Having problems with your Miele S4210 Carina Bagged Canister Vacuum ?

Noisy vacuum that wont pick up properly

\015 My vaccuum is about 4 years old and when using it the other night it started to make alot of noise and now won't pick up properly. I've changed the dustbag and filters but still thes same.\015

Answers :

Your vacuum is still under warranty. Call Miele or the Miele dealer you bought it from. They are obligated to repair your vacuum.
Repair Help & Product Troubleshooting for Miele S4210 Carina Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Noisy vacuum that wont pick up properly


Your vacuum is still under warranty. Call Miele or the Miele dealer you bought it from. They are obligated to repair your vacuum. ... Miele S4210 Carina Bagged Canister Vacuum

I have vax 1800 pet vacuum. It is picking up fine but very noisy. I have replaced the belt in the past and the noise started then. On looking at it closely today I noticed brushbar was getting worn where it slots in at the side so I suspect it wasn't fitted in properly after replacing the belt. Now in properly but still making terrible noise. There is a bit of a rubbing noise when brushbar moved round. Do you think the brushbar needs replaced? How do I lubricate the bearings to try that bef


Spray the end of the brush-bar were the bearings are with WD-40 if that solves the problem replace the bearing when it starts screeching.. ... Vacuums

No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!


I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

** suction The best way to describe it is that when I was vacuuming I could see dust clouds at the front of the vacuum where the light is swirling around in the air. It was like it was blowing dust around instead of picking it up. I checked the tubing and found that it was clogged with some paper and hair ***** etc.... So I cleaned it out and tried it again and it still was not picking up properly. I had my husband take all the tubing apart to check for other clogging and there was none. When I


You have an airflow problem. You may still have a blocked intake or tube, also check the filter. The air is supposed to go in the bottom (of course) and I'm sure you k**w where it goes out. You probably can **te a reduction in exhaust. If this is ... Oreck XL Ultra Bagged Upright Vacuum

My bissell vacuum is blowing dirt out of the bottom wont pick anything up??


... Vacuums

I recently ( approx. 2-3 months ago ) purchased a dirt devil. Now it is not picking up properly. When I push vacuum forward it picks dirt up a little bit, when I pull it back all the dirt falls out of the bottom. I replaced the filter today and it has not solved my problem. I dont know where my warranty is. Can you please help me?


Hi sounds like your line is stopped up somewhere , check ur suction an make sure your brushes are spinning, if they are try a wire clothes hanger to the hose at the bottom hose to dislodge anything that mite be stuck ... Dirt Devil Vacuums

My Morphy Richards vacuum cleaner (2 years old) will not pick up properly and also cuts out about vacuuming one carpet but then starts again later. Will I need to call our repair service?


Here are a few tips to try before you call a repair service.\015\012\015\012Most people think that putting their vacuum on the lowest setting picks up the most dirt. If you have medium to shag carpet, putting it on the lowest setting wil ... Vacuums

I have the bissell pet vacuum and it wont **** up anything I cleaned everything and it still wont pick up


It could be the belt. It the belt is worn or stretched it won't pick up the way it should. I would try changing the belt if you haven't recently. You can get the belts you need and the manual here: ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

My vacuum used to work great but now it wont pick up anything


You must look for a clog in the hoses and where the hose goes into the unit ... Vacuums

Why wont an Oreck vacuum pick up rock salt from a commercial entrance rug


... Vacuums

My vacuum is not suctioning properly, o hooked it up and cannot seem to pick up any dirt.


Make sure that the bag is empty, that there are no pieces of paper/large debris in the hose. Also, lift the front of the vacuum and while your hands and fingers are clear of the brushes, turn it on to see if the brush is turning. If not, you'll nee ... Vacuums

This vacuum is a month old, I would not recommend anyone else to purchase one. It tried to eat my carpet; now it wont even pick up anything. How is this my fault.


Its not your fault and try to fix it and recomendit to anyone\015\012\015\012\015\012\015\012:) ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

How do i fix my bissell myself cause it wont **** up trash after i picked up the lager things that dont go in a vacuum


You may of damaged the belt that moves the brushroller. Also check for clogs in the system, there could be something blocking.If you take apart, make sure to be mindful of what screw goes where. ... Vacuums

Wont pick up water - Vacuums


Unless its a wet dry vac you should not use a normal vacuum to **** up water, you could kill a normal machine that way ... Vacuums

I have a eureka the boss vacuum it wont pick up. I cleaned out the tubes the belt is good. the tubes are clear. What else can I do?The bag is only 1/4 full


... Eureka Vacuums

Wont pick up water or solutuon from floor - Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Dyson vacuum wont turn on at all, switch has not been working properly for a few months.


This sounds like a classic Dyson issue that I deal with time and again. While I may be way off base, take a look at my article http://www.fixya.com/support/t3143954-not_turn ... Vacuums

Hello I can not find my manual for my vax vs19 swift vacuum cleaner and I am having problems with the cleaner not picking up. It is a 1600w machine and is fitted with a hepa filter, my son took it apart and without the manual it is difficult to reassemble not sure if he has put it back together properly.


Check out this site;\015\012\015\012http://www.vax.co.uk/support/vacuum-cleaner-user-guides\015\012\015\012Scroll down to the one that's applicable. ... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

The vacuum suction still works but the brush wont turn. It still looks like the belt is intact and attached properly.


The problem with Dysons is that the belt breaks and sits in position.If you can turn the brush by hand, with little or no resistance then I would say the belts broken.If in doubt take the cover off and look. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My vacuum has good suction the belt is good and i cleaned all the filters but it still wont pick up anything or pull itself


Sounds like its self propelled, if so check your belt and self propelled switch. John ... Vacuums

Hoover wind tunnel not picking up properly - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


My turbopower 6200 does not seem to be picking up. The beater bar I don't think is working? ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover wont pick up - Hoover WindTunnel Pet Rewind Upright Vacuum


... Hoover WindTunnel Pet Rewind Upright Vacuum

Hi, have an irobot roomba 530 love it. But it charges ok, when finished the brushes are dirty, but does not appear to be picking up, actually vacuuming into its bin. Asked support in Australia, they recommended unscrewing bottom plate & cleaning of any fluff - which I have done. Still not working properly HELP


Remove the pickup bucket and dump it, then grab the little yellow strip in front of the pickup bucket and clean the hepa filter for free air flow. ... iRobot Roomba 530 Robotic Vacuum

Red "bag is full" indicator shows even though new bag has been put in and vacuum cleaner wont pick up. Also floor adjustment does not adjust. This is for a powerforce model 3522 series


The red light tell you that it is sensing a full bag. But a clog in the hose or the inlet down by the brush roll will also do this. ... Vacuums

Dyson ball not picking up properly and very noisy


Is the beater brush spinning? Is the sole plate that is removable and covers the bottom side of the beater brush housing installed properly such that there are no gaps between it and the housing? Is the hose that connects the beater brush housing to ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2265 seconds