Having problems with your Oreck BB2000 XL Little Hero Canister Vacuum ?

Stopped working. Is there a circuit breaker

\015 Used it on the porch outside. it was 90F out. Vacuum got really hot. It stopped all of a sudden. Is there a circuit breaker to reset?\015

Answers :

Repair Help & Product Troubleshooting for Oreck BB2000 XL Little Hero Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My vacuum stopped working and tripped a circuit breaker in my apartment. I plugged it into a circuit with higher amperage, and the circuit tripped after the vacuum ran for a few seconds then a bit of smoke puffed out of it. I assume the motor is burned out. Can I repair this? Considering buying a refurbished one for around $70 - which is probably less than round trip shipping back to the manufacturer (this is way out of warranty).


... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

Stopped working. Is there a circuit breaker


... Oreck BB2000 XL Little Hero Canister Vacuum

Stopped working while vacuuming heavy dust on patio the vacuum suddenly stopped working. I tried it on other outlets with no luck. I cleaned the filters and still no luck. Is there a circuit breaker if it get hot?


It cooled down and worked 20 minutes later ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Vaccum was being used and suddenly stopped. checked the filter, circuit breaker, and pressed restart button. still does not come on


To test the vacuum motor and circuit card, detach low voltage wires from vacuum. Using insulated needle-nose pliers, place points of pliers in each wiring connector. This should start and run the motor as long as the pliers are in place. If it doe ... Electrolux Central Vacuum

My AirVac 3000 stopped working while I was vacumming. The motor runs but it is not sucking. The bag was changed. The panel circuit breaker had not tripped. What could be the problem? Thanks.


You may have a clog in the hose or wand assembley of your accessory kit. Remove the both wands from the accessory and check your suction. If you have suction there the clog is in the wand or the tool you use to clean the floor. If not you have a clog ... M&S Systems FX-3000 Bagged Central System Vacuum

Hoover upright has stopped working and tripped the circuit breaker. Where is the fuse located on the hoover ?


Most Hoover uprights do not have fuse. Some canisters doe but it is a thermal shutoff. When the vac overheats and cools down it restarts on its own. You very likly have motor damage, but if lucky you could have an obstruction in the fan causing ... Vacuums

My Hoover Windtunnel blew the circuit breaker today, and did so again after I reset the breaker and turned off the only other appliance on that circuit. Any advice? Thanks from GrGrandma in Fremont


There could be a problem with the vac, the only way to know is to use an ammeter and test the current draw of the unit. If the vac is ok, the breaker could be failing. Plug the vac into another receptacle on a different breaker and see if it still tr ... Vacuums

Hoover EmPower 4600 keeps blowing circuit breaker. The number of outlets in the house that will allow me to run the vacuum is dropping quickly. It is a 4 year old house and all the circuit breakers are 20 amps. The vacuum only has a 12 amp motor. I am at a loss to solve this problem.


Take it to a friends house and plug it in if it does the same thing then the problem is in the vacuum cleaner.check your cord and see if there are anny cuts in it.you can open the breaker box then plug in the vacuum and watch the breaker box.you migh ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

On my Air Vac model AV425A Central Vacuum System, I discovered the circuit breaker opened. When I close it, the vacuum motor goes on. It doesn't matter which position the on/off switch is on, it runs until I open the circuit breaker again.


... M&S Systems ZX7000 Bagged Central System Vacuum

I have 200 main breaker panel. I want to install a single pole 20 amp breaker. I have 3 wires coming from an outlet, black, white, and green. I have black tied to the circuit breaker, white tied to the bus bar, but I do not see where to attach the ground


Look at the panell ,,the positive connects directly on the breaker ,,the negative on a rail inside the panel,, you will see other wires on the rail..and the ground connects on the panel itself,, you will see a bold ... Vacuums

I have an Eureka Express canister vacuum - I believe it's model 8284 - that just stopped working. Plug it in, turn it on, and absolutely nothing happens. I took it to the local sew and vac place and they say it's a circuit board that is no longer available. I've looked at all the parts lists and diagrams for that vacuum and I would swear there isn't a circuit board there. (I wouldn't have even thought that in 1989 they would have used circuits.) In any case, I absolutely love this machine a


Given the age of the machine weighed against you fondness for it, unless you can find a fault with either the switch or the cord, there is little else that can be done. With time the electrical lead can break down and one o ... Electrolux Vacuums

Every time we plug in the vaccum hose into the wall recepticle the vaacuum turns on for half a second and then blows the circuit breaker. This just started a few days ago. We tried replacing the 20 am


... Dirt Devil CV950 Central System Vacuum

Circuit braker fxk125h - Hitachi 0LSR CIRCUIT BREAKER SWITCH Replacement Part 327373


... Hitachi 0LSR CIRCUIT BREAKER SWITCH Replacement Part 327373

Dc15 fuse The roller brushes on my dc15 stopped working..I checked the obvious and then noticed that the 2 amp fuse was blown on the circuit board . I've replaced it with the same type bought from Maplins but it keeps blowing .. I tested the yellow an blue wires leading from the circuit board to the roller brush head and the are in tact and I can run a current through them ... Any thoughts from anyone .? Your help would be. Appreciated thanks Lee


Hi Lee,I'm sorry to hear you're having difficulty with your DC15. If you'd like some help, please give us a call on 0800 298 0298 - we may be able to resolve the issue with some troubleshooting over the phone.Best wishes,Jack ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

I fear the motor has failed on my Electrolux Oxygen EL6988D. Just six months after the warranty expired, I was vacuuming when it suddenly stopped. There was no blockage in the tube and it wasn't working hard or long . . . it just stopped. I looked around the Internet and it appeared that many similar Electrolux units have a fuse. I hoped my problem might just be a blown fuse, so I took the machine apart. There are two small printed circuit boards, but no fuse. There is an in-line


Hi,\015\012\015\012I don't think you need a new motor, but please stop testing the machine with live power. It's dangerous and unnecessary. Your tests indicate to me that the motor is fine and your thermal-fuse - I think this is wh ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

I have 2003 Coleman Westlake Pop Up Camper. I have electrical problem. Replace circuit breaker and ground fault. Went camping, everything running fine the all of the sudden all power cuts off. Breaker did not trip, ground fault is fine. What could be the problem ? Is my converter bad ??


... Vacuums

Circuit breaker trips with shark steam mop


Figure out how many amps your circuit breaker isthen figure out what appliances are running from that circuitif you are under...then your mop is faulty ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My hoover steam vac keep setting off circuit breaker


... Vacuums

Where is the circuit breaker on a Bissell Proheat 2X


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Where is the circuit breaker on a 3.ohp shop vac ultra plus


... Shop Vac 962-06-00 Ultra Plus Wet/Dry Vacuum

Vacuum stopped in middle of vacuuming our carpet. Would not startup at switch. Tried other electrical outlets wondering if this was the problem and checked breakers, but it still did not go back on.


2 guesses.... One is that you vacuumed up a pice of cord or sting that got wound up on the roller (if it's that tyme of machine, and NOW everything's completelt "loced." Cure: look at the brush roller and "unwind" the cord or string.\015\012 ... Vacuums

I have a kenmore progressive 359235 vacuum with intelliclean. Has been great for about 3 years but now the brush bar has stopped turning. This is a direct drive unit with a circiut breaker reset button on top . The button is not tripped. Any ideas ?


... Kenmore Vacuums

Handle got hot, circuit breaker was activated, now switch does not start vacuum


Hello. The cause of your hot handle must be investigated as you have a bare wire or connector which is shorting out. If you are handy, disassemble the handle assembly and look for melted rubber, a bare wire touching metal, etc. The fix is to repla ... Vacuums

The circuit breaker on the unit pops almost every time I use the unit, what might be causing this?


Hi, when the breaker trips every time you turn it on, the unit has a dead short. It may have a frayed wire where it goes into the units motor, or the motor it self may be shorted out.A bare hot wire that touches metal will pop the breaker right away. ... Vacuums

Dirt devil dual cyclone vacuum stopped working. it plugged up and backed up solid. now it wont run. Is there a fuse or breaker anywhere on the vacuum


... Dirt Devil Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0293 seconds