Having problems with your Numatics Numatic Hetty 200a Hetty Hepa Canister Vacuum Cleaner with Autosafe ?

My hetty hover stoped working

\015 My hetty stopped working I have changed fuse ,plug and cable and also by passed the switch, and she still wont work, don't think she burnt out, first time this happened we took her back and they changed it for a new one. please HELP\015

Answers :

Repair Help & Product Troubleshooting for Numatics Numatic Hetty 200a Hetty Hepa Canister Vacuum Cleaner with Autosafe

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I am working on a u5290-900 hover vacuum ,when operating dust leaks out under dirt cup cover. i put a piece of card board on top of cover so extra presure would be applied to the top of cover. this seams to have stoped the leak , before adding the card board the cover seamed to lift at the back when cover was locked into place. what do you think?


Dear Sir:Will be better idea to replace the cup cover. The pice of card will not function for a long time. Proceed before another extra problem coming.God bless you ... Hoover U5290-900 Upright Vacuum

Hetty hoover not working. It was working ok until I opened it up to search the bag for a missing jigsaw piece and I put it all back and I hoovered the mess on the floor, then switched off and switched on and hoover would not work? Is there a cut off button on Hetty hoovers?


Know cut off switch, its just not getting power ? 2 things its ether at the wall plug or in side the unit. I have never found a fuse in side them , so it may be just a lose wire did you try other plugs in the house . good luck DFD ... Henry Numatic "" Canister Vacuum

I bought my rainbow se vacum 4 years ago and I was using it and suddendly stoped working, I try to on no power I on and off not working at all. what shall i do is there posibility to work again.pls.help and tell me what is the best to do. thank you.


Hi, there is no reset button on a Rainbow vacuum. \015\012\015\012 All SE series vacuums have a built in thermal and load fuse on the motor, and if it blew, it has to be replaced, or wired directly, with out it on there.\015\012Moto ... Rainbow 75th Anniversary Canister Vacuum

On my hover U6616-900 the self propell work fine on the med setting on med height carpet, but when I go to low height carpet and height set on med the self propell does not pull the vacuum and it is hard to push. Also if I raise the height to the highest setting the self propell works correctly and appears to clen. Any ideas? S/N 090400184555, think this vacuum is maybe 5 years old and my wife uses it lots. Should I think of maybe a complete overhaul or a replacement at this time?


This is a typical problem you are describing. I would recommend you change the belts, this will resolve the "hard to push" and most likely resove your issues. based on the s/n given you maching was made on sept 2004. ... Hoover U6616-900 WindTunnel Bagless Upright Vacuum

We have a Hover F7411-900 which runs great but for some reason the wash does not dispense the cleaning solution. It works fine on rinse but not on wash. We tried cleaning the round piece at the base of the cleaning solution but that did not fix the problem. How can you repair so that the wash will work.


That would be the wash silonod, the thing that makes the soap and water mix together in order to make the soap come out at the bottom were the brushes are. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The beater stoped working .


That sounds like a bad or burnt contact between one of the connections in the hose. Make sure all the connections are secure and look at the contacts, if they are bad you will usually see burn marks or melted plastic.\015\012\015\012Hope ... Rainbow E series Canister Wet/Dry Vacuum

Hetty hoover...power switch lights up but not working at all, help?


... Henry Vacuums

Sebo x1 stoped working


... Sebo Automatic X1 Bagged Upright Vacuum

Spray pump stoped working & making buzzing noise


... Numatic GVE370 Canister Wet/Dry Vacuum

Kirby g4 stoped working


Cable has shorted out internally, will need new cable ... Kirby G4 Bagged Upright Vacuum

My remote control has broken (stoped working) where can we get a replacment remote control. TV - Goosmans - LD3761HDFVT


Sometimes you can go to the manufactors site and order direct thru them. Otherwise you will have to have a repair shop get it for you. ... Vacuums

Drive not working on my hover sweeper handle seems very loose


How to Change Actuator on Hoover Self-Propel vacuum Cleaner - Step by Step\015\012\015\012 \015\012This is a notorious problem for the Hoover WindTunnel Self-Propelled Models. What happpens is that the handle of the vacuum that controls the transmi ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My model F5906-900 --- problem is the brushes have stoped working... I pulled the brush assembly out by holding the two tabs, and all seems clean and the brush assembly rotates easly... onced the brush assembly is removed. What I did notice is the female driver slot (found in the main assembly unit) that drives the brushes seems stuck..Is that normal when the machine is not hooked up to power? How can I get the brushed going??? it is a good machine, but the brush options is important too it's ab


(1) Assure the Brush Control on the hood is NOT set to the OFF position.\015\012(2) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(3) Does one of the brushes ... Hoover F5906-900 Upright Steam Vacuum

My hetty hoover is not working i have changed the fuse and tried a other plugs in the houseno power going to it can you help its about 20 months old


Check the switch with a ome meter ... Henry Numatic "" Canister Vacuum

Tafel Steam Iron Model 2820 3.12 104 - switch connections - can you please explain how this is works Iron stoped workin open the back and one of cales to the switch is hanging loose - but can not workout the obvious way to reconnect - can you help by showing me a diagram of the switch mechanism kind regrad


... Vacuums

Not spraying it has stoped spraying,and the red flap called a hip is not attached,was working fine


... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

J BOUGHT A TROTEC TTK170S ONE MONTH AGO IT STOPED WORKING ON FRIDAY LAST AND HAS NOT WORKLED SINCE


Hi\015\012it may be that started leaking inside him so his security system blocked functions .in that case a lamp would be blinking on his front panel. \015\012also,security system reacts on bad connect hose with liquid bawl (it may fell of).\015\01 ... Vacuums

I have my Emerson FR966T wine coller set for 60 degrees, but my cooler never seems to get the high. It always hovers around 58-59. When I heat my house up (never above 68) my cooler seems to warm up to 60 (inside). Whats up? Why does the outside temp. affect the inside. The manual says it works best when the ambient temp. is 77 or lower.


... Vacuums

Hoover mach 3 stoped working: while I was vaccuuming, it was on and off and eventually, it stopped and won't start again.


... Vacuums

Hover windtunnel It will start when you plug it in and wont turn off with the switch you have to plug it in and unplug it to get it to work.


I had the same problem with the Hover windtunnel. All I had to do was remove the two screws holding on the handle and then pull the handle off pulling horizontal to the ground. Then I manually turned to swith off. Check it to make sure the switch ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have a dyson - bought it 3 yrs. ago and the roller brush stoped working - doesnt pick up anything. Can you help? The brush doesn't roll or spin. Where can we take it to be fixed and is it under warrenty? THis


Don't worry it's probably just that the belt has broken or stretched. Your actually supposed to change them yearly. So if its been three years thats probably the case. Here is a link to the belt you need and a manual with instrutions: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My henry hoover has just stoped working its not the fuse do you have any ideas


I had exactly the same problem.there were no burning smells coming from it so nothing seemd obvious.I then took it apart and checked that all wires were connected,which they were.Then decided to check the plug.After replacing the fuse I chopped the c ... Hoover Vacuums

The boiler stoped working on my eco pro 3300 - Polti Eco Pro 3000 Canister Steam Vacuum


There is a high possibility that the boiler has build up of minerals and requires cleaning. I suggest using a product called KalStop to remove the calcium buildup that is cause by leaving water in the tank for long period of time. ... Polti Eco Pro 3000 Canister Steam Vacuum

My bissell aroma pro had a horrible burning smell then stoped sucking up water. the motor was still working and water was being feed out just not back up. the machine was hot as i had already cleaned 3 rooms in the house. i let it cool down but the burning prob returned as soon as i turned it back on. any help would be great thanks


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0367 seconds