Having problems with your Oreck XL2000 Bagged Upright Vacuum ?

Oreck Celoc Hypo Allergenic Vac tearing up rug

\015 I noticed my oreck starting sounding really loud. I lifted it up and felt alot of air then I noticed wads of fur pulled from my new carpet. My Oreck kept tearing up the carpet and it wasn't sucking up the dirt on the regular carpet at all. It just seemed to be blowing a lot of air. Help it is a brand new vac!\015

Answers :

Most parts and service are covered on those machines for a year. (the 5 year part is just the motor and some "fluff" for advertising purposes) I would call oreck and find the nearest warranty service center. You should find they will fix it at no charge as long as its not deemed "abuse".
\015\012
\015\012If you call them and they will not help, repost and we'll get you fix'd up!
\015\012
\015\012Best of Luck!
Repair Help & Product Troubleshooting for Oreck XL2000 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Oreck Celoc Hypo Allergenic Vac tearing up rug


Most parts and service are covered on those machines for a year. (the 5 year part is just the motor and some "fluff" for advertising purposes) I would call oreck and find the nearest warranty service center. You should find they will fix it at no ... Oreck XL2000 Bagged Upright Vacuum

Our oreck upright sweeper is so hard to push on the carpet, why? its an oreck xl2 celoc hypo-allergenic plus and the probem occurs every time we use it. we didn't know there was a belt on it.


Change the roller brush ... Oreck XL21 Bagged Upright Vacuum

Where do I find the belt? - Montgomery Ward Oreck XL Celoc Hypo-Allergenic Vacuum Vacuum


... Montgomery Ward Oreck XL Celoc Hypo-Allergenic Vacuum Vacuum

Hoover Model U8185-900 beater bar part keeps smoking and burning up We've replaced the part Hoover PCB Display Bridge U8172 three times and the vac beater bar works for about a minute then the part starts to smoke and burns out again. I've taken everything apart but cannot locate anything that would cause this part to burn up. I think if I did not disconnet immediately, he vac would catch my rug on fire. Help? I didn't send back the warranty card, so I can't get any help from Hoover. Any suggest


I'm not sure why this is happening. Perhaps if you would contact Hoover and explain the problem to them such that it appears that there is a safety issue with their product, they might be more cooperative. If that fails, I have had luck writing let ... Hoover U8185-900 Upright Vacuum

I have the hoover automatic dual vac 5. this is the 3rd hoover rug cleaner i purchased and always the same problem the spray underneth the rotator bars hardly dispenses and the floor hardly gets wet, this has happened with all 3 rug cleaners


The carpet is not intended to get soaked, like what you see with a spray application. If you are seeing a stream of water in the nozzle/tank during the recovery stroke, this is working properly. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I have an Oreck XL Hand Vac Model #BB870-AW Type 2 Serial #SN870AWP3Z101356-Z which was used to **** up a large amount of fresh coffee grounds (not used). The vac will not turn on. What can I do? Hose not clogged; put in a new bag. Can't find my manual. Is there a filter or reset button?


... Oreck Vacuums

Oreck has become hard to push on rugs - Oreck XL2000 Bagged Upright Vacuum


... Oreck XL2000 Bagged Upright Vacuum

Dyson dc26 vac will not rug-clean, button on side of head won't stay out


... Dyson DC26 Bagless Canister Cyclonic Vacuum

I have a central vac beam model BM1372 the rug


... Vacuums

Why wont an Oreck vacuum pick up rock salt from a commercial entrance rug


... Vacuums

How to replace bag on oreck xl vac


... Oreck Vacuums

Oreck xl 21 fan housing has new design. willit stillfit my older vac


It should. You can call Oreck and talk with them and give them the serial number off your vacuum and they can look it up and tell you for sure if it will fit or not. ... Oreck Great XL21 XL 21 8 Pound Upright Vacuum Cleaner

I opend up my oreck little hero vac but don't know how to put it back together


... Oreck BB2000 XL Little Hero Canister Vacuum

Hoover Steam Vac won't extract water from rug anymore..


... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

My Oreck XL was working fine, then when I vacuumed a shag rug is started smoking and smelled like something is burning. (I changed the bag, checked for clogs--none found, and roller brush is turning. It has a metal handle.) Now I am afraid to use it.


Even though the brush is spinning, the belt is probably worn out and stretched. when you vacuum the shag carpet, it puts more drag on the brush. try running it on a shorter carpet or hard floor for a few minutes. if it doesn't smoke, then you know i ... Oreck XL2000 Bagged Upright Vacuum

A friend gave me her Oreck 1400 canister vac. It's like new, but has no "filter bag carrier." Where can I get one?


Sadly, your best and probably only bet for this is either an Oreck dealer or by calling the 1-800 line for Oreck customer service. ... Oreck DutchTech DTX1400BD with Powerhead Bagged Canister Vacuum

I have lost my battery charger for my oreck stick/hand vac serial number 200041103780 for a 9 volt /300mA battery


... Vacuums

Samsung Quiet Storm Canister Vacuum VAC-9049 The motor will not run. Power is on to the motorized rug tool. How can I remove the upper housing to get access to the motor? I have removed the six visible screws, but the housing is restrained at the rear. I suspect there are additional screws under the power switch and cord retractor assembly, but I cannot remove that either. HELP!


Hi Daltm,\015\012Thank you for contacting Fixya. This is Anil.\015\012I understand that you need assistance n opening the Samsung Vaccum VAC-9049 motor. I will be glad to help you with it.\015\012Please go through ... Samsung Quiet Storm 9048R Bagged Canister Vacuum

My Kenmore Quick Clean vac clogs at the top of cannister and does not let dirt to go to canister. After vacuum for few minutes have to stop empty before continuing to get rug clean. Is there anything that I can do to solve problem.


You need to own an air compressor,and blow out all vacuums ,after each use. ... Kenmore Vacuums

Handle broke and had to call in the duct tape. hate to trash the vac just for this reason (although i'd take almost any excuse to buy an oreck). is there any way to get a new "ergonomic handle"??? thanks


This site will probably help you:http://www.fixya.com/websearch.aspx?cx=partner-pub-8183356113384228%3A3nccpq-il5y&ie=UTF-8&cof=FORID%3A11&q=ergonomic+vacuum+handle&sa=Search#1392Jim ... Euro-Pro NV31 Infinity Vacuum

My Hoover Steam Vac for my rugs works fine, but I don't have any suction when I try to use the hose and attachment for my upholstery. I went over the instructions dozens of times but still no suction.


Which type of hose do you have? One has a duct attached to it that fits into a slot in front of the recovery tak, make sure it is seated all of the way down. The other hooks direct to the machine, is it cracked where it hooks up? You can tell by l ... Vacuums

Oreck XL9100 Our vac motor was removed to remove a hairpin in the motor.? The tape fell off the wires. Do you have a wiring diagragm?


See diagrams ... Oreck XL Ultra Bagged Upright Vacuum

Oreck rug shampooer won't release soapy water


Candycparker- Did you ever get it fixed? I have one of them and the main tube broke. I am looking fo rparts if you still have it and might be interested in selling it. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My BROAN CV-110 hose with the rug beater only works if I turn it on from the base unit. Shouldn't it turn on when I plug the hose into the wall recepticle? Do I need to replace the hardware at the end of this hose and if so, where would I purchase that? This central vac came in a house I just purchased. Thanks for any help. Sherry


... Broan-NuTone CV450 Central Bagged Central System Vacuum

Oreck xl the vac will not pick up anything on my hardwood floors. It just pushes it around yet the brush is spinning.


Sounds like the Oreck is clogged. You'll have to undo the bag by the way of the clip in the middle at the back of the main black spindel neck and then at the bottom. Then take apart the main neck by pushing the rubber mounts upwards to release the pi ... Oreck XL2200 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0311 seconds