Having problems with your Powr Flite Vacuums ?

Leaking valve on wand

\015 I am looking for a valve for my powr-flite PFX1300 series. the valve is on the wand and i cannot find the part under the illustration in the parts catalog. can you help? the model # is PFX1300HP-N and the serial # is A16966.\015

Answers :

Repair Help & Product Troubleshooting for Powr Flite Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Leaking valve on wand


... Powr Flite Vacuums

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper


... Vacuums

My Delonghi DSS50 steam floor cleaner water reservoir has a broken valve on the bottom where it fits into the steam unit. It leaks water rather than producing steam. I would like to find the valve and replace it or buy a new water reservoir with the valve in it. I cannot find the part I need. Can you help me?


... DeLonghi DSS50 Scopa Upright Steam Vacuum

Hoover Steam Vac clean water tank valve leaks


A) make sure that there is not a place for a stair attachment. If\015\012there is make sure air is not leaking through where the attachment goes\015\012on because of damaged or misplaced fitting.\015\012\015\012b) some steam ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Water tank valve is leaking out of the bottom of the tank. The water leaks on the floor.


It could be a cheap fix. There should be a rubber o ring that's worn or ate away by chemicals.\015\012I'm hoping the tank isn't cracked.\015\012Remove o ring. Contact repair place. O ring shouldn't be more than 5.00. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

I have the Hoover SteamVac Dual Model F7246-900 Serial AA12.0. In the Clean Water Tank the small black plastic check valve leaks water as machine is in use even when the on-off switch is not on. Can I purchase a new valve?


... Hoover Vacuums

There is a rubber valve on the top of Dyson DC14 all floors. When the vacum is locked in its upright position or the hand wand is used there is a whistling sound coming out of the valve. When the vac is used as a floor vac, it does not make the sound. Is this something that I can fix? Is there an obstruction somewhere that would be causing this sound? thank you.


The Fixya user in this repair is giving out personal contact information rather then helping the customer out on the Fixya board. This defeats the whole purpose of Fixya if the "TheDysonTeam" just gives out his phone number and helps the customer o ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I have a tetra tec ex700 which is leaking from the sides of the canister.sice last year i have had 3 replacements sent and all with the same fault.can you advise if its the valves leaking into the motor head,as i have read on other forums.if so who do i contact for a replacement.thanks adrian durran


I thought i would share my problem as it is known now thatthis filter has leaking problems.Mine started leaking every time i cleaned it or just switiched it off i triedeverything i could to stop it but i could not.I found a write up about ... Vacuums

Soap solution valve on wand is not working.


No quick fix. Just make sure to run clean water through it before storing. Also, soak it in hot water, when it becomes plugged. I have dismantled my a few times, to clean it out, but have kept it clean to void future problems. ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

FoodSaver canister valve leaks air.


... FoodSaver Vacuum Canisters

Hoover steamvac supply valve leaks


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My vaporetto 2400 is leaking steam pressure from safety valve - what can I do?


... Polti Vaporetto 2400 Canister Steam Vacuum

I have a Dyson DC22 that seems to have lost a lot of suction. I can't peer right inside the wand, but it seems that hose may have disconnected from the telescoping handle allowing a huge leak. How can I take the handle apart to inspect/fix this?


... Dyson DC22 Motorhead Canister Vacuum Bagless Cyclonic Vacuum

Hoover spinscrub water tank valve leaks - Vacuums


... Vacuums

The unit (9400-3) is not spraying water from the lower deck but will spray from the hand held wand. Checked water levels and water/soap dispenser valves which seem to be working fine. Spray nozzles are not blocked. Where do you look now.


Same problem i have got, spent one day on the bloody thing but of no use, the only solution is to spray water from bucket and use the cleaner to **** it up. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Delonghi ECO310 BK espresso coffee maker. The unit is leaking from the steam solenoid valve on top of the boiler unit. The Teflon pipe that's retained by the clip is not a tight fit and is able to slide in/out slightly. There is a red gasket present, that sits over the tube, but I suspect that there may be someting else missing from the assembly because of the play in the pipe. Does anyone have a an exploded diagram of the assembly or can confirm that it is just the gasket that is likely to h


... Vacuums

How does the cp3 valve repair kit assemble to floor wand trigger?


... Thermax CP12 Steam Cleaner

Scunci steamcanister model 52038 Steam does not get from canister through hose to nozzle. No apparent leaks - hose does not get warm. appears may be valve problem from canister to hose. Only used bottled water - barely used this machine.


... Scunci Vacuums

The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi


... Bissell Vacuums

With a/c on max, and either excellarating or accending I seem to lose vacuum and vent goes to defrost , then when slowing down it goes back to normal settings. , check valve new, vacuum ball no leaks ????? blazer s10 1997 4wd


You need to repost this in the auto. repair section, this is for vacuum cleaner repairs. ... Vacuums

We have an American Home AH2O-550F water dispenser. The hot water valve is leaking water. Is the repair covered under warenty? Where do I bring for repair or how should I fix.


... Vacuums

My Domotec Simac PVT2050 Steam Cleaner began to leak to-day. In fact it almost emptied the tank. Can't help thinking it's a simple problem to do with the pressure relief valve but how can it be solved? Thank you. Wendy


... Domotec Vacuums

Dyson Dco7 animal not picking up from floor. Checked all connection valves and cleaned filter and brushes. Also check tube for cracks and nothing there. Wand suction is great just almost non on floor section. Please help!


I would check the "U" shape tube under wand that goes under body of machine. There is a button to release it. I would also check to make sure that your brushes are spinning properly. When you tip the vacuum back the brushes engage. Carefully place yo ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Gas valve on bottom leaks is there anywhere to get a new one.


\012Hi,\012That is not that hard to fix and you can easily buy the parts yourself online...Here is a tip that will help you with the online buying...How to Buy ... Vacuums

My water valve leaks on my bissell 1970 model. How do I fix it?


I had clean solution dripping onto the floor from the wheels of the \012unit. I had to disassemble it to find the problem which turned out to \012be a leaky seam on the edge of the black plastic valve assembly. This \012is the part that the solutio ... Bissell Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0172 seconds