Having problems with your Nozzle for Sharon S3300uk ?

Where can I get a nozzle for shark S3300uk

Where can I get a nozzle for shark S3300uk

Answers :

Repair Help & Product Troubleshooting for Nozzle for Sharon S3300uk

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where do i get a nozzle for shark blaster S3325


Go to www.repairclinic.com or directly from your supplier SharkGod bless you ... Vacuums

How do I get the beater brush off of the vacumm to replace the belt? The vacumm is a Shark roadstar . I can get the belt on the one end but I cannot get the brush up to put it on that end. Judy It is a Shark Roadstar EURO-PRO Model No. UV208C


... Vacuums

I am missing the nozzle to the SC 505 Shark portable steamer. Any ideas?


... Euro-Pro Shark SC-505 Handheld Steam Vacuum

I have a hoover 3000 i have not used in awhile, and since I removed a large rug, I would like to use it again on my slate floor. HOWEVER, I cannot get it to pick up ANY water in the water recovery unit......it is dry, dry, dry. I have put in a new filter, cleaned the nozzle unit, the scrubber , and reconnected both the recovery unit and the water unit several times, but to no avail. I would like to get a graut attachment a well as replacement part, but since I can't get the basic unit to work, I


Have you made sure the plastic filter cover with the round hole in it that covers the filter is in place ( part # 59177096 ). This piece seems to get lost, and without it there is no pick-up. The other common problem is that the wheel assembly has be ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I can't find the 4 screws to get to the belt on a dirt devil 22.0 Fx. The bottom of the vaccuum says " remove four screws from bottom of nozzle then lift top nozzle cover off", where are these screws, I can only find two, and which is the top nozzle cover?


... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

Frozen top The top of my Shark sc505 is on so tight that I cannot get it off even with heavy duty tools. It appears to be frozen and will not move. How can I get it off so I can use it again?


I just bought one from a thrift store we were able to get the top off! We used wd 40 and vice grips and it came off. The machine looks like it was only used once and someone left the water in it. I immediately put white vinegar in it and rinsed it ou ... Euro-Pro Shark SC-505 Handheld Steam Vacuum

How do I get to my Bissell ProHheat 2x 9500 water heater to clean it? I've cleaned the front nozzles but just can't figure out how to get the bottom open so I can reach the heater. Thank you!


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Shark steams, but not much water is getting to the pad. This is a new problem. I've owned three Sharks and love them. Please help.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...Euro-Pr ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My Fantom Thunder upright has a blockage that sounds like it is directly above the dirt bin in the "head". I cannot access it from inside the bin chamber by going up the nozzle with a claw parts retriever. (This is the older model where the cyclone nozzle doesn't come off.) The wand, hose, rear inspection port, and front brush intake are all clear. How do I get the top of the vac off above the dirt bin? I don't see any screws or slots.


... LG Vacuums

Shark steam mop gets really hot and leaks - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

SHARK CORDLESS SWEEPER 3 SPEED CONTROL FLOOR, CARPET, TURBO BATTERY EURO-PRO 8.4V - 1.3 Ah SB617U 3305 BELT Turned on and almost immediately turned off At least four years old - not used all the time - not used in six months Checked belt - seems O.K. Do I need a new battery, if so, where do I get one? Or should I just get a new sweeper? Cost?


... Vacuums

I purchased the SHARK cordless hand vacuum,18 volt SV779Z 14 from Walmart and mailed you its product registration on Nov.3,2010. As I was vacuuming my kitchen countertop ,there was a big bang and it stopped all suction. Walmart told me to get in touch with you since they did not have any more to exchange. I have the sales ticket and did register the product as mentioned before. I need to know what I can do to get a replacement since it was under guarantee. Thank you! Robert Schwarzenberger


... Euro-Pro Vacuums

Power Nozzle Model No. N137A (for Electrolux Epic Serial 6500 SR) has a broken wire. Can I get a replacement power nozzle or find a repair place in the Everett, Washington vicinity?


... Electrolux Epic 6500 Vacuum

Power nozzle for rainbow vaccum is getting power but the motor does not work nozzle model r-2800c


Hi there it's SmartAlec from NelsonVacuums.com.au here. It will either be the fuse or the motor itself. If you disconnect the wires from the fuse and join them together and ... Vacuums

Power nozzle omni-flo plugged - goes into 1990 electrolux H684350. How do I get power nozzle cover off>


... Electrolux Vacuums

How do I replace or repair my tristar power nozzle cordI don't know how to get to or how difficult it will be. there is a short in wire because it is separating from the power nozzle.


Dear kerri_clark,Can't you take a picture of tristar power nozzle cord that you mean.I need to take a look at this to assist you further more.regards,dm ... Vacuums

Can not get Shark steam mop to steam, green light is on? Purchased 5/4/09, Registered Product 6/2/09 Cynthia Friesema 973-222-7068 please call cannot get through on your phone line!!!! Tried many times, just gives me a fast busy signal every time I try to call !!!!


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark steam mop gets hot but does not steam - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Scunci steamcanister model 52038 Steam does not get from canister through hose to nozzle. No apparent leaks - hose does not get warm. appears may be valve problem from canister to hose. Only used bottled water - barely used this machine.


... Scunci Vacuums

My shark steam mop has stop producing the steam to clean. I only get a little water to come out to wet the cleaning pad. Is it stopped up and if so how do I get the steam and water flow back


Dear Sir/Madam\012\012Good day.\012\012We're Auto-parts manufacturer from China. We are able to supply Axles & Axle tubes , Grease Nipple,Brake hose , Auto Springs, and some other fittings. If you have any requirements about auto- ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Electrolux Epic 6500 SR ...no power to power nozzle. I think it is the switch in the handle because if I use my friend's hose/handle (same model), my power nozzle works fine when I turn on the switch. If you think it is the switch, can I get a part for it?


That's about the best one to narrow down a problem, however, there could also be a break in your hose wiring. Switches, hoses, and hose handle assemblies are all available at your local Aerus Electrolux store. Simply take your entire machine in so ... Vacuums

Shark steam mop. I feel that the canister gets


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark steam pocket mop is not getting hot enough very little steam and water is leaking out


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My shark vac is getting hot but hardlthe steam is coming out to


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0661 seconds