Having problems with your Oreck XL2000 Bagged Upright Vacuum ?

My oreck is very hard to push. what could be the

\015 My oreck is very hard to push. what could be the problem. My oreck XL is only several months old. The more I use it the harader it is to push. I have checked for clogs and changed the bad and cleaned the brushed. Help.\015

Answers :

Clean and oil wheels
Repair Help & Product Troubleshooting for Oreck XL2000 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My oreck is very hard to push. what could be the


Clean and oil wheels ... Oreck XL2000 Bagged Upright Vacuum

I have an Oreck XL Platnium. It smells like burning rubber and the brush roller binds and stops as you pull it back and forth, even on a hard floor. I have changed the belt 2 times. I have taken the brush roller out and checked it. It seems to be spinning freely. What could be wrong??


... Oreck XL Ultra Bagged Upright Vacuum

My Dyson DC07 has recently been service and was making a clattering noise and very hard to push. We have taken it back and he has changed the clutch mechanism under the base which has solved the clattering, but it is still really hard to push because of the suction. It is even lifting the carpet in one room. Can you tell me what the possible reasons for this could be? One thought we had was that the little rubber wheels on the bottom cover could have worn so the hoover is closer to the floor


On the sole plate you should have 5 little wheels, these are prone to jamming after a while. You should make sure these are not jammed in anyway.\012\012You can release these with a screwdriver, but be careful not to prize too hard as you ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Oreck has become hard to push on rugs - Oreck XL2000 Bagged Upright Vacuum


... Oreck XL2000 Bagged Upright Vacuum

Oreck XL Is there any chance you could e-mail me the wiring diagram for the Oreck XL? I just can't read the one that's on-line. Thanks, [email protected]


I would advise you to ALWAYS to FIRST UNPLUG THEIR VACUUM before beginning any service procedure. The motor has 5 wires to the motor as stated in the Oreck owners manual, tow are for the headlights, one is a ground wire, and the other two are f ... Oreck XL Ultra Bagged Upright Vacuum

Oreck upright hard to push - Oreck XL2000 Bagged Upright Vacuum


If hard to push, only a few things to check:\015\012\015\012(1) Rear wheels will get hair or thread wrapped around axles, dust, etc. and be hard to turn. Make sure each wheel turns easily.\015\012\015\012(2) Small wheels on ne ... Oreck XL2000 Bagged Upright Vacuum

Oreck seems to push hard at random times oreck xl type 6


... Oreck XL Ultra Bagged Upright Vacuum

Hi I am wondering if someone could send me some (Schematics for a Bissell 9300-1) I took it all apart to clean out all the ( Hard watter out of the hoses) and now I cant remember where all the hoses go,I need to see where all the hoses go so I can hook up if someone could help me out! Thanks!!


Hi, you should be able to download the manual/manuals you need on the following web page. Just paste the following onto your search bar. I've used this site to find manuals before, it can be trusted. Good luck!\015\012http://www.manualsonline. ... Bissell Vacuums

Oreck Orbiter Hi Could you e-mail me a wiring diagram for the Oreck Orbiter please? I need to replace the mains cable & the cable to the motor. Thank you, Helen Eccott.


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618779&thid=681757\015\012Oreck Orbiter\015\012Posted by eccott on Jun 18, 2008\015\012Hi could you e-mail me a w ... Oreck Orbiter Floor Machines ORB-500, ORB-550, ORB-600 Vacuum

My oreck XL7 smells when it's on. Smells as if it's the motor. Had the Oreck for 4 years but hardly used it?


The smell is probably from the belt. When they are worn and stretched they can start to smell. You can get replacement belts for your model here:Oreck XL7 Rep ... Oreck XL Ultra Bagged Upright Vacuum

Our oreck upright sweeper is so hard to push on the carpet, why? its an oreck xl2 celoc hypo-allergenic plus and the probem occurs every time we use it. we didn't know there was a belt on it.


Change the roller brush ... Oreck XL21 Bagged Upright Vacuum

Oreck XL hard to push


Yes. it might be broken. you will need to remove the 5 screw on the bottom and see if the belt is burned. it more that likly is. ... Oreck XL Ultra Bagged Upright Vacuum

How to raise the brush on my Oreck. I got new carpet and it is so hard to push


If you need to adjust the brushes take the belt off and turn the brush roll to the next position, this link is the manual it will give you instructions on page 7 ... Vacuums

I'm trying to clear the tube on an Oreck upright and can't loosen the upper ring. Very hard to get at with the bag on.


If you have a large pair of pliers you can use that to loosen the upper ring. ... Oreck XL Ultra Bagged Upright Vacuum

My Oreck upright is picking up fine, but is very noisy on bare floors. What could be causing this?


FLIP UP SIDE DOWN AND REMOVE COVER AND CLEAN BRUSH,SOMETHING MAY BE WEDGED IN THERE,I HAVE ON TOO.IF YOU NSTILL HAVE YOUR WARRANTHY,THEY WILL TUNE FOR FREE,I KEEP EXTRA BELTS,THEY STRETCH IN TIME.ALSO CHECK TO SEE IF ANYTHING IS BENT,RUBBING ON SOMET ... Oreck XL Ultra Bagged Upright Vacuum

My bissell 3595-2 vacuum cleaner started turning off the power automatically. Now I can not get it to turn on. This vacuum cleaner is still in real good condition, as I have hardly used it. Please advise what could be wrong. I was thinking maybe a loose connection with the on-off switc.


... Bissell Vacuums

My Oreck has in the last 2 weeks become very hard to push on carpet , ok on bare floors. Thanks


Look at 3 things:\015\012(1) is there something wrapped around the rear \015\012wheels or axles?\015\012(2) Is there something wrapped around the small, front wheels or axles. (not likely this is the culprit.)\015\012(3) Is yo ... Oreck XL2000 Bagged Upright Vacuum

My Oreck has become very hard to push across carpet


IF IT PUSHED EASILY ON THE SAME CARPET BEFORE, THEN THE BRUSHROLL IS NO LONGER CONTACTING THE CARPET IT USED TO. A NEW BRUSHROLL AND/ OR BELT SHOULD GET YOU MOVING AGAIN. TRY THE BELT FIRST, MUCH CHEAPER.\015\012\015\012IF YOU HAVE RECENT ... Oreck XL Deluxe U3700 Bagged Upright Vacuum

I have bosch forumla vaccum and cord got stuck. It is very hard for me to see the screws to open it. Could somebody help me how to open this safely.


This problem is solved easily after I found the third screw to open the top cover. You will find the third screw under the top cover where the variable regulator is. But be patience, your small mistake can screw up whole system. You will need a torx ... Bosch BSG71360UC Bagged Canister Vacuum

Oreck Upright Hi Redev, I'm not sure what model I have (about 6 years old...upright, looks like the one in the picture). I changed the belt (which was torn) and then the next time I used it, it cut off on me. Now if won't turn on at all. (I turn the switch on and off and nothing happens as if it is not plugged in but it is!). I noticed at the top where the power cord enters the handle, it is all frayed. Could the electrical wires have detached? Anything you think I should check before taking it


The cord could be bad and will ahve to be replaced. It would have to have a problem inside the handle or down by the motor. ... Oreck XL2600 Vacuum

I have a windtunnel upright self-propelled that is very difficult to push, on carpet or hard floors. Seeems that it is stuck to the floor and at times you can smell the rubber from the belts. What could be the problem or problems?


Raise the front. you are trying too hard ... Vacuums

Wiring Schematic Hello, Did you ever receive the wiring schematics for your Oreck vacuum? If so, could you frward them to me, as I have the exact same problem. Thank you.


\015\012\015\012Should ... Oreck XL Ultra Bagged Upright Vacuum

Brushes won't turn remain motionless as if cleaning hard floors even though button depressed could it be a problem with the brushes or button still under guarantee


There is a re-set button located on the brush head on the left side as viewed if you are standing directly behind the vacuum cleaner. It is black in color and is recessed slightly into the cover of the brush cover. It is round and about the size of t ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Vacuum hard to push - Oreck XL21 Bagged Upright Vacuum


You probably have a broken belt. replace it ... Oreck XL21 Bagged Upright Vacuum

My purple and red Dyson has become hard to push. Could a belt have broken?


It's simple to tell if a belt has broken. Just switch the machine on and have a look (look, don't feel) to see if the brush roller is rotating. If it is, then the belt is not broken.\015\012\015\012Depending on how much use your machine has had ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1331 seconds