Having problems with your Miele S251i Plus Bagged Canister Vacuum ?

How do I take my Miele S251i apart to be able to chenge the powercord?

\015 My Miele has a broken powercord but I can't figure out to remove the covers to get to the powercord\015

Answers :

\015\012HOW TO OPEN MIELE 251 VACCUUM:\015\0121-Unplug from wall and disconnect power cord\015\0122-Remove black switch panel at back of top panel:\015\012\011A-Use Phillips screwdriver, remove two silver screws visible\011between back of hinged top door and front of black switch\011panel
\015\012\011B-Push back of the panel down while pushing it forward\011(towards front of machine). There are two plastic notches and\011clips which are tightly fit together that you need to separate.
\015\012\011Once it releases, push it a bit more towards the front of the\011machine and lift off panel. It has wires connecting it to the\011main body so it will not remove completely.
\015\012\011C-Be careful not to lose the springs that simply sit inside of\011two plastic channels, one under each of the two switches.\011These are required for your witches to operate properly.
\015\0123-Locate screw at bottom of deep rectangular hole now revealed (under former location of black switch panels). Unscrew using Phillips screwdriver.\015\0124-Open hinged top panel. Locate two silver screws, one on each side of main housing. Unscrew using Phillips screwdriver.\015\0125-This will let you lift off the whole top assembly, door and main housing, revealing the plastic chassis and the motor unit within.\015\012
\015\012You now have access to the motor, wiring connector harnesses, circuit board and the cord reel.
Repair Help & Product Troubleshooting for Miele S251i Plus Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I take my Miele S251i apart to be able to chenge the powercord?


\015\012HOW TO OPEN MIELE 251 VACCUUM:\015\0121-Unplug from wall and disconnect power cord\015\0122-Remove black switch panel at back of top panel:\015\012\011A-Use Phillips screwdriver, remove two silver screws visible\011 ... Miele S251i Plus Bagged Canister Vacuum

Taking apart the wand - Miele S251i Plus Bagged Canister Vacuum


Try this linkhttp://www.totalvac.com/manuals/miele-vacuum-S2000-manual.pdf ... Miele S251i Plus Bagged Canister Vacuum

E series How did you take your rainbow e series apart? Do you have a manual? I've got a few pieces off mine but can't see where any other screws are to completly take apart to be able to look at motor. Thanks Kelly


The clear lenses on either side of the top part of the E-series Rainbow are removable. If you look at the each lens you will see two sections on the top edge of each lens that looks like this |___| |___| about 1 1/2 inches in from each end. Put a ... Rainbow E series Canister Wet/Dry Vacuum

Shopvac 90L400 quit working (4 years old). Thought the switch was bad but not the problem. I read that there is a fuse link in the motor that frequently burns up. I tried to take motor apart but not sure of the process. I was able to get to the motor but cannot pull it out of the armature. It appears I have to take the aluminum blower unit off the shaft (it appears to be pressed on with a retaining washer). Do I have to take it off to pull the shaft and motor assembly out? Is that where the fuse


By pass the switch and take power right to the motor leads.. that should tell you if the motor is ok.. have not seen fuse link on a vac motor.. graingers has new motors, but not inexpensive ... Vacuums

How to take apart a miele s5210 vacuum - Miele Vacuums


Found this:\015\012http://www.asciimation.co.nz/bb/2009/12/29/tearing-apart-my-miele-s5210-vacuum-cleaner ... Miele Vacuums

My infinity vac NV29 seems to have an extension wand stuck down in then tube and I am not able to get it out. We rented our winter home and evidently they found some type of extension that did not belong to it. Is there a way to take the handle apart in order to remove it? I am not able to use it with the handle and have to use the one on top of the canister, which is extremly difficult for me since I am disabled. Thank you.


... Euro-Pro Vacuums

I need to know how (if) I can take apart a Miele electric telescoping wand apart to clear some debris from it. Thanks!


Take a close hanger, Or a stick end push it though to clean it out. ... Vacuums

Changing belt How do I do that? It looks like I would have to take the screwdriver to the bottom and enter the engine compartment. I'm not sure that I feel confident to take this machine all apart and be able to get it back together again.


Its not the engine compatment take the screws out the cover 4 the roller will come off then u can c where the belt goes ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Hw to take miele hose SES130 apart


... Miele S514 Solaris Electro Plus Vacuum

How to take apart to replace power cord - Miele S183 Powerhouse Bagged Upright Vacuum


Hello,In order to access the cord on the Miele S183 upright, you'll need to first remove the handle from the vacuum cleaner. There is a large screw that holds the handle in place that is located under neath of the lower cord wrap hook. ... Miele S183 Powerhouse Bagged Upright Vacuum

Torn Hose The hose on my Dyson is torn right at the top where the the accessories connect. I was able to take the connection apart and shorten the hose, but I don't know what to use to reattach the hose to the black fitting. It looks like it was glued...not sure what kind. Any ideas?


Duct tape ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Taking apart a miele s2000 vacuum


... Miele Vacuums

My Hoover SteamVac has been doing a wonderful job but in two instances, after emptying the dirty water and reattaching the reservoir, the machine has lost suction. The first time I was able to make it work again after taking it apart and putting it back together about 10 times. I don't know what I did that fixed it but as long as it worked again, I was happy. But it's happened again and I can't get it to vacuum. I can see that it isn't clogged. Can you please help me????


Look for the lower tank filter to be clean. also make sure the lower tank lid is on properly. latch when installed on machine. Make sure the front panel duct is on the lower tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

There is something stuck in the handle of my Miele vacuum. I unscrewed all the screws hoping that I could remove the hard plastic handle from the hose. I was only able to flip up a piece of plastic where the switch is. Should I pull harder to pry the plastic apart? I was afraid I'd break something. Thank You, Chrissy


... Miele Vacuums

How to I take apart my miele in order to see if the belt needs to be replaced It's a 183 dark blue model


... Miele S185 Powerhouse Bagged Upright Vacuum

I need to take the canister apart to screw the filter housing back in place. I can't figure out how to take the canister apart or another way to screw the filter housing back in place.


... Tristar Vacuums

I need to take the canister apart to screw the filter housing back in place. I can't figure out how to take the canister apart or another way to screw the filter housing back in place.


You did not identify your model and the TriStar website does not provide manuals. They do have a FAQ page which does provide some illustrated guidance which may be helpful. See here:\015\012\015\01 ... Tristar Vacuums

Bissell Healthy Home Vacuum brush stopped working. The hose attachment works fine, just the brush on bottom. Without taking it completely apart, it shows no sign of blockage. Any suggestions? Or, will I have to take it apart?


You will have to remove the bottom plate to get at the brush. The drive belt either slipped off or broke, this will have to be replaced. ... Vacuums

Miele Galaxy vacuum hose and wand don't come apart


... Miele Blue Moon Bagged Canister Vacuum

Cable stuck in machine (sphera 20). How do I take apart to release cable please? I cannot see any visible screws to take the machine apart. Cable will not retract or come out of machine


... Bosch Vacuums

Miele HS03 S251i Brush not spinning


... Vacuums

Is it possible to take the Hoover Brush Block Assembly F7220-900 #48437029 apart so that I can thoroughly clean inside the block? It looks like it could, but I don't want to break it by trying.


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Will not steam. before taking apart is there a


Hi,Look at the manual...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...E ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

How do I take apart my Bissell 7920 ProHeat Pro-Tech


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

How do you take apart a electrolux epic 3500 to take out the circut breacker


... Electrolux Epic 3500 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0399 seconds