Having problems with your Miele 251i ?

How do I improve suction

I have replaced the dust bag and the filters but the section is still poor.

Answers :

Repair Help & Product Troubleshooting for Miele 251i

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Bissell Proheat Turbo has poor suction and leaves the carpet too wet. Is there a way to improve the suction so the carpet will be left just damp not soaking wet?


Flip the unit over you will see a grey panel that looks like a V with 6 or 8 screws remove it and you will find a black cover I think it has 2 screws remove it and you will see a gasket seal for the bottom for the motor mine was white some times ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Problems with Dyson DC14 Animal Bagless Vacuum very little suction coming from the hose. cleaned filter and suction has not improved. Please help. Thanks


Two possible solutions come to mind. First off, there is a clog in your hose. If you have another vacuum, try using the hose on that one to **** it out.\015\012If that doesn't work, you may need to have the clutch replaced. Check your warran ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Filter Queen vacuum.. It doesn't seem like the suction is very good on my vacuum. Have had for a while. Ideas how I can improve suction


First eliminate other possible causes: check for blockages and leaks in \015\012the tubes, and obstructions or tangles in the rotating brush. This sort \015\012of thing comes under the category of regular maintenance\015\012 that you should be doing ... Vacuums

How do i improve suction on my Kirby g upright


... Kirby Ultimate G Bagged Upright Vacuum

I have a beam model 775a. I pipes were clogged, but I ran a plumbers snake and cleared the lines. The question I have is the suction is not the greatest, how do I improve it?


... Beam Industries 2775 Serenity Plus Central System Vacuum

Dyson DC07: When I first got this vacuum, it was so powerful that it lifted my area rugs off the floor. It is so weak it barely works. I have removed and cleaned the filter, but I can?t seem to improve the suction. What am I doing wrong? How do I fix it?


Hello,\015\012\015\012If your vacuum runs but still leaves dirt behind, the culprit could be the drive belt or an obstruction. If the agitator brush slips or won't turn, the belt is bad and needs to be replaced. If suction is weak when yo ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Hi, I have a DC01. When using the extension tools there is little suction. How can I check or improve this?


If there is little suction using the tools, then there is also little suction at the powerhead.\015\012\015\0121. Check the filters. If dirty, they need replaced. The company recommends replacing them every three months, but it does de ... Dyson Vacuums

My Dyson DC14 ANimal vacum cleaner has lost a lot of its suction, i have cleaned the regular filter but this does not seem to have improved it much. JAmie


Hi its Darran at Dyson.A loss of suction is most likely caused by a blockage or a dirty filter. If you have cleaned the filter, it would be worth checking the machine through for a blockage by following the user guide or the diagnostics i ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Uv200 very weak suction


Is there a blockage in the inlet pipe ??? ... Black & Decker UV200 Wet/Dry Vacuum

Loss of suction


Very simple fix. took me a good hour to figure this out but... first take off your brushhead. via popping the clip so all u have is the circle showing then turn on the vacum using the hose. put the hose over the hole where the brush head goes.. and g ... Dyson Ball DC24 Bagless Upright Vacuum

Insufficient suction in the hose apparatus of my upright


I have this same tool. Mine was found discarded by the side of the road and in obviously otherwise new condition. I took it home and cleaned the dirt path - it had a 'hair ball' inside - and it now runs like a top.\015\012\015\012Go at ... Hoover U5725-960 Bagless Upright Vacuum

Lack of suction even with filter removed.


I used to be a service manager for Electrolux. It sounds like possibly a clogged fan or hose. Take the hose off and check the amount of vacuum at the opening of the cleaner. If it has more suction without the hose, hold the hose in place backwards ... Electrolux UltraLux 2000 Bagged Canister Vacuum

No Suction I get great suction in the hose, but when I plug the hose back into the unit, there is no suction and the air flow indicator line goes completely red. I've changed the bag and filters. I took the small panel off the back and made sure there is no clog, and took the hose off to make sure there was no clog there. Still no suction. Please help.


I about to say that's always a clog of some sort that causes that ... Miele S7210 Bagged Upright Vacuum

Suction Cover The suction cover of my Eureka Deep Steam 2575A is broken - the tabs snapped off of the cover so I am unable to screw the suction cover back on. I need to purchase a new suction cover but can't find one anywhere. Anyone know what I can do? thanks


The exact same thing happened to me. i just called and ordered it from eureka. the number is 1-800-282-2886. the cover cost 13.07 and the s ... Eureka 2576A Steam Vacuum

I have a Dyson DC24/ all floors, serial number 530-US-D78353 that I have registered already w/ your company. The vacuum is generating suction from the main outlet (that goes to the canister)///but once I place the canister into position..there is no suction from the floor foot. The roller is working/spinning, but no suction..picks up nothing, I have cleaned and rechecked all filters and can not figure out why I suddenly have no suction. Appreciate your input and/or advise where there is a local


... Dyson Ball DC24 Bagless Upright Vacuum

Poor suction...continued Wow, thanks for answering so quickly! To answer your question, yes, there is suction at the screen, but it is very weak. I keep that screen clean. As a side note, I noticed that when I remove the top clear plastic cover (that would be part # 37 on the diagram, as far as I can tell) there is decent suction coming from the intake there--part 36? 30? it's hard to tell. But with the cover on, I feel no suction (from where it sucks up the water directly from the carpet),


Wish I had it in my shop, it is hard to figure your problem. I do know that you must have something out of place and you may have to take it apart to find it. You may feel some suction there at the top of the clear nozzle, but maybe it isn't strong ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

No suction I just replaced the bag, and normally after this I have a lot of suction. Now that I have changed the bag I have less suction that I had before. Not even enough to picj up dog hair. I snaked he hose and checked all of the connections. It seems to have an air leak but no amount of tape will fix this. I cleaned the filer as well with warm water and dried it and re installed but still absolutely no suction. I am ready to throw it out! Any suggestions would be appreciated


1, Does the blower (discharge) side blow bunches of air??Yes: Something is clogged from the bag to the hose end. Try blowing out the hose from the discharge side.Or: The bag is not properly seated. Make sure that the plastic piece is ... Kenmore 23313 Whispertone Bagged Canister Vacuum

No suction Just received my refurb. dyson animal bagless. Finally figured out how to get it all together, turned it on and there is no suction coming up thru the beater bar. The hair is just collecting around the bar and not going up into the canister. It appears all the suction is going thru the open red end of the attachment hose, which has a vented cover piece. Am I missing a piece or is there a switch to turn of the attachment suction?


So the red hose isn't connected to a part on the vaccum so like it is connected to the connester but not to an opening just above the beater bar, this is the only idea i can supply you with. good luck, maybe i got lucky and helped you out. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

No suction I am getting no suction on my central vac at the vac. I do not believe that the piping is plugged up, the vacuum is not creating suction. What are the causes of no suction at the vacuum and how do I take the top half of the Nutone central vac off?


Use the guide at builtinvacuum.com/flowchrt.html to find the issue and solution. Most likely you need to test it without any filter and be sure the bottom of the unit is attached :) To get access to the motors you need to unbolt the very top sides. ... Broan-NuTone CV350 Performance Bagged Central System Vacuum

Lost suction my DCO7 lost suction in the hose I started taking it apart and cleaning it and looking for clogs (probably more than I should have) and when I put it back together it has awesome suction in the hose but no suction in the base. It just pulls the pine needles up (christmas tree) but they never appear in the "bag" compartment and when I look they are just all gathered in a clump in the bottom by the brush.


Hi.\015\012\015\012Remove the sole plate turn the 3 plastic screws to unlock & lift off.\015\012\015\012Now remove the blockages that have accumilated from the oppening of short clear hose.\015\012Check you can turn ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Hi my dyson dc18 has great suction from wand but when you got to use the vac for floors little suction but wand still got suction even while vacuming floors is it suposed to stop suction from wand


My Dyson dc18 had the same symptoms. The wand worked well and the floor bar had no suction. After removing pieces & shoving my fingers into the machine (no blockage) I found the suction pipe rotates between two positions (floor and wand). It look ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Suction vacuum one day fine next not having great suction picking up big things but not feeling that deep down suction rolling too too easy changed bag, belt and cleaned roller it is like it is gliding over but not really getting deep visible cannot even tell I went over carpet


Don't panic! Easy fix!\015\012\015\012I was having the same problem, but I removed the base plate from the bottom of the vaccum (5 screws on mine), revealing the roller and the engine. Just behind the roller is an intake tube. Mine had ... Oreck XL Ultra Bagged Upright Vacuum

Suction loss? loss of suction in hose/attachments so not able to get to small hard to reach places. Suction not appearing to work right through hose?


Hi samdan... have you checked all the hose attachment vents .. ie Under the vacuum as well... How long is it since you replaced the filters?\015\012\015\012Try giving the Yellow cone inside a blow out. these tend to become clogged from ti ... Dyson DCO3 Absolute Bagless Upright Cyclonic Vacuum

NO SUCTION Hello There is pleny of suction in the hose,but there is no suction when vacuuming.


I fixed the very same problem about 15 minutes back. Mine is a 6660-900 but I believe all Hoover windtunnel uprights probably have the same basic design with minor differences. It has nothing to do with the belts. \015\012\015\012When ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0303 seconds