Having problems with your Oreck Vacuums ?

Filter installation Oreck PT101S - Oreck Vacuums


Answers :

Repair Help & Product Troubleshooting for Oreck Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Filter installation Oreck PT101S - Oreck Vacuums


... Oreck Vacuums

No vacuum My Floormate has plenty of air moving, but no vacuum at the nozzle. When I turn it on, the filter hops up to the black rubber "intake", rather than staying in its spot. It seems to me that the intake should be in contact with the filter when the reservoir is installed. And I don't understand why the intake isn't closer to it, but it seems fixed there, almost an inch higher than the filter. When I remove the bottom reservoir and turn the h3000 on, I feel vacuum at the intake, and air


Someone must have lost the filter cover from the machine. It is a clear blue plastic cover that goes over the filter and has a hole that lines up with the motor intake. It is approx. 3 inches square and has an angular top to coincide with the motor i ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

How to install the back hepa filter on canister vacuum cleaner. We are not sure which direction the air flows and therefore which way the arrows should point. Should the arrows point into the vacuum cleaner or point towards the outside?


The arrows in this case should point out of the machine. not into the machine. This is because you want the black rubber seal to seal on the machine and force the air through the filter. Good luck. Mark ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I Have two questions concerning my AIRVAC AV2500 Red Series Vacuum System. How do you replace the light in the floor power head sweeper and can you replace the permanent fabric filter? We had the system installed in 2004 and the light in the sweeper head just went out and can not find any manual on line on how to replace it. The filter if not torn but avter 6 years it probably needs some kine of cleaning or replaced even though it says permanent. Any help would be appreciated. Jim McCluskey


... Vacuums

Installing roller brush for oreck XL 21 - Oreck XL Ultra Bagged Upright Vacuum


Uh, probably not sure what the issue is, but \015\0121. unplug unit.\015\0122. Remove the multiple screws from the bottom of the unit.\015\0123. remove the bottom baseplate (usually black)\015\0124. the brush roll is now visib ... Oreck XL Ultra Bagged Upright Vacuum

How do you install oreck bag docking system - Oreck XL Ultra Bagged Upright Vacuum


... Oreck XL Ultra Bagged Upright Vacuum

Have new oreck quest canister and having trouble figuring out how to change vacuum bag. I have the plastic piece that you attach bag to, but don't know where the piece fits into the vacuum. looking for a diagram or manual to see where to install the plastic piece


... Oreck Vacuums

Hi, I have a oreck dual power sweeper vacuum DP460 and I am looking for replacement filter for it. Does anyone know where I can find one?


Have you tried this site click the link belowhttp://www.vacpartswarehouse.com/Oreck-DP460-Electric-Broom-s/2975.htm ... Oreck Dual Power Electric Floor Sweeper Bagless Upright Vacuum

Oreck XL21 just will not work at all any more. Beater is clean - belt is fine. Fresh bag - inflates. Took the thing apart - checked for blockages at intake, bag entry, and the tube. It just doesn't vacuum anything. No suction at all for anything stronger than air. I'd say it doesn't ****, but that would be ironic. Are these known for just "quitting" after a while? We take it in for maintenance as recommended to replace filters, etc. Is there some miracle trick to make it work or sho


Did you make sure the brush turns freely? Even though it is clean, if it does not turn freely with the belt, it will not beat the carpet and pull debris up into the unit.\015\012\015\012Another (drastic?) thing to try would be to take the unit ... Vacuums

Armor all AA255 filter installation - Vacuums


... Vacuums

How do I install l a pre motor filter in a VAX VS-190 Swift vacuum cleaner


... Vacuums

My purple Dyson Animal (without the ball) isn't working correctly. When I turn it on, the red power light, as well as the medium pile buttons flashes. When I first turn it on, the brush rotates for 3 to 5 seconds, then once I start moving the vacuum, it stops and that's when the lights start flashing. I've checked the filters, they are dry and installed correctly. What could be the problem?


I need help repairing my Dyson. I cannot push the buttons down to select Short pile/Medium pile or bare floor. The buttons will not push down at all. It will not allow me to select anything. I have very short pile carpet so it does not pick up that w ... Dyson DC28 Animal Bagless Upright Vacuum

Why is suction so poor and how do you install the filter . also vacuum gets hot fast


Dunno ur model, but if filter is full or not seated n sealed properly, itll **** at sucking. ... Sunbeam Vacuums SBH252 500W Deluxe Hand Vacuum with Attachments

I have after filters, but I'm not sure if they are for this vacuum, and if they are, how do I install them?


Lift the filter cover by depressing the thumb tab near the back of the grill. If they are the correct filters they will have a plastic ring one one side which is designed to seat in the blower hole ( where you would also plug the hose if it were clog ... Electrolux Epic 6500 Vacuum

HEPA filter installation direction - Kenmore 22313 Bagged Canister Vacuum


... Kenmore 22313 Bagged Canister Vacuum

Can't get the filter on - Oreck Dual Power DP460 Upright Vacuum


Good morning,Here is the manf. guide to the DP460:http://www.oreck.com/PUG/Power-Broom.pdfThe filter bag can be removed from the fram ... Oreck Dual Power DP460 Upright Vacuum

Dyson dco7 pre filter clip installation - Vacuums


... Vacuums

My oreck throws off and burns belts. i install a new belt and it runs fine, but as soon as i try to vacuum the carpet, it burns the belt.


... Oreck XL Ultra Bagged Upright Vacuum

The Intelliclean function isn't working properly. The indicators illuminate when I switch Intelliclean off, then on again, but the indicators are not changing (nor the power level) when I vacuum dirty areas. I need to install new filters, could a dirty sensor be the problem?


I was having the same problem with my Intelliclean and I read somewhere on the internet that I should undo the bag, clean in the area where the bag attached to vacuum. When I took bag off, something was stuck there and after I removed it, everything ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a Miele Red Star vacuum, model 314i. I bought a HEPA filter for it but am not sure how to install it.


Hi,At GoVacuum we put together a General Miele Maintenance video together for Miele Owners. Although the video showcased in the video is not specifically your Red Star machine, the filter installation is going to be the same.C ... Miele Vacuums

Oreck Dual Power Electric Floor Sweeper Bagless Upright Vacuum replacement for filter over the plastic


Dear Sir:Please follow the instruction from your section troubleshooting from user manual. or go www. fitness.manualsonline.com or www.retrevo.com or go to directly to the company from the Vacuum. and follow steps.God bless you ... Oreck Dual Power Electric Floor Sweeper Bagless Upright Vacuum

How do i install filter on Beam central vacuum model 199f


... Beam Industries Vacuums

How to install oreck xl 21 sock guard - Vacuums


... Vacuums

HEPA Filter My vacuum came with a sponge over the filter and the directions said I could wash the filter. Do the directions mean to wash the black sponge or the actual filter? Is the sponge part of the filter or is it trash? Filter F27 Dirt Devil Purpose Cleaner for Pets Upright Bagless Vacuum Model #1LY2108-000


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618630&thid=730623\015\012HEPA Filter\015\012Posted by jenski66 on Jul 02, 2008\015\012My vacuum came with a spon ... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?


Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1058 seconds