Having problems with your Numatic Henry Bagged Canister Vacuum ?

Numatic henry keeps cutting out & plug crackles in the socket!

\015 I've got a numatic henry and yesterday started to experience problems. It was working fine, I left it for a while and then when I switched it onto use it again it would only work for a few seconds then stop. Have changed the 13amp fuse in the plug a couple of times and experienced the same problem. Have now noticed that when the plug is in the socket (and the socket is switched on) I can hear a crackling sound - eek! Any clues what the problem might be?\015

Answers :

It wasn't the hoover, it was the plug socket!
Repair Help & Product Troubleshooting for Numatic Henry Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Numatic henry keeps cutting out & plug crackles in the socket!


It wasn't the hoover, it was the plug socket! ... Numatic Henry Bagged Canister Vacuum

My hoover keeps cutting off and on, now it doesn't even come on. I have checked the fuse its ok and i can't cheak the wireing,the plug is moulded into the socket.


Chances are your cord was damaged inside the insulation and over time it finally opened. That would cause the cac to not operate any more. If you have access to or one of your friends has a multimeter then you can check the wiring by using that meter ... Hoover Vacuums

Henry hoover Hi all, I bought a spares/ repairs Henry on ebay having been told there was no cable rewind and believing that since I had a spare one in the shed it would be an easy fix. However, poor Henry had his cable replaced to find when plugged in, he tries to start but nothing happens. The motor turns once and just cuts out. If you turn it on and off again it happens again. One whir and turn of the motor, then nothing. It blew the fuses out in the kitchen first time too, so could it be a re


Hi it can be the connector at the end of the Henry cable inside the cable rewind unit happened to us! ... Numatic Henry Bagged Canister Vacuum

Got a numatic henry (green colour) There is a loose wire in plug, but can't open plug to fix. how do i? Thankyou


Hi.\015\012\015\012Very simple this one.\015\012The plug is molded type this kind of plug is sealed so you cant make any repairs internally other than change the fuse.\015\012\015\012You will need to cut plug off & f ... Hoover S3639 WindTunnel Bagged Canister Vacuum

How do i charge my i stubble 7890u it came with 2 pin plug i changed it to a 3 pin plug but it keeps blowing the socket


It sounds like you have a stray wire shorting in the 'new' 3-wire plug.. Or some other form of mis-wiring--Look at the plug, and make sure that your 2 wires are connected only to the 2 spade shaped plug blades--- NOT to the Ground plug. ... Vacuums

Henry hoover vacuum cleaner keeps cutting out intermitently. I have checked all connections which are OK, problem is not with bag as is empty. Faulty motor??


... Hoover Vacuums

Henry hoover i have to keep moving the wire at the plug end to start it


... Vacuums

Numatic hoover fitted with surge cut out plug why no earth wire is this legal


... Vacuums

The hose of Hetty keeps falling off - Numatic Henry Bagged Canister Vacuum


... Numatic Henry Bagged Canister Vacuum

Turbo brush cutting out - Numatic HHR-200 Henry Hound Bagged Canister Vacuum


I had the same problem, I solved it by unscrewing all the attachment parts of the tubes and taking off the connecting covers, cleaning out the fluff and wiping off any dirt from the copper connectors, replacing the covers and screwing it all back tog ... Numatic HHR-200 Henry Hound Bagged Canister Vacuum

HVR 200 keeps cutting off.


Henry has a has a thermal cut off (a thermostat that protects the cleaner in case of motor overheating). When you have no bug inside the hoover will be very cold. \015\012\015\012Check if the hose is blocked with dust.heck also th ... Numatic Henry Bagged Canister Vacuum

My hoover keeps cutting out I have washed the filters and changed the bag but still keeps cutting out every 15secs


... Hoover Vacuums

Motor on the powermate keeps cutting in and out.


If your talking the motor on the beater bar, then chances are either when the beater bar was attached to the hose near where you hold it, it did not lock, and the connection is intermittent, or the cord has an internal break. ... Kenmore 22313 Bagged Canister Vacuum

I have a Zanussi 1700W bagless upright vacuum cleaner which keeps cutting out after about 5/10 mins use. I had to replace the rubber drive belt which snapped not long after purchasing and it was fine for a while, but now its just keeps cutting out after a small amount of use. Nothing wrong with belt which is still intact so we don't know what the problem is. It's a great cleaner otherwise - but it's driving us mad!! Please help!


... Vacuums

I have a philips shave which I took away on holiday to the Germany.The probelm was that the two pin mains plug did not fit the Germany two pin sockets. The mains plug was about two millimeter to narrow to the pins in the socket. Therefore I could not charge my shaver Mr Jackman


Germany has 220 volt outlets ... Philips Vacuums

Henry hoover cuts out


A 5amp fuse will struggle on start up on anything over 1000watts. Check the rating plate on the appliance for total load ... Numatic Henry Bagged Canister Vacuum

I just bought kaz model K76P (M) humidifier in Kyoto. I filled it to the right water level (a bit below) and plugged it in (nothing else is plugged in at that socket). The light comes on, but the water doesn't heat up. I can't read Japanese so can't read the instruction manual but it seems a simple procedure: fill with water, set the heating thing the water, plug in. Am I missing something or is the humidifier defect?


Take it back to the shop it should work and even though its in japanese ,they will know if your doing it wrong ,but i think it may have a damaged heater or a wire off where its been in transit ... Vacuums

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!


Hi,\012\012You have to open the vacuum cleaner and look for the wire.\012\012It is located inside the circular wheel, where it wind itself up.\012\012Don't be afraid to open it, unless your willing to pay somebody just to install a ... Electrolux Vacuums

My dyson d14 animal keeps cutting in and out. When it's on, the hole above where the filter is, keeps making a loud suction noise and it won't clean up hair and dirt.


Vacuum Cleaners require AIr-Flow. Your machine is not getting any air-flow. The noise you hear is a valve opening up to prevent your machine from overheating and burning out the motor. You probably have an obstruction somewhere in the machine. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I was vacuuming and the power abruptly stopped working. The plug had slightly slid out of the wall socket, but when I put it back in, it wouldn't power up again. The wall socket is working for other appliances.


The first thing to suspect is that the wall plug on the vacuum cleaner is defective, to confirm this you will need to access the on/off switch on the vacuum, there will be three wires coming to the switch from the cord ... Hoover S1361 Bagged Canister Vacuum

It just keeps saying that my bag is full and cutting out, bag not full and have tried changing it anyway, but still cutting out


I would check the air filter. It sounds like it's over heating and shutting off because it doesn't have good airflow.Jim ... Sebo X4 Bagged Upright Vacuum

How to change carbon brushes on henry - Henry Numatic "" Canister Vacuum


The brushes are easy to change, follow the directions in your book. ... Henry Numatic "" Canister Vacuum

It doesn' come on when hose is plugged in. I checked that the unit was plugged in and the socket works.


It could be one of several problems.\015\0121. Ensure the filter is clean. It should be rinsed and dried thoroughly about every six months. Allowing it to go longer results in dirty filter, which results in excessive stain on the motor, which w ... Electrolux Central Vacuum

My henry hoover has stopped sucking - Numatic Henry Bagged Canister Vacuum


Screw the pipe off and clean with cold water. \015\012\015\012check dust bag or change, \015\012\015\012check that nothing is abstructing the suckstion from the head & neck. of your hover,\015\012 ... Numatic Henry Bagged Canister Vacuum

Makita 440 Dust Extractor - Trying to rectify a problem, when i switch on an appliance plugged into the socket, it will not run. IS used to run with this plugged in, but the hoover motor runs no problem. Any ideas what might be amiss, or where i can get a wiring diagram? Thanks in Advance!


... Makita 440 Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0402 seconds