Having problems with your Rainbow E series Canister Wet/Dry Vacuum ?

It sounds fine but it is sucking very little

\015 I took the bottom apart and also rinsed out the filter\015\012still the same problem \015

Answers :

If the suction at the port that the hose hooks into has low suction, then most likely you have a problem with the motor. Some of these Rainbow motors sound ok running, but are running at a slower speed, thus reducing the suction and replacing the motor is the solution.
Could also be the bearings. If you leave water in the pan after using the vac. the hot bearings attract moisture and then rust. Replacing bearings is a heck of alot cheaper ($3.00) than a new motor ($200+)
Repair Help & Product Troubleshooting for Rainbow E series Canister Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

It sounds fine but it is sucking very little

If the suction at the port that the hose hooks into has low suction, then most likely you have a problem with the motor. Some of these Rainbow motors sound ok running, but are running at a slower speed, thus reducing the suction and replacing the mo ... Rainbow E series Canister Wet/Dry Vacuum

My dyson is not sucking well. despite cleaning and making sure hoses are free of blockage. the little airvent at bottom is making a funny sounf onless icoverit with my hand. it then sounds fine but only for a few seconds. how can i fix this?

... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Suction stopped. Roller and belt working-in fine order. Checked hoses have not found any blockage. Blowing out air or sucking so little can't feel it with hand on hose end. Help!

Either a blockage or the main air filter is blocked , some it can be washed and others it must be replaced I would check the owner manual and look at the filter, foam ones can and usually have instructions where they install to wash them. ... Hoover Tempo Widepath Upright Vacuum - Blue

My dyson 07 doesnt **** up when im doing the carpet but the hose works fine? when im vacuming it sucks up very little and the hose part seems to be sucking up air when im doing the carpet? would this mean something is plug??? thanks randy

There is a block in the hose take lower hose of and clean ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My dyson dc17 sits low on my carpet in carpet mode and the brush does not roll. If I lift it off the carpet it rolls just fine. What can I do? It sucked in a shoe string. And a little after it starte

Probably the teeth on the belt av stripped and needs new belt ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dc14 animal works fine in Vaccuum mode but when I switch to the extendable tool the sound of the vaccuum changes to a higher pitch noise and I get very little suction through the hose. Any suggestion

Your hose has a restriction. To fix this, use a broom handle and insert it into the hose as far as it will go. If the hose can be removed, take it off completely and do this, if not be careful so as to not damage the sweeper with the handle. anoth ... Dyson DC14 Bagless Upright Cyclonic Vacuum

I was just using my Bosch 1450W bagged vacuum and all of a sudden, the motor just shut down. No warning, no problems. The light still turns on, but the motor is unresponsive. There is a clean bag and filter, and nothing caught in the front roller. The motor sounded fine - no shaking, or weird frequency variations. There were no weird smells, just a little bit of heat, but nothing beyond normal. I've had this thing for several years, and never had a bit of trouble with it. Any suggestions

Many vacuums have internal thermal switches that need to cool to allow the vac to operate. After 30 minutes, check all 3 air filters and try again.\012Gary ... Bosch BSG71310UC Bagged Canister Vacuum

Very little suction from vacuum is occurring after I pulled a string from the roller. Hot air is blowing out of unit. Was working fine until I pulled out a string...Suction is occurring from wand.The brushes now make a loud sound too when activated...do I have to take the unit apart to readjust them or something?

Yes re adjust ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson animal seems to have an electrical issue that I am unable to pinpoint. Neither the wand nor the floor vac have any suction AT ALL. In fact the vac makes absolutely no sound and you wouldn't even know that it had power to it unless the rollers are turned on, the rollers work just fine. I had this problem start about a month ago and then it just started working again after messing with it for a while, now it has happened again and I am getting a little agitated! Please Help!!!!!!!!!!!

There is a filter inside the canister, and by your description it sounds like it needs to be cleaned. if you remove the filter and blow it out using a air compressor or using a slightly ridged brush and tapping the filter out this should solve your ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

When using hose with attachments little or now suction; also is making a funny sound when machine is on and left idle; seems to be working fine when using on carpeting (picking up the cat hair and dust well ---- had to empty it twice in 20 minutes of vacuuming.

Try this link.http://www.youtube.com/watch?v=mwcLnjpn9Tg&feature=related ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Bissell Proheat carpet cleaner is not sucking up the water. How do I check the pump belt. The motor sounds fine. Thank you

Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Vacuums

Hi, My Kirby Ultimate G upright has very little suction. The engine sounds fine when turned on and the bag is not full at all. Suggestions?

In general, when the beater brushes on vacuum cleaners are not rotating, the debris on the carpet is not "bounced up" and into the suction area of the vacuum.\015\012With this in mind it might be a good idea to see if your beater brush or brushes are ... Kirby Ultimate G Bagged Upright Vacuum

The Kenmore grab n go was sucking fine and then stopped sucking.

Did you check to see if it is clogged? ... Kenmore 34723 Grab-N-Go Upright Vacuum

Sounds like I sucked something up

Recommend dyson service. it sounds like a broken drive / stripped gear etc. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

How many filters does the bagless dirt devil vision wide glide have cause the motor sounds fine but it doesnt **** hardly

Check and clean the hose. ... Vacuums

Bissell ProHeat Pet Makes a popping sound and stops sucking up water

... Vacuums

My Bissell 3760-1 has stopped sucking in the roller portion. The grab n go part are working fine. Checked the belt and it looks fine. Did I burn up the motor or a microchip?

Hey Lisa! Sorry you're having difficulty with your Lift-Off vacuum. Here's a link to troubleshooting steps to assist you with the suction.\015\012http: ... Vacuums

Soinds weird my dyson sounds like sucksion is leaking...the air leaking sound is really loud. it sucks some dirt but is not going into the canister, don't know where its going. it sounds like when i'm using the attachments when i'm just vaccuming...please help!!!

Dysons web site has an online area where you can walk through common problems like this:\015\012\015\012http://www.dyson.com.au/support/ ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

My Bissell 9200 is not sucking the water into the dirty water resevoir. 1. The gasket on the clear-view seems fine. 2. The suction power just doesn't seem powerful enough (feeling with my hand). 3. The brushes turn fine and belt is fine (not sure if that even matters for this issue). Any help appreciated. Thanks, - Matt

Disassemble all lines and check to see if all O rings are installed. If cracked missing or stretched out of shape no suction will be provided ... Bissell 9200 Upright Vacuum

My Dyson Animal has good suction and works fine for actually picking up dirt, but when I use the vacuum with the roller, I hear a grinding/rumbling noise. Its only when I use the vacuum with the brush rotating. It does not happen hen I shut the roller brush off. The belt is fine. I cannot figure out what is wrong as there are no clogs, debris, or foreign objects stuck in the brush or in the belt. The noise seems to be the only issue. The vacuum picks up fine. It just doesn't sound right a

Trace the path of the suction into the tank and see if there is anything loose or ingested.\015\012Also, remove the brush and clean as best you can. Perhaps there is something caught in it. Lubricate where it makes sense with some WD40. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Is not sucking. Water comes out fine, but when the trigger is released, the water does not get sucked back.

Without more input from you, it is difficult to know what the problem is. Do you hear the vac motor wining ? If so, then ther is a clog in the passage or there is damage to the vac motor/impellor blade. If no sound from vac motor, well of course it ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Bissell ProHeat 2X which releases the water/shampoo mix fine, and will suck up using the hose, but will not suck up using the main floor unit. Have checked it all out, and there do not appear to be any blockages. Help please

The vacuum on its back then look under the front where the water comes\015\012out, you will see few little round holes now the chances are these\015\012holes are blocked so get something long like a pin and poke these holes\015\012through you should ... Vacuums

It sounds fine in the upright position but when I drop the handle to vacuum there's a terrible whining sound from the front. Something's up with the roller. Can the belt go bad?

If its a loud clicking sound then it may be your clutch is bad. I called Dyson about mine and thats what they diagnosed it as. They wanted $125 to fix it. I went on ebay and bought a clutch and tool to help do the job and replaced it myself for less ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My full size bissell sprayed the room just fine, but now it won't **** up the water. Help! The container is closed and locked into place, and the bissell sounds fine.

Wish you had provided the model number, as they are different. The most common, if there is a flow indictor, is the filter there clean or clogged. The other possilbe, there is a ovule black seal that sits on top of the clear window noozle and the e ... Vacuums

My scooba seems to work fine but no longer makes the beeping noise. Several weeks ago the beep was sounding very strange almost like a battery was dying. Now it's not making any noise at all. Is this the beginning of more problems or can the machine function just fine without the beeps? If not then how can I fix it?

Your speaker went out. It could be totally isolated. You're not going to be able to determine what's wrong with your Scooba if something does happen, though, because without those beep codes, there's no way for the robot to communicate with you. ... iRobot 5900 Scooba Robotic Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0382 seconds