Having problems with your Miele Vacuums ?

Overheating and not sucking properly

\015 It keeps over heating and is not vacuuming well\015

Answers :

You most like have a blockage in the vacuum hose or the filter is choked with dust. Clear the blockage and filter and the suction will return to normal.
Repair Help & Product Troubleshooting for Miele Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Overheating and not sucking properly


You most like have a blockage in the vacuum hose or the filter is choked with dust. Clear the blockage and filter and the suction will return to normal. ... Miele Vacuums

My kirby g series doesnt **** properly anymore. A friend borrowed it, returned it with a scratch and now its nto sucking like it use to. My son took the head nozzle off, could it be not put back on properly?


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=722170\015\012Generic problem for all Vacuums\015\012My Kirby G series doesn’t\015\012Posted by m ... Vacuums

NoSuckage !!! It seems as though my hoover steam vac has stopped sucking up the water. It is still spraying the cleaner correstly though, just won't suck it back up. I've emptied it several times and it was working properly up until a few minutes ago. HELP !!! Family coming in town tommorrow !!


I had borrowed a friend's steamvac due to potty training problems with my puppy. Today it stopped sucking up the water and I completely panicked! Immediately I googled hoover f5866-900 trying to find a replacement before I had to return the vac to my ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

Vacuum cleaner hi.this is 10 yrs old and not overly worked.bags are changed regularly and the micro filter has been changed at least three times over ten years.it goes well for about 2o minutes then loses power with not much "suck"after that.sometimes shutting down completely,because of overheating i presume,or just carries on at a much lower'"suck".have tied shaking bag inside but no luck.any suggestions out there or can you tell me the agents support office for new zealand[auckland].many thank


What brand vacuum is it? ... Vacuums

I have a new Hoover Dual V steam vac that I bought from a neighbor who only used it once. I have only used it once since then and it worked great. This time, because I am pregnant, I bought some non-toxic cleaner that was much thicker than the very watery Hoover soap. This vac has a wash option and a rinse option. The rinse option works (sprays and sucks properly), but the wash cycle doesn't at all-neither soap nor water comes out. Nothing comes out, but it still sucks. I took everything o


There's a powerful electric motor attached to a fan that sucks in air.Did you checked and cleaned that motor.If the dirt is got stuck up ion the motor then the motor will not spin as per its regular speed.For rinsing the motor spin on one cycl ... Vacuums

My vacuum cleaner is not sucking. It's overheated and stopped


In this case it is motor problem, you can sort out only by calling the technician. Call the customer care and check out the cost for repair, if it is very high you can go for a new one and be in peace of mind.Thank you. ... Sanyo Performax SC-U126 Vacuum

Hoover hygiene not sucking properly


... Hoover Vacuums

Hello- My wand has lost a lot of it's suction. I am sure it's clogged somewhere. I cleaned everything after watching a video on U Tube, but it is still not sucking properly. My model is the Dyson DC28 Animal air muscle. I have only had it a few months. Also, I am not having any luck finding a local Dyson repair shop. I live in Pella, IA. Thank you, Kim


You do have a clog ... I feel certain. I have never worked on a Dyson. Please continue with your disassembly until you find that wad of chewing gum and cat hair and tell us how you did it.\015\012\015\012Im sure you will find a clog som ... Vacuums

There is no suction from the head on the floor. The hose is sucking properly but not the floor brush. I have checked for blockages and can't find anything - any ideas?


I have exactly the same problem!\015\012i think it is something to do with the transfer hose that changes the suction from the hose to the brushes ( it is at the bottom left of the machine as you look at it from the front! ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a dirt devil ultra vision turbo that is sucking up properly but it is blowing dust out instead of clean air. Is this a problem with my filter? Somehow it is bypassing it.


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

Hello, we have a Miele cat and dog turbo 5000 vacuum cleaner which we bought in December. It has just started blowing air out of the grid on the top of the cleaner instead of sucking from the tube. The whole top section which is opened to change the bags doesn't seem to want to clip down properly either. Do you have any ideas> I'm gutted as it was so good until this happened. Thanks Michelle.


The lid not closing properly is almost certainly the cause of your problem. Without that lid sealed tight to the body you will get no suction through the hose. So, the question is: why isn't the lid clipping down properly? Did you just change the bag ... Vacuums

Morphy Richards Pets vacuum cleaner, less than one year old. Not sucking, overheating, claims bag is full when it is new. I have looked for blockages but the hose is clear. Can't find anywhere in Aberdeen to repair it


Discovered I had a 3 year warranty on it so got a replacement. Thanks for your helpful advice! ;) ... Morphy Richards Vacuums

I took the cover off the brush so I could cut off all the hair that was wrapped around it (vacuum was working fine, I just noticed the hair). I pulled the brush/spinner thing off one side, cleaned everything, popped it back in where it belonged, and tried to make sure the belt was in the proper alignment. However, when I turned the vacuum on, it makes a horrible noise like I'm sucking up rocks. What have I done wrong in putting it back together? It seemed simple...


The ends of the brush roller have to go in in a certain position.each end has a different look.make sure the match up to the seats on the roller guides and make sure the belt is centered.the belt will center itself by turning the roller by hand in on ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Electrolux z5525 vacuum cleaner not sucking properly


... Electrolux Vacuums

Doesn't work Our home was built and finished in August 07.  The central vac doesn't work.  There is supposed to be a slot that opens in the kitchen where you sweep the dust and it sucks it up.  Also, the mounted unit on the garage wall has a hose that goes up into the house but there is a hole open at the bottom of the unit.  Where can I get someone to help us?  Or, is there an installation manual I can download to see if the builder did it properly.  He stole our solar heater for our pool and s


Has the slot in the kitchen (VacPan) been installed? Or is it just not working? There should be tubing coming into the unit in the garage, and possibly another piece to exhaust the unit to the outdoors, although this isn't always necessary. The intak ... Electrolux Centralux Vacuum

Havent used for about two years. I had to put the belt on it. It doesnt seem to be sucking up very well and after about 15 minutes of vaccuuming the bag was empty. My house got really dusty. I know the rollers were spinning because i looked. I could hear some dirt going in but could definatly tell it wasnt working properly. Is it in reverse or something?


After two years you need to make sure the bag is connected properly and inspect it for tears and that the hoses are connected correctly and not deteriorated. Make sure the hose is clear. You should be able to feel the suction at the end of the hose. ... Vacuums

No suction I have a similar problem - volta vortex bagless vacuum will not ****. Worked for 1 job then quit sucking, I have had the heads replaced, then the barrel - 2 months later same problem. I push the power lever to max - 10 seconds later it turns itself down and doesn't work properly. I am over it, now looking for refund


Hi there SmartAlec from NelsonVacuums.com.au here. The problem is going to be the filter. THis kind of vacuum basically replaces the bag with a simple filter and the vacuum ... Vacuums

Kenmore vacuum not sucking properly - Kenmore 35912 / 35913 Progressive Upright Vacuum


... Kenmore 35912 / 35913 Progressive Upright Vacuum

Bissell vaccuum has a lack of sucking power and appears to be overheating


Check for blockage in the hose (if it can be removed, the motor should sound less 'labored' if the path is clear), check or replace the filter bag. (For cannister types). Uprights may have a blockage in the tubing from the pickup head to the motor. ... Bissell Vacuums

Bisel pro heat vacum is not sucking up water properly


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

I have a Bissel 9300-C 0714 BC Carpet Shampooer. It was working great and all of a sudden it stopped working. It still sucks up dirty water but it does not spray water onto the carpet. I can get it to spray water through the smallest hand attatchment but not through the large hand held piece on the base of the machine. I really hope you can help me, I am a dog groomer and I really need my machine to work properly. I can get it to spray water out of the smallest hand attatchment but that's all t


The spray jet has become clogged from the soap.... just clean it out. same thing happened to my attachment. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Sudsy water leaking from bottom of machine. Also it is not sucking the water out of the rug properly. Any ideas???


Sounds like the same problem i am having you may need a new clean tank here is the manual for your machine http://www.hoover.com/pdfs/manuals/F5914900.pdfGodbless ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Vacuume cleaner not sucking up properly. Have replaced belt but belt keeps snapping?


Check to see taht with no belt in place the brush roll turns freely.There should be no resistance. If not remove hair and thread from ends of brush Then check the leveling screws on the end of the brush to be sure they are adjusted evenly. ... Kirby Ultimate G Bagged Upright Vacuum

Suction problems My Hoover elite vacuum (which is less than a year old) is not sucking up properly. Also, when I detach the tube that goes to the vacuum cleaner so I can add my attachments, it blows OUT dirt through that opening. HELP!


Sounds like a clog right near the front ... Hoover Elite U5061-900 Bagged Upright Vacuum

DYson DC07 not sucking properly when in upright mode. I have tried cleaning out pipes etc and even tried an old motor section I had in garage (replaced once under warranty as kept cutting out and they left old motor section here). Even the old motor section had same prob so this suggests its something in the rest of the vacuum cleaner (whats left after you have lifted off the green motor section and dust collection area if you see what I mean? Any advice weclome please.


Blocked filters ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0283 seconds