Having problems with your Medline Vacuums ?

IV Pole will not stay up when IV bags are attached

\015 IV Pole will not stay up when IV is attached\015

Answers :

Repair Help & Product Troubleshooting for Medline Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

IV Pole will not stay up when IV bags are attached

... Medline Vacuums

My Oreck XL vacuum cleaner disposable bag does not stay attached. I had my husband put it on and again it came off. The cloth bag is always full of dust and suction is lost. What is the solution?

... Oreck XL Ultra Bagged Upright Vacuum

I have an oreck upright cleeaner I have not used for a while where I put bag on is the attachment 2 part because bag will not stay on.

You should have a velcro bag holder slide the bag opening onto the velcro bag housing after it is folded down then with the bag in place swivle the bag housing to the velcro and it should snug up to the inlet tube where all of the debris is vacuumed ... Oreck XL Ultra Bagged Upright Vacuum

I have an electrolux epic 6500 sr. The change bag light came on, I changed the bag, now it won't run properly. If the bag is out and the hose attached it will run or if the bag is in and the hose is off it will run, but not if the bag is in and the hose is attached. Any suggestions?

First, if it runs without a bag, there's a problem with the bag lock-out switch or wiring. This needs to be replaced/repaired by an authorized Aerus Electrolux technician.\015\012\015\012First, turn dial on top of vacuum counter-clockwis ... Electrolux Epic 6500 Vacuum

Dyson dc17 My dc17 has great suction with the attachment but when i try to vacuum my carpet it hardly has any suction. I just bought this on ebay and the seller told me to pull the pole all the way out but it doesn't seem to completely come out. am i doing something wrong? Is the metal pole suppose to come all the way out unless you are using the attachment?

... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My electrolux vac shut off for a full bag. After replacing the bag the vac won't start and the bag full light stays on.What should I be looking for to resolve my problem?

If the suggestion that renevacdoc did not work, it is most likely that your valve assembly(full bag control) has gone bad and needs to be replaced. You will have to take your vac to the Aerus/Electrolux dealer/service store for repair. ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My Bosch Ultra SS vacuum is not attaching properly to the bag. Dirt is going directly into the canister. I have tried changing bags and re-seating the bags to no avail.

\015\012A dirt collecting apparatus for a vacuum cleaner which is adapted to decrease a volume of a canister body thereby facilitating a handling of the vacuum cleaner and which has a dirt container that is easily detached from the appara ... Bosch BSG71360UC Bagged Canister Vacuum

My electrolux oxygen cannister has the "bag change" light on when there is a new bag. The light stays on when the suction power is high (to pick up small particles) and it won't pick up, but the ight goes off when the suction power is low (to pick up big objects). I changed the hepa filter, cleaned the motor filter and changed bags, but all that didn't help.

You may have a clog in the hose, and/or the inlet by the brush roll. A clog will turn on that light as well as a full bag. ... Vacuums

Electrolux upright bag light stays on even when bag is not full

I took the hose off and discovered it was clogged very tight. There was a piece of a 3 inch wire also stuck in there. Thank you for your quick response. Have a great New Year!!!!! ... Electrolux UltraLux 2000 Bagged Canister Vacuum

BAG LIGHT STAY ON AFTER I change the bag

... Bissell Powergroom Pet Vacuum

Bag change indicater staying on and vacuum smells hot when using

I suspect there is a blockage somewhere along the pipes leading to the dust bag.\015\012The bag full or bag change indicator measures how strong a vacuum is present at or near to the point where the bag is connected to the pipes. Under normal ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

The sweeper attachment does not stay connected to the rod or handle it slides back out rather than click or stay connected

You need to change the wand relaease assembly which has the metal locking pin to lock the wand\015\012\015\012http://evac ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Bag full light stays on so my electrolux diplomat lx vacuum wont start i push on/off swtch and light stays on

... Electrolux Lux 5500 Canister Vacuum

Oreck XL Silver-how do I re-attach the outside bag that holds the disposable vacuum bag?

If you provide me with the model # which is located on the back of the brush head ill provide you with the part # for the metal clip that holds the outer cloth bag onto the bag fill tube. Check on the top of the black tube or inside the cloth bag and ... Vacuums

I need to remove the outer bag from my Kirby upright. The inner bag was not attached and there is mung everywhere.

In order to remove the outer jacket from your Kirby do the following.\015\012Detach the top bag clip from the handle support. There is a plastic piece, just below the outer jacket, called the mini emptor. Turn it to the right to remove the enti ... Kirby G4 Bagged Upright Vacuum

I opened the cannister to change the bag and when I closed it the motor switch will not turn on. The second position which turns on the attachment for rugs still comes on. We thougth it was the switch so we ordered the part and it is still doing the same thing. Is there a reset button somewhere inside? The only reset button I see is on the attachment which is working.

It can be a few things. First check the overload protector located on top of the canister. If it has tripped the unit will not run. Push it in to reset. \015\012If that is the problem check the motor safety filter to see if it is clogged and caused t ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My kenmore vacuum 35922502 sensor dirt lights stay on red all the time. I have changed the bag, filter, little sponge filter, still they stay on. What is wrong? Lynn [email protected]

... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

I cant get my kirby to blow out...bag is removed from seating...its plugged in...i attach the hose to the place where the bag goes, but it wont run

I did get it to work! It was a struggle, but It finally hit that hidden switch just right. The hose attaches to where the bag goes, and it just wouldnt seat properly. I suppose there might be some wear there on the hose end that twists in . ... Kirby Vacuums

My wind tunnel keeps breaking its belt. The big one. The little one is properly attached. This is a recent problem so it has nothing to do with the rug height settings. I just broke two in the course of 15 minutes. The bag is NOT full, the brush/beater has been cleaned and properly attached Help.

Well will the brushes turn freely as they run in bearings if its got wool of cotton raped around the side of the brushs that will make them tight to turn and will brake every belt you put on it, in a flash,,,\015\012the other thing that causes ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Light is blinking and says "check bag" but bag is properly attached.

Hmmmm, Check bag you say. The manual for this machine shows it as a bagless model with a dirt cup that you empty. Is there an option for this machine that the manual doesn't show? ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Power shuts off when hose is attached. runs without hose attached. bag is empty, hose is cleared.

... Electrolux Epic 6500 Vacuum

My vacuum pole has an extra grey pole attached to it how do i get this off

Hi,\015\012this manual will help you out to get ridd off it http://www.retrevo.com/samples/Electrolux-Vacuum-manuals.html\015\012 ... Electrolux Vacuums

Hi. I purchased a Simplicity Freedom about 2 years ago. I have had it in for various repairs several times. One persistant problem that the repairman cannot seem to fix is the dirt does not fall down into the bag - it just stays up around the suction hole. I only use simplicity bags. Any suggestions would be most appreciated. thank you

You can let the vacuum run alittle longer so the bag fills up with air, also make sure that the bag in on correctly and you have the right bag for the unit. Let me know if this helps. ... Simplicity Vacuums

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!

... Miele Vacuums

Lid won't close. I started to put in a new bag but accidentally took out the plastic insert section the bag should attach to--so when I closed the lid over that, I must have pushed a little too hard. Now it won't com[pletely close! The plastic clasp is intact. Is there anything I can do before having to haul or send it for repair?

Your supposed to take out the plastic part that holds the bag but the way this unit is designed the lid will not close unless everything is inthere correctly so just make sure evverything in inserted correctly and keep trying! DO you still have your ... Electrolux Harmony Canister Vacuum - EL6985 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0374 seconds