indicator cap does not turn at all to show if the chemical is sprying or not.i am looking mainly for tubing water/chemical diagram in order to verify the right connection.please help if you can bissell user. thanks


... Vacuums

System will spray soap, but no water is mixed.


I had the same problem. After 3 weeks of seals belts pump etc. I was ready to give up.The problem with mine as I suspect with others is the seal on the water tank.The bottom plastic connector is not high enough to allow the water to flow ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Chain saw starts runs, bur saw won't start next time it is needed, craftsman chain saw


Steam vacuum? no clue but on your chain saw make sure you check the choke. it would explain why it wouldn't start again. ... McCulloch MC1275 Steam Vacuum

Bissell - Model 1697 - Powersteamer Pro - Carpet Cleaner I took the unit apart to replace some broken pieces and I can not seat the bottom to the top without properly engaging the soap/water mixer. What is the proper assembly procedure. What is the orientation of the water/soap mix valve when I seat the top to the bottom? The soap/water mix valve needs to engage the knob screw threads but this assembly is a blind operation. Do I turn to the soap/water mix knob to water only then seat the


Hi,\015\012http://dl.owneriq.net/7/7e477b7e-4440-49cf-a219-b68d301549e3.pdf\015\012This diagram will help you see the diagram plus the part assembly no and place it accordingly.I have also given link for Bissell - Model ... Vacuums

Who makes ek8005 steamleaking under cap need new cap and allparts under it.I got trhis from someone and I think parts are missingNeed picture of cap and parts.


It's made by Kable Enterprises Co Ltd - a chinese manufacturer that sells them under different made-up names. No parts are available for it - it's a "use and throw away" device. The only source for parts are other defective units kept for parts - se ... Vacuums

I have an old Friedland door chime (approx 30 years old). It has 5 terminal screws to connect wires. They are labeled 0-4. I removed the chime during remodeling and would really like to reuse it. I did not label the wires and where they connect when I removed it. I can't figure out how to wire it. I contacted Friedman and they were of no help... didn't have information on chimes that old. Can you help with how to wire the chime given it has five connections screws with no labels other t


... Vacuums

Connecting a BISSELL AUTO MIX PISTON TO A AUTO MIX KNOB


Take of the housing ,turn it over and you will see the under side of the auto mix dial , Then turn the auto mix dial to rinse only;\015\012On the top of the piston you will see a small slot , this fits into \015\012the out ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Steamfast sf250 b steam cleaner the reservoir cap is extremely difficult to remove when you need to add more water. I have followed the directions in the manual to remove the cap with limited succes


... Steam Fast Vacuums

The solution in my smart mix will not mix with water and the button just keeps going round and clicks and will not stop on either water or solution.


The smart mix knob is connected to a piston that slides up and down into the automix assembly. This piston has come off of the smartmix knob and left the unit on water only setting. Sometimes the smart mix knob breaks on the ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Stuck Roller Same problem here. I think in our case, the accumulation of hair and the increasing resistance the hair created over time caused the hair to start melting, and eventually the end cap was stuck to the roller, which prevented the roller from turning. I cleaned out the melted hair(?) as best I could, but I think I need to order a new roller and end caps.


Befrore you plunk your $ down ...\015\012\015\012I dont now that you melted the hair so much as you may have an accululation of gunk and hair. If there is a good (not 'fast food' type) auto parts store near you, go there and ask the cou ... Electrolux 1910 Bagless Upright Vacuum

I have a bissell 1698 powersteamer. i have already cleaned heater and completely cleaned all parts , checked the mix piston, checked belt. it will not shoot water or mix. the motor runs, it will **** water and the brush turns. is it the pump and does the pump just shoot the soap?


Pump is probably bad. When you put the lid back down, did you put the piston on the bottom of the smart mix knob? Also the smart mix knob should be in the water only selection when the top is pushed all of the way down. Also sometimes the flow ind ... Vacuums

Can you disperse a water and vinegar mixture with the steam buggy, without causing damage to any part of the unit? can you disperse a water and bleach mixture with the steam buggy, without causing damage to any part of the unit?


If you do this the vinegar will likely disperse hard water scale as it cleans the inside of the element. While it shouldn't stain anything it will likely cause sputtering as it breaks down the scale. If your goal is to clean and disinfect a surface t ... Tristar SB Steam Buggy Vacuum

I have an old Shop Vac model 3331.5. This is a 12 gallon 1.5 hight peak shop vac with a detachable blower. After many years I decided to use the blower feature, but have lost the lost the manual. Question; how do I attach the hoses to the blower? The motor has that cap on it the direct the flow of air in one direction and the wide hoses do not fit over it. I may be missing a part, but I would think the directional cap would have to come off anyway.


Remove the cap that directs the air and insert the hose in there. ... Vacuums

CEL lit up on dash. Codes point to possible loose vacuum line or faulty gas cap. Replaced cap with no change. Looking for vacuum line diagram if possible. Thanks, Brian


\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012 ... Vacuums

Cap (top) is froze. Unable to remove cap (top) to pour water inside for use. not sure if model specified is correct. It's a canister with hose and multiple attachments for cleaning.


I too can not figure out how to get the lid off. ... Euro-Pro Shark SC-505 Handheld Steam Vacuum

I am still awaiting for your reply, [email protected], regarding water reservoir cap steam leaking is this normal or do I require a new cap or rubber ring, otherwise I will have to take my custome elsewhere. Many thanks.


Hello, no this is not normal. You just need a new O-ring. This is about a 1 dollar fix. The original O ring is clear rubber but a 3/4" standard O ring will work just fine. You can get these at Lowes or Home Depot. ... Tristar SB Steam Buggy Vacuum

Cleaner solution in smart mix tank not mixing with the water from the bladder. All tanks are seated properly


... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

Smart mix what is the trick to connecting the smart mix?


Glad you did. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0181 seconds