Having problems with your Miele S7280 Bagged Upright Vacuum ?

Miele airflow indicator Miele S7280 Bagged Upright Vacuum issues


Answers :

Repair Help & Product Troubleshooting for Miele S7280 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Miele airflow indicator Miele S7280 Bagged Upright Vacuum issues


... Miele S7280 Bagged Upright Vacuum

Miele vacuum bag holder replace - Miele S7280 Bagged Upright Vacuum


... Miele S7280 Bagged Upright Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

Miele Red Velvet Vacuum bag indicator is showing full even with a new bag.


... Miele S558 Red Velvet Bagged Canister Vacuum

Miele upright not sucking up? - Miele Powerhouse Plus Bagged Upright Vacuum


Sounds like there is something blocking the main airway. I doubt its the filter. You may have to partially disassemble it. Maybe a hairball or something is blocking it I sucked up one of my daughters thin socks one time, had to take it apart to g ... Miele Powerhouse Plus Bagged Upright Vacuum

My Miele vacuum full bag indicator


Check the suction at the vac, without the hose, if it is strong, then you hose is clogged. If it is weak, filters could be the problem, one is the back where the bag sits, the other is on the top, you can see it when you raise the lid. ... Vacuums

We understand that your problem is: I currently own and use on a regular basis the Kenmore Progressive upright bagged vacuum. Model number 116.35923500. The headlight flickers and the intelliclean light stays red. Ive tried cleaning the intelliclean sensors, changed the bag, and cleaned off the agitator. Is this a power issue? Should I take it to the store? Any suggestions would be greatly appreciated


Welcome to fixya\012\012Hello\012\012 \012\012I have a solution for this ... Kenmore Progressive 35922 Bagged Upright Vacuum

I have the Miele S7280...the one without the clog hatch on the back. I took the bag cover off, then continued the remove the screws and cover underneath it to detatch the top from the bottom. Found the clog and cleaned it out. Heres the problem...now the power nozzle light comes on and the vacuum "on" is lite up red, but it will not come on. Checked the filters and the bag. It certaintly seems like the top and bottom are meeting up to latch into each other, but I have no power. Help!!


... Miele S7210 Bagged Upright Vacuum

Miele S7260 wheel fell off - Miele S7260 Bagged Upright Vacuum


... Miele S7260 Bagged Upright Vacuum

Service Manual Miele - Miele S7580 Bagged Upright Vacuum


... Miele S7580 Bagged Upright Vacuum

Miele S7210 on/off switch jammed - Miele S7210 Bagged Upright Vacuum


... Miele S7210 Bagged Upright Vacuum

How to replace the vacuum belt - Miele S7210 Bagged Upright Vacuum


... Miele S7210 Bagged Upright Vacuum

I am looking for a parts diagram for a Miele Upright S7280 (Salsa) vacuum


See if there is a manufactures web site and inquire if diagram is available or just Google for info with proper make and model.Fist just search for vacuum diagrams then refine search for your vacuum but this not always easy can be confusing so mi ... Miele S7280 Bagged Upright Vacuum

Suction is low - Miele S7260 Bagged Upright Vacuum


Here is the manualhttp://www.totalvac.com/manuals/miele-vacuum-S7000-manual.pdf ... Miele S7260 Bagged Upright Vacuum

Brush is not spinning - Miele Powerhouse Plus Bagged Upright Vacuum


Usually, this is caused by the brush assembly end bearings becoming bound up with string, thread, and hair. Remove the brush and clean the bearings and end shafts. Oil them lightly with 3-1 oil or similar. Check the condition of the drive belt and re ... Miele Powerhouse Plus Bagged Upright Vacuum

How do i detach hose to remove blockage? - Miele S7210 Bagged Upright Vacuum


Lift the hose out as if you were going to use the attachments. At the base of the hose there is a swivel to adjust the hose 90 degrees. Where the lower section of the hose attaches to the swivel you will see that if you give the hose about a quarter ... Miele S7210 Bagged Upright Vacuum

Does it have a seprate hose or just a hoover - Miele Alternative Bagged Upright Vacuum


Download the manual off the link belowhttp://www.totalvac.com/miele-vacuum-cleaner-manuals.htm ... Miele Alternative Bagged Upright Vacuum

How to take apart to replace power cord - Miele S183 Powerhouse Bagged Upright Vacuum


Hello,In order to access the cord on the Miele S183 upright, you'll need to first remove the handle from the vacuum cleaner. There is a large screw that holds the handle in place that is located under neath of the lower cord wrap hook. ... Miele S183 Powerhouse Bagged Upright Vacuum

..Miele S7260 Bagged Upright Vacuum stuck in down position


... Miele S7260 Bagged Upright Vacuum

I have a miele S712 (2 yrs old worked fine yesterday) - I had been doing some diy work inside and had the vac on just to reduce some of the dust in the air - after a while the vacuum fizzled out. I guessed it had overheated and took it outside to cool down - when I tried to turn it back on pressing the power button gives it power and it starts to **** but it won't STAY on, soon as you release the power button it stops, and the orange bag indicator is showing full. As I have a compressor I took


You have got dust in the micro switch and it is not latching on, if you look at this and clean it, that will solve your problem, however blowing the motir has probably wrecked the motor bearings. ... Miele Vacuums

Miele Flamenco II vacuum cleaner suction indicator not working


... Miele Vacuums

Need technical help for my miele s2180 momentum canister vacuum .Bought a display open box at fure shop..Came with a filter bag..there are no tears in the bag...Perhaps they put the wrong bag..Anyway after 30 minutes of use..The motor stopped working ..so I opened up the unit only to see,.the dirt was everywhere inside the vacuum...only a little was in the bag itself..can you hepl..Dave


... Vacuums

We have a Kenmore Progressive Model 116 Upright bagged vacuum with Hepa filter. It's at least a couple years old. For quite some time now when ever we use the vacuum the vacuum motor will shut off nafter about 5 min. of use. We then need to let it sit for awhile and then we can run it again for another 5 min. The bag has been change. Any one have any ideas how to fix this?


I suspect that you have a restriction. The motor sounds like the thermal break is stopping the motor before damage, due to heat.\012You must witness that the entire suction and discharge side are clear. This is not always very easy, but necessa ... Kenmore 34612 Bagged Upright Vacuum

I have just replaced the bag in my miele and the indicator is showing that the bag is full. The air coming from the exhaust is hot and the machine is making a higher pitched sound as it does when the bag is full. When the hose is detached, the indicator registers as empty and there doesn't seem to be a blockage.


... Miele Vacuums

RE: Miele Art Vacuum When putting on a new bag there's a gap between the bag and the fitting that's a part of the vacuum itself. Is there supposed to be a gap or is there something I'm not doing that will fasten the bag to the fitting?


... Miele ART S920 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1643 seconds