Having problems with your Minuteman C37115-18 Dual Motor Upright Vacuum Vacuum ?

How to plase the bag... - Minuteman C37115-18 Dual Motor Upright Vacuum Vacuum


Answers :

Repair Help & Product Troubleshooting for Minuteman C37115-18 Dual Motor Upright Vacuum Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to plase the bag... - Minuteman C37115-18 Dual Motor Upright Vacuum Vacuum


... Minuteman C37115-18 Dual Motor Upright Vacuum Vacuum

Hello, I have a problem with my Eureka Powerline bagged upright vacuum. It has a 12 amp motor and is model #4352, Type D. It was probably bought new in 1998. My problem is, while vacuuming today the motor seemed to slow down all of the sudden and then began smelling like burning rubber. I shut the vacuum off to check for blockages but could not find anything blocked. When I then turned it on again it runs but seems to only be running at 1/2 the motor speed and still has the rubber buring smell.


It sounds like a rubber sealing in the motor has come loose and is being constantly rubbed against the walls of the motor with would cause the smell and loss of motor speed caused by the fricton of rubber against the rod so if you can get to the moto ... Vacuums

We have a Kenmore Progressive Model 116 Upright bagged vacuum with Hepa filter. It's at least a couple years old. For quite some time now when ever we use the vacuum the vacuum motor will shut off nafter about 5 min. of use. We then need to let it sit for awhile and then we can run it again for another 5 min. The bag has been change. Any one have any ideas how to fix this?


I suspect that you have a restriction. The motor sounds like the thermal break is stopping the motor before damage, due to heat.\012You must witness that the entire suction and discharge side are clear. This is not always very easy, but necessa ... Kenmore 34612 Bagged Upright Vacuum

Motor whined loudly. Vacuum failure. Suspect motor failure. Hoover.com doesn't list a replacement motor. Drive also failed - could be secondary belt HOOVER U6323- Power Drive Bagged Upright Regards, Jeffrey


Hello, funI was trying to help you out here. Maybe this will help some? I was going back to some customers that asked questions in the recent past and even farther back. It appeared that no one answered some of them, So, I thought I ... Hoover U6311-930 Power Drive Bagged Upright Vacuum

Brushes don't move. vacuum motor works - Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum


The brushes on the roller are driven by a wide, short rubber belt. These belts get old, worn, overheated, and break periodically.It should be a fairly simple matter to unscrew & remove the plate, revealing the belt and roller assembly. Yo ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

How to replace motor on oreck xl upright - Oreck XL Ultra Bagged Upright Vacuum


... Oreck XL Ultra Bagged Upright Vacuum

Replace motor hoover windtunnel - Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum


... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Bagged upright panasonic vacuum cleaner motor wavering & smelly


The motor is failing and this causes it to run very hot due to electrical arching, replace the motor. ... Vacuums

Turn on motor just humms - Oreck XL2800 Bagged Upright Vacuum


If the motor is actually running and not picking anything up, I would believe it to be either a broken drive belt for the beater brush or the beater brush is frozen or both.\015\012Remove the beater brush and clean, paying special attention to the en ... Oreck XL2800 Bagged Upright Vacuum

Oreck xl21 motor wiring diagram - Oreck XL21 Bagged Upright Vacuum


... Oreck XL21 Bagged Upright Vacuum

Little suction motor on - Kirby Ultimate G Bagged Upright Vacuum


If you turn on the motor and the bag inflates fast your engine is working fine.You can have something clogged in the mini-emptor, or the fill tube in the exterior bag which can potentially restrict airflow. Also if your bag is full to th ... Kirby Ultimate G Bagged Upright Vacuum

I have the bissell power force bagged upright vacuum and the brush is not turning, I have replaced the belt but the brush will not move but the metal piece that is hooked to the motor that spins the belt and brush is turning but the brush won't, and the belt starts to burn


Sounds like your brush roll is seized. Remove the brush roll (see picture) and make both of the end caps spin freely. If not, replace it and you should be set. *An example of a brush roll* ... Bissell 3522 PowerForce Bagged Upright Vacuum

How to get the screws in the motor housing - Kirby Generation 3 Bagged Upright Vacuum


... Kirby Generation 3 Bagged Upright Vacuum

Motor shut off - Panasonic 471 Bagged Upright Vacuum


... Panasonic 471 Bagged Upright Vacuum

I have a kenmore upright 12 amp (M.N. 116.30003402C) vacuum that is not drawing anything up the hoes. There is no obstrution in the hoes and motor, belts, components are working, but there seems to be perhaps something missing(a part) or lost in the macinism that aids in drawing the air required to **** dust/dirt through the hoes and into the bag. Perhaps a diagram of parts and their function would help. Thank you.


... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

How much does a motor cost - Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum


Sharp has stopped making vacuums. The parts are very limited an expensive. Time to get a new vacuum. ... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum

How do i repair a burned out kirby g5 motor? - Kirby G5 Bagged Upright Vacuum


... Kirby G5 Bagged Upright Vacuum

Brush motor does not turn on - Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum


You could check Sears.com and click on parts then type in Model # or Part # this will get you a parts list you can choose from. ... Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum

How long is Kirby motor got warranty? - Kirby G6 Bagged Upright Vacuum


It depends. Did you buy it from someone who will honor the warranty? If not you may not have any warranty. Check first with the person you bought it from. You may find if you bought it from someone who came to your house to demo it the company you bo ... Kirby G6 Bagged Upright Vacuum

Brushs arc against spinning motor - Oreck XL2000 Bagged Upright Vacuum


... Oreck XL2000 Bagged Upright Vacuum

HOOVER VACUUMS MY MOTHER'S WORK, MERRY MAIDS, USES ALL HOOVER VACS. THEY ARE LIGHTWEIGHT-UPRIGHT-BAGGED VACS. I TRY TO FIX THEM WHEN THE MAIDS BREAK THEM; BUT, I'M HAVING PROBLEMS WITH A BURNING SMELL AND ONE MOTOR EVEN SMOKES. I'M NOT SURE THE MODEL. CAN YOU HELP? THANK YOU.....


Go to thehooverstore - this site lists a whole bunch of hoover machines, exploded diagrams and parts lists. ... Hoover Soft Light Supreme U4262-930 Bagged Upright Vacuum

Motor is weak and spindle starts to get hot - Kirby G4 Bagged Upright Vacuum


Hello, hartI was trying to help you out here. Maybe this will help some? I was going backto some customers that asked questions in the recent past and even fartherback. It appeared that no one answeredsome of them, So, I thought I would ta ... Kirby G4 Bagged Upright Vacuum

How do i remove the motor? - Royal 4000 Classic Bagged Upright Vacuum


I assume this is a Kirby.\015\012If that is the case, go to this URL and select the correct model.\015\012\015\012http://www.VacPartsWarehouse.com/Select-your-Koblenz-model-s/2816.htm\015\012\015\012It will take you to an exploded view of ... Royal 4000 Classic Bagged Upright Vacuum

I have a Eureka Contour model 2900 type A upright vacuum, the roller works fine nothing clogged, took it apart motor blade is free of debris, no suction from tube and blasts OUT air from the front HEPA filter location. New bag, New belt, nothing in hose.any clues as to why this can be happenning? Air should not be blasting out of the HEPA filter.


Even with your explanation,it seems the hose is clogged.Try taking the hose off,then blow through it or pour water through it.If this doesn't do it,make sure the suction canals are going to the proper areas. ... Eureka 2900A / 2901A Contour Bagged Upright Vacuum

Diagram for motor wiring oreck - Oreck XL Ultra Bagged Upright Vacuum


... Oreck XL Ultra Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1025 seconds