Having problems with your Miele Vacuums ?

How do I reverse the air flow on my misled vacuum cleaner?

Answers :

Repair Help & Product Troubleshooting for Miele Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I reverse the air flow on my misled vacuum cleaner?

... Miele Vacuums

I have a Kenmore canister vacuum - model 25614506. Some time ago, I was not able to turn the vacuum off with the on/off switch, but could still use the vacuum. Turned if off/on by pulling the plug. The other day when I went to plug it in, I heard a pop. Now the sweeper runs but the vacuum cleaner does not **** - no air flow. What could be the problem. The cleaner is only 4 years old.

The motor has an inline fuse ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

I'm trying to use the reverse flow hole on my Miele s712 to blow up an air mattres. None of my fitting appear to fit so I can use the hose. Is there something I'm missing? Is there a trick of the trade? Or am i missing some gear. It's new, out of the box but I just can't get the hose onto the reverse flow. The Poduct is a Miele S712 vacuum dispite what this system has allowed me to enter. ; )


How to install the back hepa filter on canister vacuum cleaner. We are not sure which direction the air flows and therefore which way the arrows should point. Should the arrows point into the vacuum cleaner or point towards the outside?

The arrows in this case should point out of the machine. not into the machine. This is because you want the black rubber seal to seal on the machine and force the air through the filter. Good luck. Mark ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I replaced the motor in my 6500SR Epic vacuum cleaner. Now I have 3 clear plastic hoses for air flow. I know where two of them go, Im not sure where the third air hose goes? Jan

All three are connected to the control valve assembly.\015\012The long one goes through the hole in the bag container and to the door and inside.\015\012One goes to the bottom of the bag container.\015\012The last one goes to...I ca ... Electrolux Vacuums

How to reverse air flow on a canister vacuum

... Kenmore Whispertone 23312 Bagged Canister Vacuum

The beater bar on my Dyson DC14 All Floors Bagles vacuum cleaner doesn't turn. There is no hair or thread caught up in it. All air-flow areas have been checked and there are no blockages that we could find. Any suggestions?

If it is not on the bare floor setting then you most likely have a belt issue it is not an easy fix I am sorry to say if your mechanically inclined I can tell you how to replace it. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Does the dyson dc39 have reverse air flow - Dyson DC39 Animal Canister Vacuum

... Dyson DC39 Animal Canister Vacuum

My 4 yr old Nilfisk vacuum cleaner has been working fine up until now. But suddenly, it has hardly any suction power and also, hot air seems to be coming out thru the vents on top and also thru the space that's normally used for blowing air OUT....the outlet with the retractable cover located close to the part where the power cable comes out of and retracts into. I've checked the filter and the hose and they are not clogged...I have also put in a new bag. Not keen to buy another vacuum cleaner u

Hi there SmartAlec from Nelsonvacuums.com.au here.It sounds like a blockage of some kind. The best way to find it is to set the machine up for normal vacuuming and remove o ... Vacuums

Canister vacuum, as soon as hose is on, or air flow is disturbed, the vacuum shuts off. yesterday the vacuum sucked up tree netting, we pulled it out, and now the vacuum has those symptoms.

This is most likely due to a broken or worn out Control Valve Assembly located inside the vacuum. \015\012First, check the bag and afterfilter. If bag is full or pores are clogged, or the afterfilter is dirty, replace them. Try using the vac ... Electrolux Epic 6500 Vacuum

I have an air matress with no air pump.but i have a vacuum how do i reverse the suction on it

... Bissell Cleanview Helix Deluxe Bagless Upright Vacuum Cleaner 21K3

I recently purchased a house with a Filter Queen Central cleaning system model FQ-7500. My problem is that instead of sucking air it blows the air out. How do I reverse the air flow?

Never seen this model but it is on of two things,the hose is hooked up wrong or the motor is either switched in reverse or the motor has been reversed with wire leads ... Filter Queen Majestic Canister Vacuum

We have the Kenmore progressive direct drive (bagless) and have had it for about 3 years. We have taken good care of it, and paid quite a bit for it hoping that it would last for a good long time. It has started making a noise that seems to be an overflow air type of noise coming out of a bottom air outlet opening for when the air flow is blocked. We have looked into clogs, changed filters, and the whole works, to no avail! Quite Frustrating since I love this purple vacuum! The machine started

There has to be a clog or block somewhere - if the motor works, it should work did you try a wire coat hanger to go up in further where you cannot see?Bets regardsCk ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

How do I get my vacuum cleaner to blow air instead of **** air? I want to use it to blow up an air bed - Nilfisk King 240

... Nilfisk Vacuums

My infinity vacuum has an air flow restriction/no suction

... Vacuums

Ultrasilencer Green Vacuum Cleaner to blow air instead of ****

... Electrolux EL6984A UltraSilencer Green Canister Vacuum Cleaner

I have a Z345 Electrolux cylinder vacuum cleaner, from the 1970s probably, but not used much. I have lost the guide. I forgot to change the bag before it was full. Smoke started to come out - smelling of burnt paper, not rubber. So switched off. It did not blow the fuse, and may be OK. I wish to inspect it. How do I open it up? Alos I have an air filter and a motor filter for it. I have often changed the air filter on the top. How do I get at the motor filter, if there is one? Than

Good day! OK you have to is replaced the bag and that's it.And don't forget to change the bag again to avoid that problem.Thank you ... Electrolux Guardian Bagged Canister Vacuum

Just bought a Vax u88 AM B Air Multy Cyclonic Upright Vacuum Cleaner don't know how to move handle to vacuum carpet

Put your foot on the head then pull handle down ... Vacuums

Bissell proheat is blowing not sucking air - Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Samsung vacuum cleaner model sc4130 air track is not blowing air and has a very loud noise

... Samsung Vacuums

Is it possible to make the Miele cat and Dog vacuum cleaner blow air out in order to fill an air bed?

Sorry, but the short answer is: no! ... Miele Cat Dog Plus S511 Bagged Canister Vacuum

I have a Model 116.35922500 Kenmore upright vacuum cleaner. It makes a loud air noise when using the vacuum. I have disconnected and removed the hose to see if anything is lodged in the hose and it appears clear. It makes the noise when the hose is connected. When I remove it, the noise stops. When I place my hand over the hose, the nose re appears. I sounds as though the noise is coming from the fan or internal parts of the machine. So, when there is a load or pull on the machine, it mak

... Kenmore Progressive 35922 Bagged Upright Vacuum

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano

... Electrolux Vacuums

I NEED A FILTER/ AIR CLEANER FOR WAP VACUUM CLEANER WET/DRY WITH MODEL # WAP ST-15. I NEED TWO PIECES. Please email me the price for the filters. And the delivery lead time. ASAP. THANK YOU!

... Wap 28538 Wet/Dry Vacuum

Hi I’ve got a Panasonic vacuum cleaner MC E468 1600W a few years old now but works well up to recent problem. Not picking up I checked the obvious things and found excessive air being sucked in around the hose housing at the back of the vacuum (as it enters the waste bag) On inspection it appears to me as if there should be some sort of gasket that may have perished and been sucked in, however I can’t identify any such part. Any thoughts on what the problem/solution may be will be appreciate

The hose on the back might be loose - check to see that the hose is not obstructing anything where it screws in at the back - or indeed the screws may be loose themselves; some of the MCE 468 models had an additional ring washer that sits between the ... Panasonic Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0952 seconds