Having problems with your Miele Cat & Dog 326i Bagged Canister Vacuum ?

Changin the dust bag how do you do it?

\015 Note I have a nice new one to fit but its been so long I have comppletlly forgotten\015

Answers :

1. open the bag compartment by lifting the black catch near the handle.\015\0122. grip the grey plastic fitting on the bag, using the little handles on each side, and slide it out of the black holder. As you do this, part of the grey fitting remains caught in the black holder, and this causes the bag closure to cover the hole. When the cover is fully in place, if the grey bit doesn't release itself, you can help by slightly lifting the black tab where it's trapped.\015\0123. slide the new bag in where the old one came out, and close the lid.\015\0124. job done!
Repair Help & Product Troubleshooting for Miele Cat & Dog 326i Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Changin the dust bag how do you do it?

1. open the bag compartment by lifting the black catch near the handle.\015\0122. grip the grey plastic fitting on the bag, using the little handles on each side, and slide it out of the black holder. As you do this, part of the grey fitting remains ... Miele Cat & Dog 326i Bagged Canister Vacuum

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?

Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

The vacuum leaks dust around the joint between the bag and the vacuum. I unlatched the bag, removed and emptied it, and replaced it. However, the vacuum still leaks dust around the joint and the bag keeps working loose. How can I make sure that the bag is securely latched so that it does not leak or come loose? I have no manual. Thanks.

... Bissell 3065 Power Partner Vacuum

Miele S5000 dust bag holder came out with dust bag

... Miele Vacuums


Sounds like the bag if full and the is coming out from around the bag.make sure the bag is in correctly and tight ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!

... Miele Vacuums

I had a real heck of a time with the bag installation, because after the pop i zipped it up and started to use it and then the bag of the vac, not the replaceable bag fell off and i kept putting it back on but it kept falling off and when i looked inside the bag to reattach it to the vac cleaner i noticed that the dust was all inside. i haven't even used it that much as i keep it to do the upstairs bedroom only. i love that it is so lightweight and easy to use and i hope that someone can co

Mary, I have some wonderful news for you and your Oreck XL2600 Vacuum, I called 1 800 989 3535 customer service and inquired about your bag attach problem, it seems to be a docking station problem that "may" be warranteed, however if it is missing ... Oreck XL2600 Vacuum

I just notice when I went to change bag in my Kirby G4 that the whose inside was split open, which made all the dust fill up in the bag. How do I get a replacement part for this and what is that part called. Do I need to buy the whole outer bag?

You do not need a whole bag. The bag fill tube is replaceable. can be temp fixed with duct tape and new one installed at home. vacuum inside with another vac and you will be set to replace ... Kirby G4 Bagged Upright Vacuum

My Oreck is 10+ years old. The bag will not remain on the opening of the handle inside the bag. Dust goes into the cover rather than in the bag getting in the zipper which makes it very difficult to unzip the cover. Any suggestions?

Check and make sure bag collar is behind the two lips. if it isn't it will leak dust and make it hard to open. ... Oreck XL Ultra Bagged Upright Vacuum

Dust bag fitting Hoover, Telios, 1700

... Hoover Telios Canister Vac Vacuum

Change dust bag indicator frequently turns on

... Bosch BSG81360UC Premium Health Guard Bagged Canister Vacuum

When vacuuming dust does not go into bag but goes all over the place.

Used an elastic band to tighten bag onto nozzel. ... Nilfisk Vacuums

How to replace a dust bag holder on a hoover - Sebo X4 Extra Bagged Upright Vacuum

... Sebo X4 Extra Bagged Upright Vacuum

Faithful Sebo X1 upright, about 12 years old, stopped working today. I replaced old with new dust bag, checked all dust paths were clear, checked main brush was clear/clean, and drive spindle rotated OK with fingers. When power switched on, the two red indicators briefly flash on then off, but nothing more happens, motor does not start - even with power reaching machine. Tried removing all consumables, refitting and turning on a few times to reset, no joy. Removed base cover, both belts were i

At 12 years, this vacuum has had a good long life. I suspect the motor is shot, but it could be due to faulty wiring and connections. A bad switch, break in the power cord, and worn brushes in the motor are other causes.\015\012I recommend ta ... Sebo Automatic X1 Bagged Upright Vacuum

Dust bag was full and have changed it but not getting proper suction since bag change - why?

The extension tube is probably blocked.\012Check for suction with all the tubes off - if there is suction now then the tubes are blocked - be carefull not to damage them if you poke things in the unblock them. ... Miele Revolution 600 Bagged Canister Vacuum

My nilfisk action sucks for a few minutes then over heats and sometimes blows dust out and the bag explodes. The pipe is not blocked and I have cleaned filters and put a new bag in but still thesame thing is happening

Their has to be an obstruction in the system causing this issue ... Vacuums

Inside the my wd09450 there is a part missing which holds the dust bag on to the end of hte hose. the rubberized port of the bag should fint over it. where can I get one?

... Vacuums

My Oreck XL vacuum cleaner disposable bag does not stay attached. I had my husband put it on and again it came off. The cloth bag is always full of dust and suction is lost. What is the solution?

... Oreck XL Ultra Bagged Upright Vacuum

I was given a royal dirt devil model 103 and i am not sure if it needs vacuum bags? i have no owner's manual. Dust seems to fly out of cloth bag when using

... Vacuums

Dust bag light says full even when the bag is new

... Miele S251i Plus Bagged Canister Vacuum

When I turn on my Kenmore Premier 4.5 Peak HP 10.0 Amp after about a minute of running I get a burning smell. When I opened up the compartment that holds the dust collection bag, and remove the bag I found a filter. The filter was minimally dusty and has been cleaned. After sniffing around, I could not identify the source of the smell.

Dose it smell like rubber check your belt ... Vacuums

Hoover tempo upright is clogged. I can only vac for a few minutes, then I have to unplug it and turn it over and clean out the under part under the roller. It is totally stuffed with dirt and dust and carpet fibers. I have a new bag in. It is like it is clogged up inbetween the bag and the roller. Also gets clogged when using the hose. It is maybe a year old. How can I take it apart and unclog it?

Disconnect the hose and head and wands. Drop a quarter thru the hose, the handle sometimes clogs. peer thru the wands and inspect the elbow on the head for blockage as well ... Vacuums

The dust bag inside the outer zippered bag keeps coming loose and making a HUGE mess. does it lock down or something? Wife is ready to throw the whole thing away.

Hi\015\012On most types there is a bayonet type fixing - 2 lugs that line up with 2 slots in the bag seal plate.\015\012You usually need to rotate the bag 45 degrees to push the lugs into the bags plate, then rotate it so the bag is uprig ... Vacuums

I cannot keep the bag attached to the handle inside the cover on my Oreck XL Vaccuum. When it comes off dust blows out into the cover instead of the bag which makes it very hard to unzip the cover.

There should be a spring ring that slides up over the bag on the handle if thats missing try and use a couple of heavy duty rubber bands. however i do suggest you order the correct part. ... Oreck XL Ultra Bagged Upright Vacuum

We have a beam Serenity plus home vacuum system and there is no longer sucks. I removed the dirt from the bottom plastic container, but I also notice a sack or bag connected to the unit when I removed the bottom container and inside that sack there appears to be lots of dust. How do I access that and remove that dust without damaging the unit. I don't know how to do that

Hello. Let's begin by getting that dust and dirt out of your permanent filter. To do this, get a big clear plastic bag and pull it up aroung your canister, with the dirt receptacle removed. Then Grasp the sewn in weight inside of the filter and sh ... Beam Industries 2900 Serenity Plus Central System Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0418 seconds