Having problems with your Miele Vacuums ?

My Miele s558 Silver moon vacuum just stops suddenly while vacuuming. I can start it again using the button on the handle of the hose. It is erratic, doesn't SEEM to be due to overheating. I read online that this may mean it need a new starter switch. What do you think?

Answers :

This is caused by a circuit board problem in the hose. Unfortunately, the only way to fix this problem is to purchase a new SES 125-3 hose. The good news is that the new production hoses have rectified this problem and you will not experience it again.
In the handle part of original hose that came with my Silver Moon model, I found a broken wire. I repaired it twice and eventually got the "new improved" model that supposedly fixes this issue. It doesn't. The new hose just started cutting out again after 2 years of use. Time to switch vacuum makers.
Repair Help & Product Troubleshooting for Miele Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Miele s558 Silver moon vacuum just stops suddenly while vacuuming. I can start it again using the button on the handle of the hose. It is erratic, doesn't SEEM to be due to overheating. I read online that this may mean it need a new starter switch. What do you think?

This is caused by a circuit board problem in the hose. Unfortunately, the only way to fix this problem is to purchase a new SES 125-3 hose. The good news is that the new production hoses have rectified this problem and you will not experience it agai ... Miele Vacuums

My dyson 07 doesnt **** up when im doing the carpet but the hose works fine? when im vacuming it sucks up very little and the hose part seems to be sucking up air when im doing the carpet? would this mean something is plug??? thanks randy

There is a block in the hose take lower hose of and clean ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dco7 animal does not seem to be self adjusting the height. Beater bar is turning fine but doesnt seem to be getting into the carpet. Terry [email protected]

... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Humidifier model # 32-15412 is flashing "20%' and I can't find the owner's manuel. I think it may mean that the filter needs replacing. Or does it mean something else?

... Kenmore Vacuums

Model#F5858-910 hoover steam vac,silver ,spin and scrub. It doesnt seem to spray cleaner it seems to stream it now. what could be wrong? I cant get to end of where it sprays to see if something is blocking it . otherwise it works great. I have it about 8 yrs. always worked good until recently

... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hi my proheat bissell 7901 stopped pumping water to the floor, but it pumps water from the hand hose. I read the manual and followed how to check belt and the flat belt on right side of shampooer is fine and I turned on and it turns and so do the brushes at the bottom of the machine. I was reading online and I guess there's two belts on this machine? where can I find the other belt to see if it needs replacing. I guess it's a ribbed belt? that is the water pump belt?

Just taken ours apart with the same problem... found it was caused by the 2 halves of the main casing coming apart in the area where the upright pedal release is. I found this to be due to the upper casing having broken in 2 places - the bottom of th ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have a Dyson DC22 that seems to have lost a lot of suction. I can't peer right inside the wand, but it seems that hose may have disconnected from the telescoping handle allowing a huge leak. How can I take the handle apart to inspect/fix this?

... Dyson DC22 Motorhead Canister Vacuum Bagless Cyclonic Vacuum

I bought the 085845 yesterday, put it together and had trouble pushing it on my 8 x10 area carpet. The vacuum did not move easily and seemed to "pick up" the carpet. It seemed that the automatice height adjustment may not have been working. Any suggestions?

I called Dirt Devil and they said return it! ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Hi, I bought a Homedics toe touch weighing scale about 12 months ago (or less). I don't use it that often but a short time after I'd bought it it has started give inaccurate readings in terms of weight or no weight readings at all and just gives me the 'Err' message. I have changed the batteries but this doesn't seem to help neither does using it on a hard surface. Any ideas - I haven't kept the receipt so can't take it back! Regards Eleanor Kirk

... Homedics Vacuums

I just bought kaz model K76P (M) humidifier in Kyoto. I filled it to the right water level (a bit below) and plugged it in (nothing else is plugged in at that socket). The light comes on, but the water doesn't heat up. I can't read Japanese so can't read the instruction manual but it seems a simple procedure: fill with water, set the heating thing the water, plug in. Am I missing something or is the humidifier defect?

Take it back to the shop it should work and even though its in japanese ,they will know if your doing it wrong ,but i think it may have a damaged heater or a wire off where its been in transit ... Vacuums

I have an Argos electric multi timer (MK9 2NW. Type: TS-EE8) but as I haven't used it for years I've lost the instructions< on reading the reviews on this product it seems that they don't always work &/or need charging, I've had mine on charge for a few days but can't get a reading so I don't know if its broke. I've searched the net but can't find the instructions, can anyone advice? Thanks, David.

I have 2 of them and have the same problem! I guess you get what you pay for! ... Vacuums

My kenmore vacuum model 116.36933502. It has no suction. I have cleaned out every spot,taken off the back and still nothing. The motor runs but doesnt seem to be at full power. The agitator brush works. When it broke i seemed to smell something and since it has no belt. Does this possibly have to motors?

... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

IRobot rumba 4000 seems to run ok and then starts making a kinda hi pitched growling noise and slows way down. it is very clean(blown clean with air compressor)sensors are clear ,newly installed well lubricated on ends of brush and beater bar, new battery. it seems like the wheel tracks may be dragging . i have cleaned and lubricated where i could on them but can't find a way to totally remove and inspect wheel tracks.

It sounds like your Roomba's brush gears are not working. Run the robot without the dust bin to see if the brushes are turning. If they are not, the robot will need to be replaced. Contact iRobot CS for support at (877) 855-8593. ... iRobot Roomba 4000 Bagless Robotic Vacuum


Wilwythy\015\012I have the same type. I bought after the first boatlift from Mariel Harbor in Cuba at the same time I bought my Short Wave Radio, in order to listen to Radio Habana and Radio Free America to understand what in the heck was happe ... Vacuums

Once the unit runs it sometimes does not want to shut off. This happens regardless of the port used. If I unplug the unit it will usually seem to reset after a while and then may or may not work properly.

Most likely you have a bad relay board. It is the part that controls the on/off and power supply. ... Broan-NuTone CV450 Central Bagged Central System Vacuum

The hose works great, but the head of the vaccuum does not pick up anything !!! I checked every opening that may have been clogged, but nothing came up. When I hold my hand under the brush/roller, it seems to be putting out more air than intaking air. Particles "dance" on the carpet, but don't get "sucked up" into the vaccuum ? I have had the vaccuum only 1 year, so the brushes should not be a problem. I changed the bag, and checked the belt. The belt and brushes seem to be OK. ?

Hi there,Uprights are notorious for debris forming clogs when changing direction. The 90 degree turn where the base suction goes up. Have a closer look . You may need to pull the base plate off to access the blockage.Best reg ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hi, I bought a used Miele silvermoon vacuum on ebay and the motor just doesnt seem as powerful as my Miele red star

... Vacuums

Heater/fan issues I have a Honeywell - Year Round Fan with 1500W Heater that shuts off within five minutes if the fan is not running too. I don't have the oners manual and can't find one online. I have read several reviews that say the same thing. The heat does do much good when the fan above it is blowing cold air. Any ideas?

There is a safety switch which will shut the heater element off if the fan doesn't run. If the fan doesn't circulate air, the element would overheat and could possibly start a fire, so the switch will shut the element down. I'm not familiar with this ... Vacuums

Shampoo-er This seems to be a common problem, the shampooer is putting out alot of water and hardly any suds. I read through the posts about the little filter that sometimes gets out of place and I think I found it in the box - is it about 1" diameter hard plastic ring around very fine mesh? If so where exactly does it go? Some posts say in the hose, and others say in the opening of the tank. Or does it go in the place where the hose attaches to the tray? I also found a round sponge in the box o

It goes on the small hole on the tank where the hose attaches to it. The sponge goes in the hole directly under the on/off valve. Here is a link to my online shampooer instructions.\015\012 \015\012 ... Kirby Ultimate G Bagged Upright Vacuum

My roomba wont work. Pushing the power button doesnt do anything. It charges seemingly normal, going to green in a few hours. ive tried the reset trick, holding the power button down with the battery removed. Now what? thanks

... iRobot Remanufactured Roomba Vacuum Cleaning Robot with Scheduler, Case/Color May Vary Robotic Vacuum

I have a eureka power paw that keeps breaking belts. there doesnt seem to be a part that keeps the belt in place

My belt keeps breaking too, but worse is that I can't find out the size for replacing. Who knows the size I need for the Eureka Power Paw? ... Eureka Vacuums

Vx550 issues Like most here, ours shuts down after a few minutes use. Ichecked everything and found the thermal protection was shutting it down. I then decided to check online to see if this was a usual problem, it seems that it is. I guess a call to nu-tone is warranted. i wonder if they will ship a new unit to western Canada.

Heven't fixed it yet, but I've pulled the motor to see what the specific issue is. As soon as I have the problem isolated and a solution, if possible, I'll post it here. I will have to contact Nutone Monday and see what they will do. If nothing, I'll ... Broan-NuTone VX475 Bagged Central System Vacuum

Need help!!!!! I read the manual and tried my new hoover, the brushes spin, but the waters not going to the bottom tank, what does that mean and what can i do?

Need help!!!!!\015\012Hoover F7425-900 SteamVac V2 Widepath Upright\015\012I read the manual and tried my new Hoover, the brushes spin, but the waters not going to the bottom tank, what does t ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

I bought a used vacuum seal machine (hobart model ht-120) it does excellent vacuum but it doesnt seal correctly all the time. it seems like there is something wrong with the valve that activates the bar that goes up and makes pressure and heats the bag for complete sealing. The heating is perfect but what is not working is what make the bar go up and down.

... Vacuums

Su2914: loss of suction even when cylinder is empty!! doesnt work correctly when pet attachment is added either, only seemed to work ok for first 4 months then loss of suction, will pick up eventually but quite poorly! Should I take it for a service? Thanks

... Samsung Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1157 seconds