Having problems with your McCullough mc1275 ?

Heater will not heat up

Plug in light is on but will not heat up

Answers :

Repair Help & Product Troubleshooting for McCullough mc1275

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a very old toastmaster small heater model 2517. I use to have it at work to keep under my desk for heat on my feet. I want to give it to my son for his pop up camper. My question is, are these heaters safe for campers?


They are inherently unsafe regardless of safety tiptoe switches. go for a modern ceramic heater. much safer. why court a disaster for such a small dollar amount. ... Vacuums

My Charmglow Electric heater is not working. The problem is when i turn on all the buttons which includes blower fan, heat 1,heat 2, and firebackround motion. Only the fire backround motion goes on nothing else. I did notice that the fan button is not working properly


... Vacuums

We have purchased a kerosene heater wick (dura heat dh-145)for a dyna-glo model rmc-95-c4. we put the wick on the heater and it seems that now that it is soaked with the kerosene it is to thick and wont move up or down with ease and only a small part of the wick will light.


... Vacuums

I have a Sleepwell Dreamland Luxury cotton Electric Duvet. It has twin heater controls, the control has a 1 to 9 heat setting and also a time duration function. One of the controlers works fine but the other turns itself off after about half an hour. Can you help and perhaps give me an address where I might purchase a new heat control.


... Vacuums

Heater does not generate steam / water temperature not hot enough shark S3202 has only been user 10 to 15 times. can a new heating element be installed? where can I buy element?


Hi,The element is not sold anywhere... go figure...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I need a operation manual for Pro-heat Platinum with on Board Heater. Thanks Sheila Creasy 156 Forest Ave. Lynchburg Va. 24502


Here is the manual you need:ProHeat User Guide (PDF) ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Heater not heating water to create steam. Where can I get parts?


... Lentek Steam Xpress SE01 Vacuum

I need programming instructions for a Maxi-Heat portable heater, model number NH400BE. Thanks


... Vacuums

I have a bissell pro heat model 7901-B that has power but no water circulation. I was told that the previous owner used it without water and that she couldn't get it the power on. I bought it off of her and cleaned it out and now the power works, but there is no water circulation. The brushes run and heater works, just can't seem to get it to circulate water. Thankyou for your time, Don


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

I can't find my manual for the EcoQuest Safehearth heater, it is showing a E2, I don't know what this means, which then it s not heating. help please


E2 means that the heater senses that it has been tipped over. Unplug it, wait a few minutes and then plug it back in an try it. If the problem persists there are 3 capacitors on the control board in the front of the unit that go bad causing the sympt ... Vacuums

Heater/fan issues I have a Honeywell - Year Round Fan with 1500W Heater that shuts off within five minutes if the fan is not running too. I don't have the oners manual and can't find one online. I have read several reviews that say the same thing. The heat does do much good when the fan above it is blowing cold air. Any ideas?


There is a safety switch which will shut the heater element off if the fan doesn't run. If the fan doesn't circulate air, the element would overheat and could possibly start a fire, so the switch will shut the element down. I'm not familiar with this ... Vacuums

My model # DBL-2000-MS heat will not come on,and as you turn up the thermostate it shuts off right at the point when it should be at highest temperature but the heater element never comes on. Everything else works.


... Vacuums

Bissell pro heat - belts are ok. water will not


Remove the handle, disassemble the lower section of the top to get to the heater. Make sure the unit is unplugged! Use miniature bottle brushes like the painters use to clean paint sprayers (I purchased mine from Harbor Freight for about $4) and clea ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

BISSEL WILL NOT HEAT THE WATER


... Vacuums

Bissell pro heat steam carpet cleaner is not releasing water


... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Water Heating System


You need to have the wiring checked in the handle. Either the switch or wires going to the heater are bad or shorting to something they shouldn't. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have a Bissell ProHeat 2x, and I did something dum. I had some powdered cleaner that said it works with carpet cleaners-well I mixed it in-and the next time I tried to use it, nothing came out. So, I took it part to check what was wrong-and found out that the powdered cleaner solidified in places. I cleared the nozzels, nothing. I think the solenoid, between the heater and nozzels is pluggd, and possibly the heater. I've got a question-could I use CLR to clean the heater, with replacing t


Heck yeah, give it a shot. Try running some water through it too- fill it up, heat it just to where it's hot and unplug it, shake it around and dump it out. Repeat. You might have to get a wire or something to go through and get the powder loosened b ... Bissell Vacuums

DZ9080 IRON IS NOT VERY OLD, BUT HAS HEATING AND STEAMING PROBLEMS. IT MAY BE ALL HEATING RELATED! MY WIFE WILL SOMETIMES JUST LEAVE IT "ON" FOR TWO HOURS AND THEN IT WILL START STEAMING AGAIN. I CANNOT MAKE SENSE OF THE HEATING INDICATORS; SOMETIMES IT WILL STAY GREEN NO MATTER WHERE YOU SET THE DIAL ---- AND IT DOES NOT FEEL HOT! WHEN I TRIED IT AGAIN TODAY, THE SHOT-OF-STEAM WORKED FOR A WHILE (AND THE SPRAY WORKED), BUT THEN ALL IT WOULD DO IS DRIP WATER AT THE TIP WHEN TIPPED DOWNWARD.


I couldn't find any warranty information on this iron, but I suspect that the heating element either has a faulty connection or part of it has cracked, making contact at time, but poor contact at other times. The unit will have to be taken apart an ... Rowenta Vacuums

Model Mars A4 laminator not heating up. The red ligh5t comes on but then wont go green. No heat being generated. Was wondering if it is the round thermistor on inside of the unit, or could it be the heating element itself.


... Vacuums

I have the euro steam blaster s3325 when I turn it on, the steam ready **** comes on right away not heating can the heating element be replaced? thanks


There is a device attach to the heating element called a thermo fuse, this devise brakes down when it get to hot.open the machine and replace it with the same value. it is written on it.. ... Euro-Pro S3325 Handheld Steam Vacuum

HELP! My HAAN floor steam mop water pump went silent & dead! Heat element still heats, but the pump is inactive.


... Vacuums

My mini steam zapper heats but produces no heat


You should get steam in the amount of time it take to boil water ... EuroSteam Vapor Steam Cleaner Vacuum

On our Hoover U6445-900 (Mach 6.9) we replaced the small belt that goes to beater brushes in front of unit. Upon starting, the Hoover quickly got hot and smoky. We shut it off and looked things over carefully, but the second try also resulted in friction heat on the belt. Now it appears the belt may have stretched due to heat and the brushes won't spin. Any ideas?


Are you sure you purchased the right size belt..the friction you speak of is usually caused by a belt not being the right tightness or a jammed beater brush ... Hoover U6446-900 WindTunnel Bagged Upright Vacuum

The steam mop doesn't seem to be "steaming"...even though I leave it on long enough to heat up. I can hear the steam but it doesn't seem to heat the pad


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Sharp R-1480. Microwave would not start - jarred door, and it heated and worked. Replaced bottom of the 3 inter-lock door switches. Turns back on - all seems normal. No heat (it does overall sound louder). Thanks, Mark [email protected]


Hi Mark,It sounds like you have a magnetron problem now or at very least a rectifier that is shorted. The elevated sound level comes from one of those two components. But since you had a door switch problem I would lean toward ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0217 seconds