Having problems with your Miele S251 Flamenco II Bagged Canister Vacuum ?

Accessing motor Miele Flamenco II

\015 Hello, Read your previous posting. My vac stopped working. I am trying to get a look inside to see if the cord is detached or if motor is dead. Do I need to remove the top ( red) cover? The foot control panel (black) is already off. I am worried about breaking the hinges and popping those little springs? Thank you.\015

Answers :

I had the same thing happen to my S251. Open up the vac. There is a third hidden screw in the groove where the accessory door is hinged. It's really well hidden, use a flashlight. Once its open, you'll have access to the power cord and you can test its conductivity. I didn't really believe it could be something as pedestrian as that, but the retractable power cord takes a lot of abuse, and eventually it fails. Replaced mine and the vac works great.
Repair Help & Product Troubleshooting for Miele S251 Flamenco II Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Accessing motor Miele Flamenco II

I had the same thing happen to my S251. Open up the vac. There is a third hidden screw in the groove where the accessory door is hinged. It's really well hidden, use a flashlight. Once its open, you'll have access to the power cord and you can test i ... Miele S251 Flamenco II Bagged Canister Vacuum

How do I access the Miele 5000 motor

... Miele Vacuums

How do I rewire a miele flamenco II lamb ametek 115923 motor without the male plastic lead ?

... Miele Vacuums

My Miele Solution HEPA 5000 vacuum cleanr gives off a burning smell but will continue to run with a varying motor tone. I have not run it for more than a minute like this. I have reviewed responses to similar problems but cannot figure out how to access the motor. Can anyone advise?

... Miele S318 Bagged Canister Vacuum

Miele S5000 Cat & DoG - I need to access the motor housing because it sound like there is something flapping in there

... Miele Vacuums

My Miele Flamenco II has finally broken. The local repair shop says it needs a new motor - $159 + 40 labor, but that it's probably not worth putting that much into it. I'm guessing we've had it since the mid-90s. It has worked fine until now. Any opinions? Thanks.

... Miele S251 Flamenco II Bagged Canister Vacuum

How to access motor of Miele de luxe s228i - Vacuums

... Vacuums

How do I open a Miele s5310 vacuum to get access to the motor

Connaissez-vous la m?thode pour ouvrir un aspirateur Miele S5310 car le contacteur Marche/arr?t ne fonctionne plus.\012merci de votre aide R?my ... Miele Vacuums

How do I access the motor to my eureka capture? It has no suction at all but turns on just fine..filters are cleaned and there are no clogs or leaks on the hose....im thinking there must be something stuck in the motor possibly but there are soo many screws that im having trouble removing them all....whats the best way to access the motor to check it??

... Eureka Capture Upright Vacuum Vacuum

Miele Flamenco II vacuum cleaner suction indicator not working

... Miele Vacuums

Motor problem I just picked up a screw. It appears to be stuck in motor. The sound of the motor changed to a whirring noise and it started to smoke. How can i access the motor?

First six pictures HERE will let you know how to remove shell to see the motor. I would not recommend starting it before you get the screw out (you will need to ... Kirby Generation 3 Bagged Upright Vacuum

Hi, I bought a used Miele silvermoon vacuum on ebay and the motor just doesnt seem as powerful as my Miele red star

... Vacuums

I need to disassemble the cleaner to access the motor

Took me forever to find it but it is in the very bottom. You have to open the top where the attachments are stored. In the back in front of the power on\\off button down at the very bottom is a tiny screw. ... Miele S251i Plus Bagged Canister Vacuum

Dead motor? My 8 year old Miele S251i has worked fine, until I was recently vacuuming and moved the plug from one outlet to another. When I restarted the vacuum, it made rrrrr.....rrrrrr....rrrrr noises and smelled like something was burning. I turned it off, and it's shown no signs of life since. Sound like a motor problem? I've taken the cover off and looked at the cord and seen the motor, nothing looks obviously wrong, but I'm also not mechanical.

... Miele S251 Flamenco II Bagged Canister Vacuum

Samsung Quiet Storm Canister Vacuum VAC-9049 The motor will not run. Power is on to the motorized rug tool. How can I remove the upper housing to get access to the motor? I have removed the six visible screws, but the housing is restrained at the rear. I suspect there are additional screws under the power switch and cord retractor assembly, but I cannot remove that either. HELP!

Hi Daltm,\015\012Thank you for contacting Fixya. This is Anil.\015\012I understand that you need assistance n opening the Samsung Vaccum VAC-9049 motor. I will be glad to help you with it.\015\012Please go through ... Samsung Quiet Storm 9048R Bagged Canister Vacuum

BURNING SMELL My DC 07 has suffered from poor suction in the upright position for some time now but this morning it ground to a halt. It was if the motor had burned out. I turned it upside down and some small stones etc tumbled out. I tried switching on again and the motor kicked in but the smell was horrendous so i switched off immediately. If it's likely to be **** inside the motor area i don't no how to access it. I've removed for fixing screws but still unable to prise apart. Is it just the

Hi.\015\012\015\012Try this site http://dysonmanuals.llc.nu/ has service manuals covering removing the Dc07 motor. ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

How do I gain access to the motor of an Electrolux 2000 canister vacuum. The air intake on the motor must be partially blocked as there is a loss of suction and the motor makes that high pitched whine like it does when you cover the hose with your hand

Dismantling the vacuum probably won't help much, and reassembling can be a bear. \015\012To check the intake, remove bag and look into bottom of bag well. It there's a filter there, remove it and check intake at bottom of bag well. Clear if t ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Miele Cat & Dog vacuum gets VERY hot and is VERY loud. Hose has no restrictions and I have changed the dust compartment (motor) filter and the exhaust filter. It still gets hot when I run it with the top open and all filters removed, so I'm guessing the problem is with the motor. Should I be going into the motor compartment? If so, what am I looking for?

Hi\015\012\015\012The fact that it gets very hot could be due to a number of issues.,but the fact that it started making a very loud noise at the same time suggests that there might be more problems maybe brushes etc.\015\012\ ... Miele S514 Solaris Bagged Canister Vacuum

Smoke from Hoover Savvy U8185-900. Looks to be from the Motor assembly U8174-900. How to access motor in order to verify condition, have already removed all screws, but unabale to expoxe motor..

... Hoover U8185-900 Upright Vacuum

Miele Blue moon vacuum motor surging on and off and power light flashing. After many surges of the motor (on->off->on-> off etc), the motor no longer attempting to start as ferquently ie. now off for many seconds and may turn on for 1 second.. sometimes stops turming on and just power light flashes. There is also no voltage at the plug for the hose for the power head. I noticed that the vacuum first started having probs when hair was caught in the power head and the ovetrheating light went on

... Miele Blue Moon Bagged Canister Vacuum

Miele S7210 Has a blockage within motor area, rest of attachment clear

... Miele S7210 Bagged Upright Vacuum

Replacement Motor for a Miele S143 Vacuum Cleaner

Your vacuum should still be under warranty. If they dealer does not fix it for free call Miele directly. ... Miele S143 Bagged Upright Vacuum

Motor on mod 8975 making inordinate amount of noise disassembled 1 intake source at a time - still making noise can't figure out access to motor

The complete repair details and manuals for you bissel device is available on this link .\015\012\015\012 ... Bissell Vacuums

MRG 720-42/2 Hi, I have a vacuum Miele and the motor failed....and now I would like to buy a new one. The motor type is MRG 720-42/2 If you know where could I buy it, please let me know...... Many thanks is advance. Carlos Suarez [email protected]

... Vacuums

How do you replace a belt on the a Simplicity Synergy vaccuum? Removing the 2 screws on the bottom plate allows you to access the roller, but doesn't give you access to the drive motor. Any ideas?

... Simplicity 7850 Premier Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1472 seconds