Having problems with your Miele Cat & Dog 326i Bagged Canister Vacuum ?

Using hoover, stopped working. Bag very full so changed. Hoover seems very hot. Will not work. Checked fuse


Answers :

Give the vacuum time to coold\\ down, then try again. If it still doesn't work, take it to a repair shop to be checked.
\015\012When a vacuum is used for long after the bag is full, the motor can overheat to the extent that the motor burns out. This is one of the benefits of having a vacuum that shuts off when the bag is full.
\015\012You should also check the hose for clogs. Disconnect at both ends and drop a coin in one end. If it fails to fall through, there's a clog that needs removed. This is likely to happen at the canister end when the bag gets too full.
Repair Help & Product Troubleshooting for Miele Cat & Dog 326i Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Using hoover, stopped working. Bag very full so changed. Hoover seems very hot. Will not work. Checked fuse


Give the vacuum time to coold\\ down, then try again. If it still doesn't work, take it to a repair shop to be checked.\015\012When a vacuum is used for long after the bag is full, the motor can overheat to the extent that the motor burns out. ... Miele Cat & Dog 326i Bagged Canister Vacuum

My Hoover T5703 has suddenly stopped working. I was using it, moved it to another room, presssed the start with my foot - and nothing! I have checked that the fuse and electricity socket are both OK.I did knock it over a while ago and am wondering if I have broken a bit of plastic in the foot starter. It doesn't seem to 'click' as firmly as it did, but I cannot see how to take it off to check?


... Hoover Vacuums

My Hoover sprint 1700w has stopped working. I thimnk it could be the fuse. How do i get the plug apart to get the fuse out? Can you give me other possible reasons it could have stopped working?


... Vacuums

I have a Hoover U3330 001 upright vacuum, while using it today the power suddenly cut out and it stopped working. I have replaced the fuse with a new and tested fuse, but the machine will still not power up. please can you help?


... Hoover Vacuums

I have a Hoover Windtunnel 2 upright vvacum cleaner. During regular use my wife turned it on and it staarted cleaning, then all of a sudden it stopped and then started again then stopped for good. I unclugged the hose, cleane4de the brushes , blew the main filer and still cannot get it to start. The motor seemed hotter than usual. Can you help me? Lenny Rentz e-mail [email protected]


Actually, if you don't have continuity, then you have an open, not a short. ... Vacuums

Cleaner stopped working, changed bag still not working. Have checked mains fuse and liittle fuse on printed circuit board. When cleaner is on moving slider to the off positon the LED's glow red for a fraction of a second. Reset button does not feel as though it clicks when pressed, it does not seem to move. Many thanks, Hugh


... Panasonic MC-E583 Bagged Upright Vacuum

My vax power 8, 2200 watts 300 air watts 4L capacity upright Hoover is brand new, I emptied out the dust/dirt collecter and cleaned the motor filter yesterday for the first time, i switched it on and all fine, the brush is spinning and the hose is sucking, put the Hoover to work it's fine for about 30 seconds then then suction stops and its dead it won't collect no more, so switched off taken apart again and the motor filter is blocked and full of dust, so I unblocked it, do the same process aga


I had the same problem. It looks like the seal on the lid on the bottom of the cylinder has fallen out when it was emptied. There is no longer a proper vacuum being created so you don't get the cyclone effect and the dirt doesn't collect where its su ... Vacuums

Hoover upright has stopped working and tripped the circuit breaker. Where is the fuse located on the hoover ?


Most Hoover uprights do not have fuse. Some canisters doe but it is a thermal shutoff. When the vac overheats and cools down it restarts on its own. You very likly have motor damage, but if lucky you could have an obstruction in the fan causing ... Vacuums

My machine (Hoover Wind Tunnel - bagless) is only 1 yr. old. The agitator brush doesn't turn all the time. I know it's not supposed to turn when in the upright position. However, it only seems to work when I have the setting on high. When I stop, but have not put the machine in the upright position, it stops again and then slowly starts moving. Could the V-belt be worn out already? In the owner's manual it states that this belt is not normally replaced. The exact same thing happened with my old


Sounds like you should do two things:\015\0121- Remove and clean the beater brush of all debris as best you can. At the end of the brush you will see a hard rubber piece, at both ends, that holds it in place in the body of the vacuum.\015\012Add som ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Henry hoover my hoover has stopped working i have changed the bag and fuse and it still is not working i dont know what to do


... Numatics Numatic Hetty 200a Hetty Hepa Canister Vacuum Cleaner with Autosafe

When I stop the hoover it seems to deposit dust on the carpet. How can I stop this from happening?


It sounds like the vacuum is clogged, probably the hose. You'll need to remove the hose from the vacuum and use a vacuum with a blower, or an air pressure gun, to clear it. Do so from the tank side of the hose. You can also try placing the nozzle ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Riccar R-200 upright vac. My wife ran it for an hour without stopping and a full bag. The motor cut off and the unit won't turn back on. Is there a fuse to reset in the unit if it overhe


... Dyson Vacuums

Our Miele vacuum is only 2/3 years old and seems to have given up the gost, our previous one lasted 15 yrs. The machine starts ok and within 4/5 minutes the power drops down and the hoover comes to a stop and it may re-power itself again within minutes, as of today their is no power when the on button is pressed. What do you think the problem is Thank you.


There is a circut board that is going bad and not providing the power to run the motor. You will need to contact a Miele dealer for that part. It is the only board that is in this machine so they should just need a model number in order to get it ... Oreck XL Ultra Bagged Upright Vacuum

Hoover just stop working thought it may be fuse think motor gone!!?


Hi there,Sorry to hear you're having difficulties with your DC07. Like most Dyson cleaners, your DC07 is equipped with a safety device which shuts off the cleaner if it starts to overheat. This is often due to a blockage, or because the f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Henry the Hoover just stopped working. I have changed the fuse but still no luck, any ideas? thanks


... Numatic Henry Bagged Canister Vacuum

My 5200 hoover spin scrub all of a sudden stopped sucking in mid clean.i took the front clear cowling off and checked for blockage but couldnt see anything.there is nothing to these thiings,they are disposable it seems lol


Most likely your vent for the suction container is plugged or the suction hose can of or is broken at the connection to the tank nozzle (very common on these. Clean the machine thoroughly, and check that all hoses are tight and connected. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The brush on my hoover windtunnel stopped rotating.We already replaced the belt, and that did not seem to help


Check to see if the brush is frozen up. If you can not rotate it by hand you need to remove it and clean as best you can. Add a bit of WD40 at each end by the pieces that hold it onto the vacuum and turn by hand to be sure it is free.\015\012When r ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

NoSuckage !!! It seems as though my hoover steam vac has stopped sucking up the water. It is still spraying the cleaner correstly though, just won't suck it back up. I've emptied it several times and it was working properly up until a few minutes ago. HELP !!! Family coming in town tommorrow !!


I had borrowed a friend's steamvac due to potty training problems with my puppy. Today it stopped sucking up the water and I completely panicked! Immediately I googled hoover f5866-900 trying to find a replacement before I had to return the vac to my ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

Hoover Tempo Vacum Cleaner - 2yrs old. Just stop working. Checked all recomanded steps in manual. Looking for a location of fuse within appliance to reset.


I had a panasonic with the same issue. Turned out to be just a loose connection at the switch. ... Hoover Vacuums

We have a new hoover bagless that is a couple months old. The pet hair attachment stopped working. I disassembled it found lots of hair wound around the various rollers and removed - painstakingly thorough i might add. Problem is the brush still wont spin and now the belt seems loose - I think I put it all back together correctly but wondering if there is a trick to this?


Without the model number, I can't look it up, but this has a 1 years warranty on it, maybe take it to a warranty shop. Just take proof of purchase, model and serial numbers. ... Vacuums

My kirby just stopped working for no apparent reason. Everything seems in order but it won't switch on. I changed the fuse but this wasn't the cause. Any ideas why it isn't working?


It has a plug that attach's to the vacume itself , then that attach's to the wall, check that, try different outlets ... Kirby G5 Bagged Upright Vacuum

Vax hoover, it has sucked up a piece of cellophane and stopped working have changed fuse but still nothing anything else we can do


There may be a thermostat at the motor, it is supposed to protect the motor if it gets overheated. It may have opened up and it will have to be replaced if this is the case. You also need to remove the clog if you haven't already done so. ... Vacuums

I am using a hoover steam vac and the button keeps popping up to say that the water is full. That makes the thing stop sucking up water out of the carpet. Problem is, it has barely sucked up any water yet. Help!


Have u tried cleaning it out really good make sure any areas that water is **** up through are free of hair, lint ect. ... Hoover Vacuums

Dyson DC07 switched off whilst hoovering, It would not turn on, 1st it stopped rotating brush and than tuned off completly.. I tried ttoi change the fuse but still not turn on. Motor not runnung either.


Hi its Darran at Dyson.Our machines are fitted with a thermal cutout switch. This will activate if the motor on your machine becomes too hot. This is caused by a lack of airflow to the motor, which is caused by a dirty filter or a blockag ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not


Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0869 seconds