Having problems with your Oreck XL2200 Bagged Upright Vacuum ?

What do i clean the burnt rubber on the shaft of my oreck with?


Answers :

Use some fine grit sand paper, steel wool, or a wire brush. Turn the vacuum on without the belt installed and gently use one of the above on the shaft. If you have any other questions, just feel free to ask.
Repair Help & Product Troubleshooting for Oreck XL2200 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What do i clean the burnt rubber on the shaft of my oreck with?


Use some fine grit sand paper, steel wool, or a wire brush. Turn the vacuum on without the belt installed and gently use one of the above on the shaft. If you have any other questions, just feel free to ask. ... Oreck XL2200 Bagged Upright Vacuum

Just replaced the roller on my oreck XL, and it is smelling like burnt rubber


If the roller bearings are starting to seize the the belt may be slipping ... Oreck XL Ultra Bagged Upright Vacuum

Burnt smell..not the belt...shaft and brushes are cleaned and moving...what is it! HELP!


Check your switch eureka's are bad about switch's burning up. ... Eureka The Boss Bagless Stick Vac - 166DX

The brush on my dc07 will not spin while vacuuming and it also smells of burnt rubber. I cleaned the brush bar and the belt is intact...


... Dyson DC07 Bagless Upright Cyclonic Vacuum

How to clean out an oreck canister vacuum from bedbugs


You can buy a spray for killing fleas in carpets, either from hardware store or vet. I suggest you try spraying inside vacuum. ... Oreck Vacuums

I have an Oreck xl21 that makes a lot of noise. I think the fan is loose of the shaft causing it to wobble. I cannot seem to get the fan off the shaft. Does anyone know how?


... Oreck Vacuums

My Oreck XL 9100HA started smoking (white smoke) when I vacuumed. There is a burning rubber smell. How do I check/change (if appropriate) the belt? I have no User manual, nor can I locate one on the Oreck site. The bag is a new one. The vaccuum had been picking up, though not at its best strength.


It sounds like the belt has been damaged. You can get another belt from yoru local Oreck store. You can even take it in to the store to show them what happened. Purchase another belt and replace it. (It was very easy when I did this, so hopefully ... Oreck XL Ultra Bagged Upright Vacuum

Hi, the seal from the impeller and pump shaft leaked. got new seal kit and installed. only disconnected the contacts piece to get clean attachment to shaft and the points now stay together looking like the springs are frozen thanks for your help


Hi ggetman38...\015\012\015\012That is normal\015\012What you are talking about is the centrifugal switch, they will swing apart when the motor rotates, they are there to start the motor with the points touching each other at motor ... Vacuums

My oreck rinse-o-matic vac keep shutting off while i'm cleaning. I cleaned the water out and added new, I checked to see if anything was jammed up at bottom. It keep shutting off??


I had the same problem...kept pushing the reset button on the plug, but continued to shut off. Took it to my local electrician, who removed the plug w/reset and replaced it with a regular plug...works fine now. Must've been a short in the reset part. ... Oreck Vacuums

Oreck Steam Carpet Cleaner Signature Series, How do you work it with the wheels, where do they go.I have an older Oreck Steam Cleaner and I don't know where the wheels should go when i am cleaning


... Oreck Vacuums

My Oreck XL upright is blowing out instead of sucking in. I changed the bag and cleaned the brushes; I also cleaned out the main "pipe." I looked for a place to change settings and couldn't find any, so I know I didn't inadvertently switch something. The brushes seem to be spinning at the correct speed. Thank you, Julia Byrem


... Oreck XL2200 Bagged Upright Vacuum

I heard that a class action lawsuit against Oreck Vacuum is being started because of all the problems customers are having with their vacuums. Does anyone know about this? My Oreck is only a couple of years old and keeps burning up belts. I took it in after only one week of usage when I started to notice white smoke coming out of it and the smell of burning rubber. I feel like I got the old run-around, when the service tech told me he couldn't find anything wrong (but replaced the burned up belt


You are correct about the fact that legal action has been taken. Go to this link to read more\015\012\015\012 ... Oreck XL2200 Bagged Upright Vacuum

My Generation 3 Kirby Vacuum is giving off a burnt rubber smell when I vacuum. I have tried to raise the height of the head but it still happens. Can you tell me what could be causing rubber to burn? What needs to be fixed?


The belt driving the brush roller in the power head is slipping. It is really just a big thick rubber band. Where it wears out it slips and burns due to friction. Look at the bottom of the power head. There is a cover plate held with 2 to ... Kirby Generation 3 Bagged Upright Vacuum

The powerhead will turn until you touch it down on the carpet then the belt just spins (burning rubber smell). Is there supposed to be a fitting around the metal shaft opposite the powerhead or does the belt ride on the metal shaft?


That means that the belt is stretched and worn and needs to be replaced. Here is the belt you need and the manual which has instructions: ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Simplicity freedom vacuum has a burnt rubber smell


If the belt is continually wearing out I would think that the brush cylinder is not free to rotate. Take the belt off and ensure that the brush cylinder moves freely. If is does not, then you need to investigate why - probably something wound round i ... Simplicity 7250 Deluxe Vacuum

Burnt rubber smell when vacuuming


This could be a few things:A. If your model has a floor selector switch (Bare floor/tools - Carpet) your clutch could be worn. (there is a rubber clutch pad between your cam and roller shell) - Fix would be to replace the clutch pad and belt. ... Simplicity Vacuums

Oreck XL Shield stopped sqirting water and soap out while cleaning couch


... Oreck XL Shield Power Scrubber Floor And Carpet Cleaner

My Oreck vacuum cleane won't turn on


I have an Oreck vacuum. My son used it just earlier today and it worked just fine, then just a little while ago a tried to turn it on to vacuum our bedroom and suddenly it won't turn on! I tried plugging it into other outlets but it was no use. M ... Oreck XL2200 Bagged Upright Vacuum

I want to take the fan impellar off the motor to clean it. I cant seem to get the metal housing off of the motor. Do you have to take the nut off the impellar If so how do you stop the shaft from turning thank you.


Very simply you dont take the fan out of the motor. it was not made to be removed or cleaned because its not supposed o get dirty if your using good bags in the vacuum. the best you can do is blow it out with an air hose. ... Electrolux Epic 6500 Vacuum

Smells (burnt rubber) like it's overheating when I vacuum


I would check the brush roller and make sure it turns good and replace the belt on it . When you smell burning rubber most of the time it is the belt . ... Kirby Ultimate G Bagged Upright Vacuum

Hi there Hi have a Samsung VCU2913 Bagless Upright Vacuum. The wheel at the bottom have a rubber where it is driven by for the brush to clean the floor. Where can I get this, its n new vacuum... now I cant use it. I am in SA , Pretoria


Go back to where you bought the vacuum and ask for a BELT. Take the MODEL # with you and buy 2. Always keep a spare ... Samsung Vacuums

Oreck schematics Did you ever get the schematics in pdf or a clear picture? I need the same thing to hook up my lights. Accidently burnt them out due to improper connect.


... Oreck XL Ultra Bagged Upright Vacuum

FAN PROBLEM??? good morning! my vacuum smells like burnt rubber (fan perhaps) but I can't find how to get into main part of the vacuum. it's just very rounded with no latches or screws to get inside where the motor, belts and fans would be located. can you help me? thank you


There isn't any belts, and the fan wouldn't be rubber, so not sure what you are smelling. Maybe this picture will help you.\015\012\015\012 ... Bissell 6700 Butler Revolution Bagged Canister Vacuum

I have a Hoover Wind Tunnel, model #U6655-900. I have changed both belts & have cleaned the brush. It is difficult to push and I smell burning rubber. Do you have any suggestions?


The transmission for the self-propelled could be broken. That's the reason it's difficult to push and the smell ... Vacuums

Cleaned hair/string buildup around beater bar , put everything back in place now vacuum makes knocking noise and has that burning rubber smell.


This sounds like the beater belt is slipping and may be due to the fact that the beater brush is not secured correctly or there is debris / grease build up inder the belt. Try cleaning it with Methylated Spirit and repalce the belt. Do not clean the ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2579 seconds