Having problems with your Oreck XL2200 Bagged Upright Vacuum ?

Oreck vaccuum is leaving black marks on hardwood floor

\015 Just changed belt, tried both sides of belt but still leaves huge black marks when vaccuuming\015

Answers :

Repair Help & Product Troubleshooting for Oreck XL2200 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Oreck vaccuum is leaving black marks on hardwood floor

... Oreck XL2200 Bagged Upright Vacuum

Oreck vacuum leaves brush marks on hardwood floor

... Oreck XL Ultra Bagged Upright Vacuum

My new oreck magnesium upright is making a black marks on my hardwood floor. what should i do?

... Oreck XL2200 Bagged Upright Vacuum

It leaves dirt and fluff in the rollers not in the filter. So is not cleaning properly. There is never anf fluff at all in the filter. Also the lid does not close properly and we constantly get the 'check tank' light coming on. It leaves streaky marks across the floor and seems to leave the floor too wet (hence the streaks). Look forward to hearing from you.

Is there something stuck in the air passage between the tank and inlet ... iRobot 5800 Scooba Vacuum

Replaced Oreck power switch. 2 black leads and 1 white lead for switch. Posts marked 1, 2, and 3. 2 black wires to switch powers on. Connect white wire and breaker trips. Where does the white wire go?

Both black go to the switch. Power in - black to switch / white to white from motor. From motor - black to switch / white to white from power cord The black wire from the power hooks to ... Vacuums

Poor cleaning I recently bought the Shark Steam Mop as I read mainly fantastic reviews. I was disappointed to find that it leaves a slight film on my dark hardwood floors when finished. I can wipe the film away with my finger and you can see foot prints if walked over. I also found that there are cloth streaks on my ceramic floors after drying as well. I followed all instructions, vacuumed beforehand, used distilled water even though my water is not considered hard, cleaned slowly, etc. I am wo

Hi,This type of problem usually is not he fault of the Shark Steam Mop.The problem is the old residue left on the floors by other cleaners.Here is a tip that I wrote that will help you out with that problem... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Steam mop leaves wheel marks on timber floors

... Vacuums

Oreck xl the vac will not pick up anything on my hardwood floors. It just pushes it around yet the brush is spinning.

Sounds like the Oreck is clogged. You'll have to undo the bag by the way of the clip in the middle at the back of the main black spindel neck and then at the bottom. Then take apart the main neck by pushing the rubber mounts upwards to release the pi ... Oreck XL2200 Bagged Upright Vacuum

My vacumm is leaving scuff marks on my hard wood flooring

Contact Dyson vacuum cleaners fans heaters accessories spares official site ... Dyson Ball DC24 Bagless Upright Vacuum

Vacuum smells like burning rubber when on, no suction, leaving black marks on carpet

Usually when my vacuum smells like burning rubber, the belt needs to be changed and that is very easy to do. You just need to remove the the screws that hold in the rotator and put in a new belt. When the belt needs to be changed the vacuum will no ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

When vacuuming the floor it does not leave brush marks or pick up anything unless you reach down and lift on the very front of the machine and then it works for a while and quits again

The belt is probably worn or stretched. When this happens the belt won't turn the roller brush when it is against the carpet. Here is a link for the manual and links for the belts you need: ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Oreck is hopping on my carpet while vacuuming. It is fine when pushed away - it hops and leaves marks on my carpet when I pull it back. I have changed the bag and cleaned off the roller and checked for a clog. All are fine.

My first thought is to change the belt.If it is stretched this is a common symptom.You can go to youtube and my chanell is sewvacmd.Their is a video on how to change it.Hope this helps. ... Oreck XL2200 Bagged Upright Vacuum

Not picking up no suction leaving black marks on carpet

... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

Kirby Sentria My vacuum is leaving scuff marks on my hard wood floor any ways to fix?  please help.. thanks.

Be sure that the brush roller is dusengaged. \012To do this you:\012* Lift up the headlight lamp\012*Turn the handle until the red arrows line up ... Vacuums

Oreck does not have good suction and leaves lint on rugs, and floor---any solutions?

If it has been longer than 6 months I woulf replace the belt. Wile doing that look to the rear of the vacuum and the side chute and make sure you do not have anything plugging those entrances. ... Oreck XL2200 Bagged Upright Vacuum

I have oak floor and there are scuff marks. Is it...

If you have a wax finish you can buff out scuffs with just a cloth. for polyurethane, do not use water. use the cleaner with a soft terry cloth. to much presure can make it worse.you can also use a small amount of paint thinner on polyurethane. make ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Orech scratching hardwood floor ???

Sue them, that is what I am doing, I bought one last year that did over 5000.00 damage to my hardwood floors. ... Oreck XL2200 Bagged Upright Vacuum

Oreck upright leaving dust trails

... Oreck XL Ultra Bagged Upright Vacuum

When vacuuming hardwood floor, hair gathers on brush and never sucks into vacuum. I spend most of my time cleaning off brushes. How do I clean hardwood floor with dog hairs.

1. Broom and dust pan, then mop\015\0122. Wet dry vac with wide non-brush attachment\015\0123. Here's a link to a vacuum professing to clean pet hairs well\015\012\015\012 ... Sebo Air Belt C2.1 Bagged Canister Vacuum

How do I remove a hardwood floor polish safely from a laminate floor

Www.hard-wood-floor-cleaners.com and select the best chemicals and use for your hardwood polish laminate flooring.God bless you ... Vacuums

Dyson vacuum I have a DC07 vaccuum. The problem I am having is that the front does not want to stay down as I vaccuum and I continuously have to keep stepping on the front to make it go back down to the floor. It seems as though there is either not enough weight in the front or possibly the unit just has to be broken in so that there is not so much resistance between the handle and the front of the vaccuum. Could there be something I did not remove or is this typical on these vaccuums?

There is some thing broken it is two plastic cogs they help the front go down and stay up you will have to get a star screw driver and there should be two screws on top and two at the b ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No Suction The suction of the vaccuum has stopped. We haven't had the vaccuum for very long and the bag has been recently changed. Both the floor vaccuum and the hose are not picking anything up. I'm not sure what the problem could be.

Your Power head is blocked with hair or dirt,,or the hose which connects the Upright with the power head is blocked.Try taking a steel coat hanger apart (straighten it out) and then push it into the pickup hose to remove blockage. ... Eureka Smartvac 4870 Bagged Upright Vacuum

Hazy floor I have used the Shark Professional on my tile floor in kitchen. It keeps leaving it look hazy. I tried vinegar and water mixture twice and still no luck. I agree it really does clean the floor but I no not like the hazy look.. It happes on all three settings

If your floor has acrylic finish then some solutions will dry coat the top. Does buffing it after litely with a rag shine back Up. If so then you need to get solution made for your floor. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Noise Hi... I was doing normal house work and had been using it on carpet... I put it on floor for my hardwood floors and picked up loose clean cat litter and went to put it back on carpet and it made a horrible noise like it was rubbing. cleaned the filter... cleaned the roller thingi ...checked the belt and it is still making that horrible noise. It does not make the noise when I have it on floor but as soon as I put it on carpet it screams at me. Help! Please and thanks Linda

Hi Linda,\015\012Sounds like clutch problems, try to move the lever for carpet/floor back and forth a few times maybe it will free up. If it still makes the grinding noise, the clutch assembly will have to be replaced. Let me know, i can even ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Black marks on carpet

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=19810&thid=706295\015\012Black marks on carpet\015\012posted by carpetburner on Jun 25, 2008\015\012While I was w ... Oreck XL Ultra Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0752 seconds