Having problems with your Oreck XL21 Bagged Upright Vacuum ?

Oreck xl vac

\015 Air flow tube is plugged. I can't get it apart to clean out. It says to press the 2 pins at the base but they don't move when I try to press them, even using a pliers.\015

Answers :

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=19805&thid=719784
\015\012Oreck XL vac
\015\012Posted by ddevol on Jun 29, 2008
\015\012Air flow tube is plugged. I can't get it apart to clean out. It says to press the 2 pins at the base but they don't move when I try to press them, even using pliers.
\015\012
\015\012Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. The tube going into the motor section is to push the pin and then twisted, the lower part get a dust and dirt build up and sometimes hard to remove, give it a shot of WD-40 @ the top and bottom of the fill tube and then repeat the pus in the tab and twist and it should come loose. There are also in the bigger cities the Oreck stores that you can also bring it to as well. If you have further problems or you do not have the strength to do this, bring it to a local vacuum cleaner dealer in your area and it is only a 5 or 10 minute job to remove the tube and to unclog the vacuum. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.

\015\012http://www.oreck.com/ Customer Service 1-800-989-3535
\015\012Monday thru Friday Hours are: 7:00 am to 7:00 pm CST
\015\012Saturday and Sunday Hours Are; 8:00 am to 4:30 pm CST
\015\012Thanks, Don the Vac Man
Go Ahead. Use Us.

\015\012
Repair Help & Product Troubleshooting for Oreck XL21 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have an Oreck XL Hand Vac Model #BB870-AW Type 2 Serial #SN870AWP3Z101356-Z which was used to **** up a large amount of fresh coffee grounds (not used). The vac will not turn on. What can I do? Hose not clogged; put in a new bag. Can't find my manual. Is there a filter or reset button?


... Oreck Vacuums

Oreck Celoc Hypo Allergenic Vac tearing up rug


Most parts and service are covered on those machines for a year. (the 5 year part is just the motor and some "fluff" for advertising purposes) I would call oreck and find the nearest warranty service center. You should find they will fix it at no ... Oreck XL2000 Bagged Upright Vacuum

Oreck xl 21 fan housing has new design. willit stillfit my older vac


It should. You can call Oreck and talk with them and give them the serial number off your vacuum and they can look it up and tell you for sure if it will fit or not. ... Oreck Great XL21 XL 21 8 Pound Upright Vacuum Cleaner

How to replace bag on oreck xl vac


... Oreck Vacuums

I opend up my oreck little hero vac but don't know how to put it back together


... Oreck BB2000 XL Little Hero Canister Vacuum

I need a wiring spec for oreck vac Mod # XL3600HH


... Oreck Vacuums

Oreck xl vac


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=19805&thid=719784\015\012Oreck XL vac\015\012Posted by ddevol on Jun 29, 2008\015\012Air flow tube is plugged. I ... Oreck XL21 Bagged Upright Vacuum

My oreck vac is smoking - Vacuums


... Vacuums

My oreck rinse-o-matic vac keep shutting off while i'm cleaning. I cleaned the water out and added new, I checked to see if anything was jammed up at bottom. It keep shutting off??


I had the same problem...kept pushing the reset button on the plug, but continued to shut off. Took it to my local electrician, who removed the plug w/reset and replaced it with a regular plug...works fine now. Must've been a short in the reset part. ... Oreck Vacuums

Oreck model BB870-AS - I was vaccuming when the vac shut off. The motor just spooled down and nothing more since. I have opened the case. Have power at the switch, and to the motor, but can't get a voltage reading to the common lead at the motor. Is there a fusible link, or something similar in that lead that might have burned out? Thanks!


... Oreck Vacuums

I have an oreck gold vac with the new lifetime belt, and it keeps cutting off. what do i do?


... Oreck XL U4150 Gold Bagged Upright Vacuum

I have lost my battery charger for my oreck stick/hand vac serial number 200041103780 for a 9 volt /300mA battery


... Vacuums

Handle broke and had to call in the duct tape. hate to trash the vac just for this reason (although i'd take almost any excuse to buy an oreck). is there any way to get a new "ergonomic handle"??? thanks


This site will probably help you:http://www.fixya.com/websearch.aspx?cx=partner-pub-8183356113384228%3A3nccpq-il5y&ie=UTF-8&cof=FORID%3A11&q=ergonomic+vacuum+handle&sa=Search#1392Jim ... Euro-Pro NV31 Infinity Vacuum

How to change the bag in the Oreck XL hand canister vac? I can't seem to get the plastic piece back in before locking with the metal clip. Is there a diagram to show me?


... Oreck Vacuums

Oreck XL9100 Our vac motor was removed to remove a hairpin in the motor.? The tape fell off the wires. Do you have a wiring diagragm?


See diagrams ... Oreck XL Ultra Bagged Upright Vacuum

My daughter has an Oreck Vac that won't power on. Is there a reset button somewhere?


... Oreck XL2000 Bagged Upright Vacuum

Oreck xl the vac will not pick up anything on my hardwood floors. It just pushes it around yet the brush is spinning.


Sounds like the Oreck is clogged. You'll have to undo the bag by the way of the clip in the middle at the back of the main black spindel neck and then at the bottom. Then take apart the main neck by pushing the rubber mounts upwards to release the pi ... Oreck XL2200 Bagged Upright Vacuum

Oreck xl 1900 vac no suction


... Vacuums

A friend gave me her Oreck 1400 canister vac. It's like new, but has no "filter bag carrier." Where can I get one?


Sadly, your best and probably only bet for this is either an Oreck dealer or by calling the 1-800 line for Oreck customer service. ... Oreck DutchTech DTX1400BD with Powerhead Bagged Canister Vacuum

I have a Oreck Versa Vac and the water container does not want to pop back in after I take it out


... Oreck Vacuums

I need the specs. for an oreck xl car vac.


... Oreck XL Auto Car Vacuum

Oreck 9100C Vac


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=19810&thid=647356\015\012Oreck 9100C Vac\015\012Posted by thecleaner on Jun 04, 2008\015\012How to I replace both ... Oreck XL Ultra Bagged Upright Vacuum

Wattage of our Oreck Plus XL 2


Electrical Facts Germany | Voltage Converters Adapters | Europe ...\015\012There are basically two kinds of voltage converters. ... Adapting a television ... Oreck XL Ultra Bagged Upright Vacuum

I'm trying to clear the tube on an Oreck upright and can't loosen the upper ring. Very hard to get at with the bag on.


If you have a large pair of pliers you can use that to loosen the upper ring. ... Oreck XL Ultra Bagged Upright Vacuum

Hoover u5781-900, motor shuts off (intermittent)when you shake vac or make jerky movements.If you move vac to up right position the vac starts right up.When you giggle vac, motor starts and stops no mater if you just started up or vac for ran for 45 min. Thanks Lucy C.


Lucy\015\012you have a bad connection somewhere in the unit\015\012this is a fire hazard and you should not use this until its been fixed\015\012could be a pinched wire or broken connections ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0371 seconds