Having problems with your Morphy Richards Supervac 70485 2-In-1 Bagless Cordless Vacuum Cleaner, Silver ?

I have a Morphy Richards Suppervac but can't figure out how to get nozzle off hand held bit to empty!! No doubt there's a simple solution!!


Answers :

Repair Help & Product Troubleshooting for Morphy Richards Supervac 70485 2-In-1 Bagless Cordless Vacuum Cleaner, Silver

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Morphy Richards Suppervac but can't figure out how to get nozzle off hand held bit to empty!! No doubt there's a simple solution!!


This link is for the manual,, hope this helps youhttp://www.morphyrichards.co.uk/Pdf/IB70485.pdf ... Morphy Richards Supervac 70485 2-In-1 Bagless Cordless Vacuum Cleaner, Silver

Cleaning solution does not come out of the rotating cleaning head or the hand-held nozzle the solution pump seems ok but does not run (electrical continuity check between the two leads on the pump show very low resistance so they seem to be intact) - no dirt or blockage is apparent (it is a very simple device with 1 moving part wires to the pump also pass a continuity check THERE IS NO VOLTAGE on the pump leads from the control circuit board when I turn on the "manual" cleaning mode - a


You can contact Bissell directly at the following\015\012\015\012For UK inquiries:\015\012Monday - Thursday 9 am — 5 pm\015\012Friday 9 am — 4 pm\015\012\015\012BISSELL Homecare (Overseas) Inc ... Bissell SpotBot Robotic Wet/Dry Vacuum

I have a Bissell 1623-1 Steam Cleaner. It will work good for about 2 minutes and then after that it will not dispense cleaning solution on floor or through the hand held wand.I have replaced both drive belts with no improvement. I have cleaned it and found no obstructions in hoses and spray nozzles, put back together and it still will not dispense. Is it possible the pump or solenoid is no working? Aaron


... Bissell 1623 Steam Cleaner

Hand held piece - the solution doesn't spray out anymore. I have taken it apart to clear any obsticles but still just a few drops come out. It has been several years since we received it as a gift. Any recommendations? -Kevin


Most likely the pump. its red and has a couple of wires attached ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

I have a Bissell Proheat Turbo 2x model 9300. It has stopped spraying at the floor. The hand tools will work so I assume this means the problem is at the base somewhere. I cleaned the nozzles but don't know what to try next. It has always had a problem with dumping too much cleaning solution as well, don't know if this is a contributing factor


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a bissell proheat 2?X carpet cleaner, the solution and water does not spray out on the upright machine, but the hand held one is working. How do I fix this please.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The unit (9400-3) is not spraying water from the lower deck but will spray from the hand held wand. Checked water levels and water/soap dispenser valves which seem to be working fine. Spray nozzles are not blocked. Where do you look now.


Same problem i have got, spent one day on the bloody thing but of no use, the only solution is to spray water from bucket and use the cleaner to **** it up. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Ive completely lost suction from the main part of the machine. I can only use the hand held attatchments attatched to the nozzle


Hi there,\015\012\015\012Sorry to hear you're having problem with your DC07. You should be able to resolve the issue by following these simple steps: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a dyson hand held that shuts off after just a few seconds of run time. we keep it charged but to no avail. Can someone suggest a solution.


Yeap..... i just found a fix for this ,, its mad how easy it is to fix as well...and it works 100%,,,\015\012now dyson implemented a filter magnetic switch if u take your filter off you will see a small magnet in the corner,, u will notice wher ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

The cleaning solution stopped coming out of the rotating brush but still comes out of the hand held vacuum hose.


If you can check where the vacuum hose where it is connected their might have dirt in the opening to the rotating brush,or it is glogged,clean with a wire and it will be ok ... Bissell SpotBot Robotic Wet/Dry Vacuum

The cleaning solution on my bissell spot bot is not being pumped through....on the stationary mode or the manuel hand held mode with the brush attachment


I had the same problem, and found that the culprit was that the small filter element. about the size of a dime, that sits arount the nozzle activator (pin that depresses the clean water nozzel) was clogged with "gunk", and prevented cleaning solution ... Bissell 12005 Spot Bot Handheld Vacuum

Hoover Max Extract LS F6056900 Hand Tool not working / Cleaning Solution I need to know what I need to get in order to have the hand tool work on this model. Also, what cleaning solution is best for pet stains? Tried cleaning, pre-treating with Spot Shot and towel and/or scrub brush, then cleaning, still doesn't work. PLEASE HELP!!


... Vacuums

Hoover platinum carpet cleaner. won't extract the water out of the carpet... ever since I used the hand held extension. I have tried unplugging, resetting the hand held part... i have all this water in my carpet!!!


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My cigarette injector nozzle on my Top-O-Matic keeps coming off. Why and how do I fix it? With glue? I put the tobacco in, and my empty cigarette tube on the nozzle, then use the hand crank to push the tobacco into the tube and the NOZZLE is coming off with the tube and the tobacco isn't filling the tubes. please email me back a response [email protected]


... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

My bissle proheat carpet cleaner/vaccuum has become clogged with the cleaner solution. As a result the cleaner solution does not reach the carpet when in operation. I had this fixed before at a local appliance store but they are now closed. I would like to do it it at home. Is there is simple solution to clean the system so it becomes functional.


Take apart the handle (a few screws) unclip the small clear hoses, use a pipe cleaner or small screwdriver to clear the hose from the crystalized cleaning solution that is blocking the hose. Put it back together and it will be like new. ALWAYS run ... Vacuums

I have a Bissel 9300-C 0714 BC Carpet Shampooer. It was working great and all of a sudden it stopped working. It still sucks up dirty water but it does not spray water onto the carpet. I can get it to spray water through the smallest hand attatchment but not through the large hand held piece on the base of the machine. I really hope you can help me, I am a dog groomer and I really need my machine to work properly. I can get it to spray water out of the smallest hand attatchment but that's all t


The spray jet has become clogged from the soap.... just clean it out. same thing happened to my attachment. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

MY hoover steam vac hand held hose cleaner leaks profusely


Try taking a sharp knife and shaving a little off the edge of the plastic, or a small file if you can get to it, see if it is getting binded. If its getting stuck internally, you will have to replace the switch instead of risking takin it apart. ... Hoover F5810 SteamVac Upright Vacuum

Just got secound hand ....hand held shampooer where to put water and how to put back on machine for use


... Dirt Devil Vacuums

Asking again. Better wording? My lightweight Bissell carpet shampooer is continually spraying cleaning solution. The sucking action works well but can't keep up. This unit does NOT HAVE A HEATER. This is a simple unit. Is there a cable going down the handle from the trigger? ( it feels like that's the way it works. Could the drain be plugged. Also it will only use 1/2 a tank of solution at a time. Then must be filled again


Hi Sue. I understand how frustrating this must be. I'd like to help you with troubleshooting steps, but need more information.\015\012Here's a quick link to contact us: ... Vacuums

I have a 5260D Baby Lock Serger, which I had tuned up a year ago. I haven't used it very much since. When I took it in, and again now, it sews fine for awhile, then starts slowing down until it is barely sewing, even with the foot all the way down. The hand wheel seems very tight. - it doesn't turn freely, but takes a some push, like it is resisting a bit. Any idea what could cause this slow down and the tight hand wheel? I appreciate any ideas. Thank you. Maura


Hi,Since you say that you didn't use it for many years then does it make noise?If so it need oiling on its parts.oil orifice and point of contact.Please do rate the solution if the issue is resolved or post a comme ... Vacuums

Theres no spray coming out but theres solution in. ive checked seals, turned off left it and primed it. it works for 1 stroke then im bk to square one again. please help me


You need to check the seals. It is loosing prime after one stroke. I had the same problem and found obstructions causing a seal to leak and allowing air into the sytem. Take it completely apart and clean thouroughly.Also do you have the dial to choos ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

I got a Dirt Devil Versatile 3 in 1 design hand vaccum for a birthday present This has a suction type of cleaning. I would like a hand held lightweight vaccum cleaner with a roller type brush and cervice tool. I would like to clean carpeted steps. I want to return the above cleaner and get a voucher for another cleaner.


... Dirt Devil Vacuums

I have the Quick Steamer Plus 160 Series/2070 Powerbrush. It will not release cleaning solution and will not pick up solution that had already been dispensed. Is this something simple I can fix???


I checked the bottom of the fresh water supply container and all\015\012was well there then I used a pin in the tiny air valve on the container.\015\012Turned the machine on, pulled the lever to release water and held\015\012it for several minutes an ... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

I was vacuuming up for a friend and now it won't turn on. I feel obligated to repair it; but maybe there is a simple solution? I have a hunch that the switch went out. Is there an overthrow relay or something? applicance: dirt Devil D2 12 amp i truly hope that you have a solution as I'm unemployed and really broke.


Are you serious,put it in the reciycle bin,and dont be so mean and buy a ney one 6/7 dollers .adrian.,,,,, ... Vacuums

My bissell proheat cleaner is letting out little spray solution when on the floor cleaner setting. If I press the sprayer on the attachment solution comes out of it even when it is not set on the attachment setting what should I do to fix i. How do I clean the water nozzles under the machine?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0345 seconds