Having problems with your Oreck XL Ultra Bagged Upright Vacuum ?

Oreck upright leaving dust trails

\015 Changed the bag, checked all I can check but my Oreck is leaving dust/dirt trails behind. It still sucks up stuff but there are dust/dirt marks left here & there, very frustrating!!! Any solutions greatly appreciated. Thanks in advance!!!\015

Answers :

Repair Help & Product Troubleshooting for Oreck XL Ultra Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Oreck upright leaving dust trails


... Oreck XL Ultra Bagged Upright Vacuum

Vacuum leaves a trail of dust


... Eureka Whirlwind LiteSpeed 5843 Upright Vacuum

My Oreck Upright will not stay upright! The handle falls over everytime I leave it stand on its own.


What you are in need of is what they call a detent. There is a possibility that is has broken off from the housing which means that the only way to repair it properly is to replace the entire housing. It may have just had the screw come loose and h ... Oreck XL® Classic Bagged Upright Vacuum

Vacuum leaves a trail of dust


... Eureka Whirlwind LiteSpeed 5843 Upright Vacuum

How do i stop dust coming out of vacuum - Oreck XL Ultra Bagged Upright Vacuum


Change the bag. ... Oreck XL Ultra Bagged Upright Vacuum

Oreck vacuum leaves brush marks on hardwood floor


... Oreck XL Ultra Bagged Upright Vacuum

My Oreck XL is blowing air and dust out instead if sucking.


... Oreck XL Ultra Bagged Upright Vacuum

How to detach oreck upright bag to wash


... Oreck XL Ultra Bagged Upright Vacuum

Oreck upright brushes not spinning - Oreck XL21 Bagged Upright Vacuum


... Oreck XL21 Bagged Upright Vacuum

How to replace motor on oreck xl upright - Oreck XL Ultra Bagged Upright Vacuum


... Oreck XL Ultra Bagged Upright Vacuum

Replacement brush for Oreck ProPower Plus - Oreck Pro Power Plus Upright Vacuum Refurbished Refurbished Pro Power Plus Upright


... Oreck Pro Power Plus Upright Vacuum Refurbished Refurbished Pro Power Plus Upright

How to unclog the Oreck XL upright? - Oreck XL2200 Bagged Upright Vacuum


... Oreck XL2200 Bagged Upright Vacuum

Oreck upright hard to push - Oreck XL2000 Bagged Upright Vacuum


If hard to push, only a few things to check:\015\012\015\012(1) Rear wheels will get hair or thread wrapped around axles, dust, etc. and be hard to turn. Make sure each wheel turns easily.\015\012\015\012(2) Small wheels on ne ... Oreck XL2000 Bagged Upright Vacuum

Oreck propower brush not turning - Oreck Pro Power Plus Upright Vacuum Refurbished Refurbished Pro Power Plus Upright


... Oreck Pro Power Plus Upright Vacuum Refurbished Refurbished Pro Power Plus Upright

Why does my Oreck drag on carpeting? bought an Oreck upright 4.8 bagless at a garage sale. Great on the kitchen floor but seems to drag , difficult to push on the commercial carpeting. any hints


... Oreck Dual Power Electric Floor Sweeper Bagless Upright Vacuum

Faithful Sebo X1 upright, about 12 years old, stopped working today. I replaced old with new dust bag, checked all dust paths were clear, checked main brush was clear/clean, and drive spindle rotated OK with fingers. When power switched on, the two red indicators briefly flash on then off, but nothing more happens, motor does not start - even with power reaching machine. Tried removing all consumables, refitting and turning on a few times to reset, no joy. Removed base cover, both belts were i


At 12 years, this vacuum has had a good long life. I suspect the motor is shot, but it could be due to faulty wiring and connections. A bad switch, break in the power cord, and worn brushes in the motor are other causes.\015\012I recommend ta ... Sebo Automatic X1 Bagged Upright Vacuum

Installing roller brush for oreck XL 21 - Oreck XL Ultra Bagged Upright Vacuum


Uh, probably not sure what the issue is, but \015\0121. unplug unit.\015\0122. Remove the multiple screws from the bottom of the unit.\015\0123. remove the bottom baseplate (usually black)\015\0124. the brush roll is now visib ... Oreck XL Ultra Bagged Upright Vacuum

How to disassemble oreck xl 21 vacuum - Oreck XL Ultra Bagged Upright Vacuum


... Oreck XL Ultra Bagged Upright Vacuum

My Oreck vacuum cleaner will only stay on in the upright position. If I try to recline it to vacuum, it shuts off...put it back up and it turns back on. Of course I can't vacuum in the upright position...what do I do?


It sound as if you have a short in the cord or it has come loose from the motor you can take it part by removing the four screws in the buttom of the base plate to see if any of the wires are loose. ... Oreck Vacuums

Sock stuck in oreck vacuum - Oreck XL2000 Commercial Upright Vacuum, XL 2000


... Oreck XL2000 Commercial Upright Vacuum, XL 2000

Upright vax blowing out dust - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Oreck xl 2100 vacuum belt keep on slipping - Oreck Xl 2100 Bagged Upright Vacuum


... Oreck Xl 2100 Bagged Upright Vacuum

Hi, I have an Upright Vacuum. Unfortunately, the box that contains the Dust container handle, and the Dust container pipe, has broken the base. It is right where we open it to clean the pipe. It is possible to buy the whole tube? Alicia


Hi, yes it is possible to buy the whole tube replacement but you have to get in touch with the manufacturer of the vacuum cleaner to make a request for the needed parts.Take care ... Vacuums

Our oreck upright sweeper is so hard to push on the carpet, why? its an oreck xl2 celoc hypo-allergenic plus and the probem occurs every time we use it. we didn't know there was a belt on it.


Change the roller brush ... Oreck XL21 Bagged Upright Vacuum

Oreck has become hard to push on rugs - Oreck XL2000 Bagged Upright Vacuum


... Oreck XL2000 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0569 seconds